The vehicle experienced the same problem as the recall that was issued regarding the manifold, however the vehicle identification number was not included in the recall. *Ak the consumer stated the vehicle ran for five hours, he stopped to get gas and the vehicle failed to restart. *Jb
Engine & cooling
1998 Buick Lesabre Engine problems
Owners have filed 204 complaints about the 1998 Buick Lesabre's engine & cooling with NHTSA - 50% of all its complaints, most recently on June 15, 2023. They describe 1 crash, 29 fires and 2 injuries. Stalling, loss of power, oil consumption, overheating, head gaskets, timing chains and engine failure.
- Complaints
- 204
- Recalls
- 0
- Crashes
- 1
- Fires
- 29
- Injuries
- 2
- Deaths
- 0
Engine complaints
Consumer states that while driving, the vehicle would stall and it will be hard for the consumer to control the vehicle. Dealer notified. *Ph the vehicle started to loose speed pulled into gas station. The vehicle start again. Gm was aware of the problem. The consumers friend had experienced the same problem with the replacement of the manifold gaskets. The consumer requested to be reimbursed for the manifold and the starter. *Scc *nlm
Fax fm andrew hunt (nj) request assistance in getting reimbursed for $561.24 Worth of repairs to fix the upper intake manifold on his 1998 gm buick lesabre & recall all cars listed in gm tech. Service bulletin # 01-06-01-007a. *Mr the consumer stated the concern was the vehicle did not give warning of a problem as the coolant emitted from the tail pipe unnoticed. If there was too much coolant in the engine the vehicle would stop. The defective plastic intake manifold and the broken starter from the vehicle which clearly showed that the egr stove pipe allowed water to get into the engine. *Scc *jb
I had been losing coolant (2 quarts in 4~6 weeks) without seeing any spots on ground or coolant about engine / radiator. While driving, experienced relatively sudden loss of power, mil light came on, could not drive greater than 60 mph, very poor operation and acceleration. Dealer (superior buick, dearborn michigan) diagnosed problem as blown headgasket. I subsequently had engine remanufactured under dealer premise of head gasket, only to find that the upper intake manifold had failed and allowed coolant to pass into intake passages (reference gm service bulletin 010601007, and ~7a). I was never informed of these bulletins by the dealership, but they are 2 years old.*Ak
First we would like to report our dissatisfaction with stillwater motors in that they added bogus charges on to the invoice then later, after we questioned and insisted on seeing these new parts and the old parts, they adjusted the invoice by crediting us $400. The car was brought in due to the engine running rough, overheating and an increased usage of coolant. The dealership diagnosed the problem as being a defect in the upper manifold resulting in leakage of coolant onto the sparkplugs. In the end, the upper...
Read the full complaint
manifold, 4 gaskets, the oil filter, and thermostat had been replaced and had the fuel/emission system flushed. We were quite astounded to see so many issues with this very same problem we had and we are hoping that there is some relief given to all buick lesabre owners who have had to incur these repair costs. *Ph
Consumer parked vehicle after driving with no signs of mechanical trouble. The consumer returned to car and attempted to start the vehicle, but was unsuccessful. The vehicle was towed to the dealer who diagnosed that the plastic intake manifold cracked, which caused coolant to leak, which resulted in engine failure. *Ak *cb
Vehicle's "plenium" intake valve (part no. 506Cgm4) cracked causing coolant to leak into engine resulting in engine failure.
On 07/21/03 my 1998 buick lesabre (vin [[redacted]]), suddenly and without prior symptoms, began to run extremely rough and the engine stalled and was unable to be re-started. Fortunately, I was able to get off the road before the engine stalled. I am now saddled with a $2,000 repair bill all, apparently, as a result of the failure of the plastic gm plenum. The plenums failure caused other failures within the engine (including, but not limited to, the ignition control module and the starter). According to...
