BMW of North America, LLC (BMW) is recalling certain 2009-2011 K1300 (S, GT), 2010-2011 S1000 RR, 2005-2011 R1200 (GS, GS Adventure, R, RT, S, ST), 2006-2010 HP2 (Enduro, Megamoto, Sport), 2005-2008 K1200 (R, R Sport, S, GT), and 2012 K1600 (GT, GTL)...
2003-2008 · 6 model years
BMW K1200 GT Problems by year
Owners have filed 19 complaints about the BMW K1200 GT across 6 model years, and it has 6 recalls. The 2006 has the most complaints once its age is allowed for (10), while 2003 has far fewer than a typical year. The most reported problem area is the fuel system, followed by the brakes.
- Complaints
- 19
- Recalls
- 6
- Crashes
- 1
- Fires
- 0
- Injuries
- 0
- Deaths
- 0
K1200 GT complaints by model year
Highlighted: the year with the most complaints for its age. Older vehicles have had more time to collect complaints - the Safety Index grade allows for that.
Most common K1200 GT problems
BMW K1200 GT recalls 6
Bmw is recalling certain model year 2005-2011 motorcycles. The bearings could be subject to corrosion. This could lead to reduced movement of the link lever.
Bmw is recalling 428 my 2007 f800 s, f800 st, r1200 r, k1200 s, k1200 r, k1200 r sport, and k1200 gt motorcycles. It is possible for the coating to separate from the inside face of the steering damper housing. If this happened, the coating could partially...
Bmw is recalling 548 my 2008 k1200 s and gt motorcycles. The fasteners used to secure the front brake-disc may not be long enough to ensure a secure mounting. Over time, these fasteners could loosen. If that happened, the brake disc would no longer be...
Bmw is recalling 30 my 2008 k1200 s and k1200 gt motorcycles. A set screw may not have been installed at its specific location within the oil duct. Consequently, an adequate supply of oil may not circulate within the engine.
On certain motorcycles, frequent short trips particularly during cold temperatures, can cause water to accumulate in the oil tank, and when the engine is running, escaping water vapor can condense on the oil tank air bleed valve. In freezing temperatures...
Latest K1200 GT complaints
I have had the fuel level sensor replaced 4 times in the past three years and under 2,000 miles. The last one was replaced 4/2/18 with 37,200 miles and it failed after 41-miles. Bmw refuses to honor their 2-year parts warranty and replace the last one replaced 4/2/18. This is a safety issue as my fuel gauge does not work and running out of gas on the highway or when crossing an intersection could easily result in a fatal accident. Bmw extended their coverage on this known defective part for 12-years and my coverage ran out in august 2018
With reference to complaint number 10630065 filed on 2 september 2014, the following is added: when the defective abs pump on these bmw motorcycles is replaced by dealers, the new pumps supplied are no better than the ones it replaces and prone to the same failures. Please do something about this. *Tr
At a speed of 50 mph, I applied both front and rear power assisted brakes and the rear brake did not work. I was able to slow using the front brakes to avoid hitting a car in front of me. A master caution light came on as well as a rapidly blinking brake failure light. This is a known and very expensive failure on all bmw motorcycles costing up to $3000 to repair at a dealer. When repaired, these brake systems are still subject to fail without warning in the same manner as described above. This has and will...
Read the full complaint
continue to increase the risk of a crash and personal injury up to and including rider/passenger death. The company should be forced to recall the affected bikes (1997-present model) to inspect and repair these very expensive, failure prone brake systems without cost to the owners. Updated 10/22/14. *Jb updated 12/15/14. *Jb the consumer stated the failure of the abs module leaves the motorcycle with minimal to no braking ability. Updated 09/28/15.
Final drive crown bearing wore prematurely and caused the rear wheel to make noise and wobble slightly when ridden. Could have become a very serious situation if I had not been attentive to exactly how the bike was sounding and acting.
I found a 4 ft diameter puddle of gasoline on my garage floor. The air in the garage was also very thick with gasoline fumes. I noticed a steady dripping from the bmw motorcycle as the source of the gasoline, which had been dripping overnight. I feel fortunate to have caught this issue before the gas ignited and burned the motorcycle and possibly the garage. There was no way to stop the dripping and so I removed the fairing that covers the engine (not a simple job) and found one of the plastic fuel disconnects...
Read the full complaint
had broken and was leaking gas. Upon inspecting the fitting, I found that a plastic male quick disconnect fuel fitting had broken cleanly, if exposed to full system pressure, gasoline would have gushed onto the right side of the motor and my right leg had I attempted to start the cycle, in researching this issue, I find it is very commonplace. There is an action that dealers are supposed to take to "inspect" the fittings and replace if leaking. My cycle was in for service at an authorized dealer at 8211 miles. Less than 500 miles prior to the failure. The inspection solution did not solve the problem as the fitting failed suddenly and catastrophically. Until that point, they may not leak. Mine showed no evidence of leaking until it failed completely. Also, the way the fuel lines are secured places bending stress on the fittings that may encourage the breaking of the male fitting at the narrow diameter of the connector where the plastic is very thin. Given the nature of the failure, its frequency, and the possible consequences of pumping fuel at full capacity onto the rider and hot engine, I feel the inspection solution is inadequate and all of these plastic fittings should be replaced with the metal fitting that is now being used on late models. *Tr
I have experienced a recurring problem with high engine idle speed, unresponsive decelaeration when the throttle is closed and rough or "bucking" at constant cruising speeds of approximately 60 mph. I have learned from multiple independent forums that this is a common problem among owners of this model. Repair attempts, at owners expense, have produced inconsistent satisfactory results. Operation of the motorcycle is unsafe. Bmw should be forced to develop a solution and a subsequesnt recall issued to repair the problem at company expense. *Tr
Questions about the BMW K1200 GT
Which BMW K1200 GT years have the most problems?
Which BMW K1200 GT years have the fewest complaints?
What are the most common BMW K1200 GT problems?
Across every model year, owners report problems with the fuel system (6), brakes (5), transmission & drivetrain (4) most often.
How many recalls does the BMW K1200 GT have?
NHTSA lists 6 recalls across all BMW K1200 GT model years. Each year's page lists the recalls for that year; check your own vehicle by VIN at nhtsa.gov/recalls to see whether the repair has been done.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data