Chevrolet G30 Problems by year

Certain honeywell fram racing brand hp4 and hp8 oil filters that were manufactured from may 25, 2006, through september 14, 2007, and sold for use as replacement equipment for vehicles list above. The affected filters are marked with a date code a61451...

Certain replacement fuel filters, fram brand name p/n g3727, with date codes x52911 through x60801 sequentially or x600141 and a mexico country or origin marking on the fuel filter housing manufactured from october 18, 2005, through march 21, 2006, sold for...

Vehicle description: light duty pickup trucks and multi-purpose passenger vehicles. One or both front brake rotor/hubs were built with an out-of-specification gray iron that can fail during the life of the vehicle.

The steering linkage assemby contains a relay rod tapered-stud attachment nut that was not torqued to proper specifications.

Water intrusion into the kick panel areas in front of both the driver and passenger doors can cause a corrosion path between the battery feed and the electrical ground.

These tires have bead damage which occured during tire mounting.

One of the four rear axle u-bolts can break. This can potentially lead to the spring lifting from the axle under certain rebound, braking or cornering maneuvers.

Due to a thin case casting, an external transmission leak can occur.

Vehicle description: light duty pickup trucks, vans and motorhomes equipped with electronically fuel injected 6.5L diesel engine. This is not a safety recall in accordance with federal regulation part 573. However, it is deemed a safety improvement...

The lower control arm can crack at the flange on the end of the control arm near the ball joint pad.

The brake pedal assembly has a pushrod pin that is too small and it is installed in the wrong position, causing an increased brake pedal ratio and a decreased master cylinder stroke.

Vehicles were incorrectly equipped with standard rear windows instead of the necessary riveted installation seal assemblies.