The hood latch is separating from the the bracket attached to the frame. This occurred while attempting to secure the hood closed while parked. The latch no longer aligns correctly with the hood. The vehicle has 193000 miles. It appears the metal bracket is of insufficient design strength. The safety latch will not be able to hold the hood closed if the there is vibration at high speeds. Other owners report failures where the latch breaks loose. Some owners attempt repairs with epoxy that do not last. All vehicles of this model should be inspected and the bracket replaced to avoid accidents.
Body, doors & structure
Acura RSX Body problems by year
12 complaints filed with NHTSA about the Acura RSX's body, doors & structure. Doors, hoods and latches, frame rust, sunroofs, leaks, trim and structural failures.
Body complaints by model year
Latest RSX body complaints
Acura only 5 years old when red paint, on exterior, started fading. Now body is compelety faded with patches of peeling paint on hood and roof. This car my husband purchased and is one of our family cars. My prius is a 2007 and the paint is not fading!
There is water and condensation build up inside the tail lights. I have replaced them a few times and still have issues. This can be a serious electrical hazard and I've read many forums of people having the same issue. I feel acura should take care of this problem. *Tr
Acura rsx 2002 to 2006 owners have experienced a flood in their rear tire well, causing tail lights, in some to rust out. This could cause a safety issue, particularly when driving at night and your tail lights have gone out. There is no recall on this issue, yet the blogs on acura rsx web site are huge! It's an expensive fix and not always covered by warranties. My car jack is rusted out and the spare tire won't come out due to excessive rust. *Tr
Water leaks in to the trunk (where the spare tire is kept).It puddles and causes rust and mold. It causes asthma exacerbation and respitory illness. Due to the water, the tail lights get fogged up and it makes it difficult to see the brake lights. It also fogs up the inside of the car and makes it difficult to see out of the car . This car has never been in a rear end collision. *Tr
My 2002 mdx has 75,000 miles and needs the engine mounts replaced. It was reported by lots of people that acura's design flaws on the motor mounts for 2001, 2002 mdx. Lots of discussions may be found athttp://www.Topix.Net/forum/autos/acura-mdx/t54qbspdkrmccnv0a it is a disaster for consumers to pay for the design defects! *Tr
Dt: problem was noticed about a week ago. The hood latch is bolted to a piece of metal, and there is a broken place in the metal. The metal piece broke away from the body on the right side, and then on the left side of the hood, the metal shows fatigue, and is almost broken, and is ready to break away soon. Metal fatigue is evident on both sides. Consumer contacted the dealer, and the car will be taken to dealer today. The case number with acura is 120050617300086. *Ak
*Open body seam at drivers a-pillar. I reported this problem twice as suspension noise which I though was the problem; dealer found no problem with the suspension. A few months went by and I realized the noise was coming from the driver side specially when turning wheels all the way to the left. Dealer kept the car from 2/12/04 until 2/28/04... Body seam was rewelded by an independent body shop. Now I get metal clicking noise when going over bumps. I don't feel safe driving this car after all and I get frustrate everytime I hear noises in the fron end.*Ak
Acura rsx: radiator and condenser have absolutely no protection (grill) in this model. The rsx is very susceptible to road debris damaging the condenser and radiator rendering the car inoperative, due to overheating and rapid loss of radiator fluid. This is especially true at highway speeds. Acura considers this an "act of god" and does not cover this damage. My sense is that this is very faulty manufacturing. The service managers related to me that there has been a "number" of repairs in recent past, and not just with this model. The nhtsa is requested to fully explore this problem with acura. *Nlm
Bumper not flushed nor aligned, unlike the left rear end. Bumper paint failing due to improper mounting of the rear bumper. As a result, bumper rubs against the rear signal lights causing the paint to fall/chip.*Ak
Rear bumper cover falling off. The rear of the car has a large plastic cover that extends the width of the car and covers the bumper from the bottom of the car to the bottom of the taillights. The top of this cover is held in place by a series of clips that are part of two metal strips bolted to the car. These clips engage set points along the bumper cover. The clips, particularly those directly below the taillights, do not properly hold the bumper cover. It disconnects from these clips, sags backward and down...
Read the full complaint
from the car and causes the top of the bumper cover to vibrate against the taillights, removing paint and plastic from this area. Though upon failure the bumper cover it still attached to the car along the bottom of the cover, it may be possible that if enough time passes and sag is created, the bumper could fall away from the car since it would not be attached along the top. This could create a safety issue for the cars following an rsx in such a failure. We purchased our rsx in july of 2001. Since then bumper issues have been on going, having repeatedly disengaged in the method described. It has been returned to an acura dealer (wier canyon acura) each time. In july we contacted acura client services. I wrote about this information to jason cox via fax, discussed it via phone and on july 12, 2002 sent a letter to mr. Koichi ameniwa, president american honda motors company. I also set up a web site with pictures of the car and its failures at http://rsx.Obriens.Net so honda america could see the problems. They seem disinterested at best.*Ak
The rsx is a brand new car that has only been on the market for about six weeks. The car has a very serious safety problem when driven by smaller adults. Basically, smaller adults can not see effectively out of the car. I will fax a letter that I have written to the president of american honda motors with this form. I sincerely believe that it is just a matter of time before some drivers of the car are involved in crashes because they simply can not see out.*Ak consumer states because the seat is so wide and tall,...
Read the full complaint
all she can see is the support beam between tht wo windows when looking left, the only way she can see out the right side of the car is to position the passenger seat in the full forward position and then tilt the seat back forward slightly. *Slc *tr
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data