The brake proportioner valves may break and separate from the master cylinder. This would allow brake fluid to leak and would result in a partial loss of the brake system.
Brakes
Buick Skylark Brake problems by year
95 complaints filed with NHTSA about the Buick Skylark's brakes. Spongy or hard pedal, ABS faults, brake failure, noises, parking brake and brake fluid leaks.
Brake complaints by model year
Brake recalls
Under certain conditions, vehicles may experience premature rear wheel skid during braking. Rear wheel skidding is most likely to occur on a wet or slick surface.
Rear brake hoses may have been manufactured incorrectly when the metal end fittings were installed. Some rear brake hoses may separate from the metal end fittings when subjected to the pulling force specified by federal motor vehicle safety standard 106...
Under certain conditions, the rear brakes could lock up without prior warning during high deceleration braking. The problem may be caused by defective proportioner valves in the braking system.
There is a potential for interference between the clutch control cable and brake pipe in the master cylinder. This can result in rubbing contact when the clutch pedal is operated. Also, the brake pipe clearance to the transmission case may be inadequate. If...
Latest Skylark brake complaints
The entire time I have owned this car, there have been issues with the abs - especially when the road is wet and driving down hill. When applying the brakes in these conditions, the car does not always stop even when pushing the brake pedal to the floor. You will here a clicking or grinding type of noise. It's not the pads or rotors because it happens when they have been replaced. In these conditions, I have to make sure I have plenty of room so I won't hit the car in front of me. I have on several occasions...
Read the full complaint
not been able to stop at a red light and gone through the intersection. It happens more frequently in icy conditions even when driving super slow. From reading other online complaints, I see I'm not the only one. I believe this is a manufacturer's safety defect.
The consumer's anti-lock brakes went out while driving on dry conditions. Consumer was driving 40 mph when he started to brake. The orange and red brake light came on, and it was still on. He took the car to the dealer 2-3 days after the incident. The dealer inspected the car, and told the consumer that his brakes were ok that they were normal brakes. However, the anti-lock brakes were no longer functioning. The consumer did not have the anti-lock brakes repaired since the dealer was charging him $575.00. *Ak *sb
BRAKES WEAR OUT PREMATURELY. *AK *MR
Ac heating - heater core went out- ac still not working computer control- buick reprogrammed computer chip- my complaint was erratic idling. It fixed problem. Paint peeling this year struts and springs on suspension are not lasting long tires- probably my fault for not rotating transmission- I replaced it with salvaged one at 170,000- heard a lot of complaints about this 4t60e transmission. Brakes- front ones last 1,000 miles. I replace all hardware. Steering-listen to this-the pivot pins on my tilt steering fell...
Read the full complaint
out and the steering wheel was on my lap.Car could still drive. I epoxied new pivot pins in and this solved the problem. All repairs done by me, except for the computer reprogramming-i thought it was a design problem and they should have fixed it for no charge. They did not. Heard friends tell me g.M cars eat up alternators and I have experienced this three times. Thank you!
Consumer noticed when depressing brakes vehicle would travel extended stopping distance. Technician who serviced vehicle replaced brakes due to corrosion. *Ak
While applying the brakes vehicle would throw consumer forward. Dealer notified.*Ak
Consumer wants to know if there is a recall on 1996 buick skylark rear braking system. *Mr *nm
THE ABS LIGHT ILLUMINATED ON THE DASHBOARD.*JB
When putting on brakes vehicle shakes and pedal goes to the floor. Please provide any further information.*Ak
Abs brake light illuminated and stayed on. Vehicle has to be shut down and restarted to disengage. Dealer has repaired problem once, but it seemed to have reoccurd. *Ak consumer stated that the problem still exist. *Yh
When applying brakes vehicle not stop brakes locks up and vehicle shimmied. Had repaired, but problem still exists. Please add vin. *Ak
While vehicle was in reverse, vehicle unexpectedly accelerated. When brakes were applied, pedal went to the floor, causing loss of vehicle control which resulted in a collision.*Ak consumer has been told that there is nothing worng with the brakes, however this incident has happened twice. *Slc
Brakes are defective when applied, and pedal goes all the way down to the floor. The dealership is aware of problem.*Ak consumer no longer owns vehicle because noone could fix the defect. *Slc
The front brakes have been replaced 3 times in the last 2 years, the rotors have also been replaced. Nlm
There was a thumping sound after the brakes were applied, a technician indicated the cause of the noise was due to the fact that when the brake pedal was depressed, the brake bridged the rear wheel cylinder gasket and subsequently the brake fluid built up on the brake lining/pad of the brake shoe, the brake fluid is manufactured with a silicone base, which apparently coats the brake lining, and can not be removed, therefore there is potential brake failure, consumer was informed that the problem is the silicone in the brake fluid formulation.*Jb
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data