Chevrolet T10 Problems by year

Vehicle description: passenger vehicles, light duty trucks, sport utility vehicles, and mini vans equipped with trw seat belt buckle assemblies. The buckle base of these seat belt assemblies were not properly heat treated and therefore do not pass the load...

Significant wear can develop on the low and reverse clutch preventing the park pawl from engaging. This can prevent a "no park" condition to occur while the engine is running, causing unintentional movement of the vehicle without operator action. (The "no...

The outboard rear safety belt assembly will not release the webbing from the retracted position. This does not meet the requirements of fmvss 209, "seat belt assemblies."

Vehicles have been shipped with the fuel tank sender seal out of position.

Nuts used to attach lower control arms, rear spring and shackle, and rear shock absorbers do not meet specifications and could "strip".

Use of improper primer on metal surfaces of windshield and side window openings could cause low adhesion to the metal surface and would not provide retention required by fmvss 212.

Tire and wheel information on certification label may be incorrect. Consequence of defect: trucks fail to...

Some vehicles have bucket seat back locks that do not conform to federal motor vehicle safety standard 207, anchorage of seats. In event of a crash, the seat back lock may not function.

The right front crossover pipe, which carries brake hydraulic fluid, may break and leak fluid. This occurs when the right front fender skirt contacts the pipe and vibration causes the pipe to wear through.