Vehicle description: light duty pickup trucks and sport utility vehicles equipped with vacuum power, 4-wheel disc brakes. These vehicles fail to comply with the requirements of fmvss no. 105, "Hydraulic brake systems." These vehicles were built with a...
Brakes
Chevrolet C10 Brake problems by year
20 complaints filed with NHTSA about the Chevrolet C10's brakes. Spongy or hard pedal, ABS faults, brake failure, noises, parking brake and brake fluid leaks.
Brake complaints by model year
Brake recalls
Vehicle description: light duty pickup trucks and multi-purpose passenger vehicles. One or both front brake rotor/hubs were built with an out-of-specification gray iron that can fail during the life of the vehicle.
The brake pedal push rod retainer is missing, mispositioned or not properly seated.
Right and left hand brake hose may contact the wheel or tire in a full turn.
Improper size rear brake assemblies were installed.
The hydraulic brake fluid used in certain vehicles may fail to comply with the brake fluid boiling point requirements of federal motor vehicle safety standard no. 116, "Motor vehicle brake fluids". Braking efficiency may be reduced and vehicle stopping...
Latest C10 brake complaints
1981 Chevy c-10, front brake hoses retainer bracket, crimped too tightly on hose, causing hose to plug, uneven brake pressure, vehicle pulls to right or left. *Tr
Tl*the contact owns a 1985 chevrolet c10. The contact was informed by the emissions station that the rear brakes on his vehicle do not operate. He stated that the vehicle needs an axle brake assembly. The vehicle has not been repaired. The current mileage was 140,000 and the failure mileage was unknown. Updated 02/01/08. *Lj the consumer stated the brake system has not worked properly since the year he purchased the vehicle and will not be driven until manufacturer can remedy the defect. Updated 02/01/08 *tr
Engine revs up when engine is cold and idles down the road at 35 mph I first reported this to the dealer soon after I bought this truck and was told that it was the way a 5.0 L. Engine operated and nothing could be done about it after several near crashes because of the rpms of the engine as I have approached icy intersections because the wheels would be pushing me and the brakes would lock up I would have to shift into netural to keep from runnng into the intersection, after 5 years I have this is a safety hazard and the dealer may have been in error as tho the problem or otherwise. This has happened several times (the icy roads) am I the only one having this problem?*Ak
Brakes fade after stopping at light or on hill. Pedal goes to the floor, have to pump to get back up. Consumer complaint # 814663. *Ak
Anti-lock brakes are not working properly at all. Consumer took vehicle back to the dealership for brake problems. The mechanic told him that his vechicle is safe. His complaint is when he is in the parking lot driving 32 miles and applies brakes to the floor, they just don't stop vehicle. *Ak
When applying the brakes the front brakes stopped, but the back wheels kept spinning. Dealer couldn't fix the problem. *Ak
The anti-lock warning brake light stays on all the time. The light has been on for over two years. The dealership/repair shop waere not able to determine what the problem with the system was. Please provide any further details. *Ak
When the brakes are applied right front wheel locks up, resulting in loss of vehicle control. Owner says that the wheels lock up when a load is in the truck or a trailer is attached to it. The dealer and manufacturer have been notified. *Ak *ml
Consumer experiencing excessive wear of the front brake shoes and pads, replaced the pads four times in one year .Also, brake dust on the brake wheels, and brake hose has been replaced on two occasions. Please provide any further details. *Ak
Problem in 1988 with the abs brake indicator light coming on and the truck was hard to stop. Several repair calls at the dealer. At present the brake light stays on and it almost impossible to stop when driving at 40mph within a normal distance. The brakes is and has been a safety hazard on this truck. I need help.*Ak
With parking brake fully engaged the vehicle can be driven with no noticeable effect of it being on. Consumer now relies on wheel chocks after being told that there is a design flaw in the emergency braking system that cannot be corrected. *Ak
Brake line, which run along the side of frame/back brake ruptured and rusted out, causing brake fluid to leak on the rear brakes. Consumer has yet to have parts replaced. Please provide any further details. *Ak
Vacuum booster originally supplied on vehicle performs very poorly, excessive force needs to be applied in order to stop vehicle. Needs to replaced with the newly designed vacuum booster.
ANTI-LOCK BRAKES FAILED, CAUSING ACCIDENT.
Excessive force needed on pedal to stop vehicle. Occasionally after stopping, there is a popping sound and the vehicle moves forward as if bumped by another vehicle.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data