Check a vehicle VIN check Latest recalls Latest complaints Common problems Rankings Compare vehicles Recall roundups All makes Guides Share your experience
Theme

Suspension

Chrysler Crossfire Suspension problems by year

8 complaints filed with NHTSA about the Chrysler Crossfire's suspension. Broken springs, struts, control arms, ball joints, noises and alignment that won't hold.

Suspension complaints by model year

YearSuspension complaintsCrashesInjuriesRecalls
20071000
20052000
20045000

Latest Crossfire suspension complaints

2007 Chrysler CrossfireSuspension

Hello, I have installed Ground Control adjustable camber arms on my vehicle to permit camber adjustment to within factory recommendations. These same model camber arms are failing on a number of vehicles which are identical to mine (Chrysler Crossfire). My vehicle has not yet failed. A photo is attached. They pose an extreme safety hazard, as they can cause complete loss of vehicle control. There have been no injuries yet, but it is only a matter of time. Thank you for considering my report.

Filed Incident SuspensionNHTSA 11421766
2005 Chrysler CrossfireSuspensionBody, doors & structure

My 2005 chrysler crossfire was on the ca-10 interstate and the rear window detached from the vinyl during drive. Was not able to move it while driving causing hazard to drivers around my vehicle and limited visibility.

Filed Incident Suspension · StructureNHTSA 10910466
2004 Chrysler CrossfireSuspension

Tl* the contact owns a 2004 chrysler crossfire. The contact stated that the front end of the vehicle was not aligned. The failure recurred multiple times. The dealer was unable to locate the failure. The vehicle has not been repaired. The manufacturer was not notified of the failure. The approximate failure mileage was 120,000.

Filed Incident SuspensionNHTSA 10650726
2005 Chrysler CrossfireSuspensionWheels & tires

Right rear rim broke in half. This break was on the inside of the rim about 1" from the spokes. The break was around the entire rim. Not across the rim; around the entire rim. I can provide pictures and still have the rim. *Tr

Filed Incident Suspension · WheelsNHTSA 10535648
2004 Chrysler CrossfireSuspensionBody, doors & structure

The passenger side rear stabilizer body mount bracket was found to be 90% separated from the body. The mount bracket has 4 weld points on the body frame. The welds are electrical welds. One break was along the weld at the junction point of the bracket to the body. The other 2 separations were along the midpoint of the bracket support legs. The rearward support legs are approximately 1 inch wide. Both were broken. The forward legs are approximately 1 half inch wide and one was broken on the outboard passenger...

Read the full complaint

side. The driver side bracket shows no sign of problems. The thickness of the steel in the bracket is approximately 3/32 inches. This vehicle was involved in a low speed front end collision approximately 3 years prior to this problem forming. Images are available. *Tr

Filed Incident Suspension · StructureNHTSA 10486547
2004 Chrysler CrossfireSuspensionBody, doors & structure

Design of vehicle did not allow for camber adjustment to front tires unless a weld is cut and a new piece is installed. Therefore, over time the camber of the tires can became such that the front tires wear on the inside edge that cannot be seen by the owner of the vehicle during a normal walk around inspection. This places the owner of the vehicle in a position that a tire which appears to be in good condition when inspected, may blow out without notice when at highway speeds. It would seem that a...

Read the full complaint

manufacturer's design that requires a weld to be cut and a new part installed at a later date to allow for a simple tire alignment adjustment and may lead to a potential tire failure until discovered by the owner, is not a vehicle design which incorporates a high degree of safety engineering. *Tr

Filed Incident Suspension · StructureNHTSA 10238545
2004 Chrysler CrossfireSuspension

Dt*: the contact stated while driving the vehicle going 55 to 60 mph it started vibrating. The vehicle was taken back to the dealership four times within a six week period. The dealership inspected the vehicle the first time and could not duplicate the problem. After driving the vehicle for a short amount of time it was taken back a second time having the same problems. The dealership balanced the wheels and stated the vibration should go away. This did not fix the problem; the vehicle still vibrated at...

Read the full complaint

various speeds. It was taken back to the dealership once again, but the problem could not be duplicated. After driving a week or so the vehicle was taken back this time all four tires were replaced. This still has not fixed the problem. The dealership states there is nothing mechanically wrong with the vehicle. The manufacturer has been alerted.

Filed Incident SuspensionNHTSA 10152888
2004 Chrysler CrossfireSuspension

I get my x-fire maintained at maplewood dodge -chrysler dealership service center in maplewood nj. I first took in for new brakes in nov. 2005 And also asked them to check the rear right wheel because it was making a metal rattle noise when I go over bumps. They told me that they had to order a right front strut. They called me and said that they had to replace the front strut and released it to me. Jan 3, 2006, I returned to the service center with the same noise problem. They kept my car for 7 days. I was...

Read the full complaint

told that they had to order a rear strut for my car. I asked why did they replace the front strut. I was told that they did not replace it, they just ordered it. (First lie) three 3 days in on jan 6, 2006 I asked about my car and service rep chuck said "what's up bro. I asked about the status of my vehicle. He said "if it was ready I'd called you". Yes I'm a black man, but I am not his bro. I am a customer. I made a complaint to the service manager al. Nothing was done. I came back on tue. Jan. 10, 2005. While waiting to talk to al the manager, he was talking to the mechanic who assigned to work on my car and chuck. Unknowing of my presence, al say to them that he needed them to look into what is going on with the white crossfire, the customer has been in a rental for close too 5 days. The mechanic say "so, that is not my problem". That is a problem! I ask chuck, exactly what is wrong with my car. He look at me and said "i don't know" I ask, did any one look at my car, because everytime I call here you tell me that they are working on it. He then called the mechanic and I ask him what part is being ordered for my car if any. I looked at chuck then me and said "i don't know". No one there could tell me why they had my car for 5 days or what part is being ordered or if any needed to be ordered. Then the person assigned to work on my car said "i'm not even qualified to work on that car. Now it is wed. Jan. 11, 2006 And I still don't have my car. *Jb

Filed Incident SuspensionNHTSA 10147422

Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data

Owners helping owners

Know before you drive.

Every experience you share - good or bad - shows on that vehicle's page and helps the next owner and buyer. Two minutes, anonymous.

Share your experience