Chevrolet P30 Problems by year

Certain honeywell fram racing brand hp4 and hp8 oil filters that were manufactured from may 25, 2006, through september 14, 2007, and sold for use as replacement equipment for vehicles list above. The affected filters are marked with a date code a61451...

Certain replacement fuel filters, fram brand name p/n g3727, with date codes x52911 through x60801 sequentially or x600141 and a mexico country or origin marking on the fuel filter housing manufactured from october 18, 2005, through march 21, 2006, sold for...

Vehicle description: light duty pickup trucks, vans and motorhomes equipped with electronically fuel injected 6.5L diesel engine. This is not a safety recall in accordance with federal regulation part 573. However, it is deemed a safety improvement...

Seat pedestals for driver and passengers may have a larger than specified slot in the center channel.

Left hand lower control arm can crack and could eventually cause the lower ball joint to separate from the control arm.

Three bolts which attach the sill that supports the base of the seat were omitted; therefore vehicles do not comply with fmvss 210 and fmvss 207...

During a combined cornering and braking maneuver, the tie rod end could contact the tire wall. Consequence of defect: this contact can...

The wheel may develop cracks between the disc and rim. Consequence of defect: if this occurs and is not noticed, the crack could increase around the rim, resulting in...

The fan blade, when subjected to high stress levels, can fatigue and break apart at the hub while the engine is running. Consequence of defect: if breakage...

Due to a manufacturing problem with the fuel tank filler pipe, the fuel cap may improperly seal the end of the filler pipe. This fails to conform to the requirements of federal motor vehicle safety standard 301, "fuel system integrity." In the event of a...

In a vehicle impact from the rear, the three piece hoses could separate and result in fuel leakage in excess of the amount permitted by federal motor vehicle safety standard no. 301, "Fuel system integrity".

Vehicles may be subject to abrasive contact between the rear brake hose/pipe assembly and the axle housing with normal brake usage and rear pad wear. Should this condition occur, it could lead to a brake hose/pipe failure, resulting in loss of brake fluid and...