Chevrolet Monza Problems by year

Certain honeywell fram racing brand hp4 and hp8 oil filters that were manufactured from may 25, 2006, through september 14, 2007, and sold for use as replacement equipment for vehicles list above. The affected filters are marked with a date code a61451...

On certain vehicles, the seat belt retractors in the rear seating positions contain first lock positions which will not lock when used by smaller passengers. This fails to comply with the requirements of federal motor vehicle safety standard no. 208...

The carburetor fuel feed hose may not have been properly positioned during assembly. As a result the hose could come in contact with or be too close to the engine emission exhaust system gas recirculation valve. This can cause the hose to rupture.

The engine oil pressure switch may cause a random internal electrical short which could result in the engine starting by itself when the ignition switch is turned to the "on" position.

Operation of the vehicle in a manner which produces hard bottoming out of the front suspension may cause deformation of the left engine mount support structure and allow the engine mount bracket to contact the steering pitman arm or steering linkage.

Under certain driving conditions, including extended severe braking, the wheel bearing area may encounter temperatures that can cause the grease to migrate out of the bearing area. This will reduce the amount of lubrication available to the bearings and...

The intermediate shaft coupling on the involved vehicles may have been machined oversized in the serration area where it attaches to the steering column. This would prevent the coupling from properly tightening on the shaft when the clamp and pinch bolt were...