Read the full complaint
the mechanic that serviced the vehicle, this is not uncommon in gm vehicles that utilize the plastic plenum. I would seek restitution from general motors for what appears to be a historical and systemic failure of this plastic plenum resulting in extraordinary engine repairs.*Ak information redacted pursuant to the freedom of information act (foia), 5 u.S.C. 552(B)(6). *Tr
The manifold and gasket had to be replaced. I was told coolant was improperly mixing with my oil causing black smoke to be emitted from my exhaust, the car missing and eventually semi-locking. The locking cause the cone of my starter to crack in two when I attempted to re-start to the tune of a $1,500. Repairfor all. Dealer ackowledged they had this problem with other vehicles. The initial stater replaced was discovered defective and was again replaced on june 25, 2003. A complaint to buick customer service was fruitless and they were not sensitive at all to the problem encountered. *Ak
After owning this car for less than 3 months I noticed coolant tank empty, took it to dealer who charged me $342 for new water pump, still loosing coolant. Come to find out after a sludge was found in engine that intake plenum was cracked allowing coolant into cylinders, damaging the bearings and now am paying for a new motor. Gm denies problems exist. This car has only 50,000m miles. *Nlm
The key was inserted into the ignition when a loud explosion occurred along with smoke pouring out of the side of the engine area. The consumer was unable to put the fire out. *Mr *scc
Consumer having problems with the intake manifold. While driving the vehicle stalled and lost complete p[ower of the steering and brakes. Manufacture was not contacted at the time of this call.*Ak
The vehicles intake manifold failed when the vehicle was started and resulted in a fire under the hood. *Mr *ts *nlm
The consumer attempted to start car when the engine backfired, the manifold exploded and the engine caught fire. *Mr *ts *nlm
Vehicle fire/ vehicle destroyed. *Mr on several occasions, prior to fire, vehicle would surge then die out at both stops and when slowing down. Also engine had a whining noise. Dealer replaced generator assembly. Fuel filter also replaced. Cleaned throttle body. Brakes made squealing noise. Rear brakes cleaned and adjusted. There was a loud noise in the right rear after hot at stops. Exhaust system misaligned. The mirror compass and rear window were also inoperative. Vehicle was also involved in an accident prior to fire. *Tt
I purchased a '98 buick lesabre - from my brother-in_law, it only had 70,000 miles on it when the head gasket blew causing me to rebuild the top section of the motor--then after that was fixed and I drove the car for approximately 3 months more -- the bottom part of the engine blew--and I had to replace the complete engine not knowing what caused this problem. The car was always maintained by the dealership "boyle buick" in bel air, md. *Jb
The type of metal used in the engine was flimsy, and anti freeze ate through it, which resulted in a leak. *Jb *ts
There was a loud bang, then the engine would not start. The independent shop stated that the problem was the plastic intake manifold that seeped into the engine. Mr scc
The plastic intake manifold on my 1998 buick lesabre went bad last fall, which cost me over $1,000 to repair. There were about 70,000 miles on the engine at that time. Subsequently, I read an article in a newspaper that said the nhtsa was investigating gm cars with the 3.8 Liter engines for engine fires that resulted from these problems with the plastic intake manifold. I am wondering if a recall has been/could be issued, or if there is any way owners of cars with these engines can be reimbursed for the massive...
Read the full complaint
repair bills resulting from this engineering defect. Of course I am also very concerned for my safety since I have learned of the propensity for fires with these engines. Thank you.
Car refuses to crank sometimes, wait 45 min-1 hour, then it will crank. Also, slowing down to stop and car just dies, refuses to crank, again wait 45 minutes - 1 hour and it will crank. This is happening every 2 weeks-1 month. I was told it was not firing, but could it be something to do with fuel system? Dealer kept for 2 days and could find nothing wrong. Buick said they had not heard of this problem. *Jb
THE ENGINE CAUGHT ON FIRE.*JB
The engine caught on fire and burned some parts while vehicle was warming up.*Jb
The vehicle was hard to start, consumer heard a pop noise, and the engine started to run rough. Consumer stated maybe a blown head gasket.*Jb
THE ENGINE FAILED.*DT *JB
The battery was low, tried starting the motor a few times in the morning. After waiting all day, charged the battery back up to normal and started the car. A loud bang and flash was noted and then the engine caught fire. Put the fire out with an extinguisher. There was a back fire in the intake manifold, which is made of plastic and it exploded casusing the engine to catch fire. Visual damaged caused by the fire was to the fuel line, air line and wire harness. Vehicle is 4.5 Years old and only has 23,000 miles on it.*Jb
Buick Lesabre engine complaints by year
Lesabre engine problems, every yearSource: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data