Check a vehicle VIN check Latest recalls Latest complaints Common problems Rankings Compare vehicles Recall roundups All makes Guides Share your experience
Theme

Steering

American Coach American Eagle Steering problems by year

1 complaints filed with NHTSA about the American Coach American Eagle's steering. Loss of power steering, stiff or loose steering, wandering, column and rack problems.

Steering complaints by model year

YearSteering complaintsCrashesInjuriesRecalls
20201000

Latest American Eagle steering complaints

2020 American Coach American EagleSteeringElectrical systemBody, doors & structure

1. Some of the vehicle's wiring harnesses are located, unprotected, in the wheel wells above the vehicle's tires. Water, road debris and/or a tire blowout pose a significant risk in potentially damaging the wiring harnesses and disabling the vehicle creating a road hazard. 2. Electronic components that are responsible for the vehicle's operation and located within the service bays are subjected to water intrusion when the vehicle is driven in the rain. Water intrusion originates from somewhere within the vehicle...

Read the full complaint

and not as a breach of the service bay door seals. Water damage to the electronic components can potentially disable the vehicle and/or cause a fire creating a hazardous condition on the road. 3. Fuel lines from the mid-chassis fuel tank are routed through the frame members in such a manner that they are scuffing against the sharp edges of the frame members. The fuel lines are unprotected and could eventually wear through resulting in a fuel leak and potential fire. 4. The steering shaft binds against the floorboard. This defect was identified in a PDI report generated by the manufacture's inspector. The manufacturer chose to deliver the vehicle for sale without addressing this defect, nor disclosing the defect to the customer. 5. The vehicle's utilizes a truss framework for the chassis. The bottom structural member of the truss frame is comprised of 3 individual pieces butt welded together. The pieces are not aligned with each other and some welds are incomplete. The length of the entire bottom structural member is 20'7", which begs the question, why wasn't a single continuous frame member utilized. Furthermore, if welding complies with DOT standards, shouldn't the pieces have been cut at a 45 degree angle to maximize the welded contact area resulting in a stronger structural member. The vehicle is available for inspection. The manufacturer is aware of some of these defects

Filed Incident Steering · Electrical system · StructureNHTSA 11437708

Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data

Owners helping owners

Know before you drive.

Every experience you share - good or bad - shows on that vehicle's page and helps the next owner and buyer. Two minutes, anonymous.

Share your experience