Check a vehicle VIN check Latest recalls Latest complaints Common problems Rankings Compare vehicles Recall roundups All makes Guides Share your experience
Theme

Brakes

Ford Aspire Brake problems by year

22 complaints filed with NHTSA about the Ford Aspire's brakes. Spongy or hard pedal, ABS faults, brake failure, noises, parking brake and brake fluid leaks.

Brake complaints by model year

YearBrake complaintsCrashesInjuriesRecalls
19977200
199610100
19953100
19942000

Latest Aspire brake complaints

1996 Ford AspireSteeringBrakesTransmission & drivetrainCrash

Dt*: the contact stated without warning the brakes and steering failed, while driving 5-10 mph. The vehicle ran into a brick wall and there was damage to the front end of the vehicle. There was a police report taken at the scene and the vehicle was towed to the contact's home. The vehicle has not been inspected by a mechanic. Also, at 14,000 miles while driving 15 mph the vehicle stopped. The engine was still on, but the vehicle would not move. The dealership determined the transmission needed to be...

Read the full complaint

replaced. This happened again at 40,000 miles and the transmission was replaced by the dealership. At 55,000 miles the vehicle was taken to an independent repair shop for the same problem and the transmission was rebuilt. The transmission was rebuilt a final time at 65,000 miles. There have been no further problems with the transmission.

Filed Incident Steering · Service brakes, hydraulic · Power trainNHTSA 10150215
1997 Ford AspireBrakes

Problems with rubber hose, rust and corrosion to the metallic brake lines.*Mr *cb

Filed Incident Service brakes, hydraulicNHTSA 10032455
1996 Ford AspireBrakes

Since the purchase of this vehicle (1996 ford sable) I have had problems..The car shuts off at speeds of 10mph, while sitting in traffic, or attempting to accelerate. I have reported this probem to nhtsa, the dealer, ford motor co. And the local newspaper, the dealer says he can not fix it until it duplicates while he has it...Again he says "wait until something happens" , I asked if he were waiting for someone to be injured or killed he said unfortunately that's what will have to happen in order to locate the problem. I find this to be a ludicruous answer, ford motor company should take responsiblity for manufacturer defects. Ford motor company refuses to correct these defects.*Ak

Filed Incident Service brakes, hydraulicNHTSA 743052
1996 Ford AspireBrakes

Since vehicle was purchased in 1999, I have reported to ford motor and budget car sales the problem with the brake system, brakes jam, vehicle goes backward and jerks forward while sitting in traffic. Ford motor co. Refuses to take responsibilty for the manufacturing defect and budget auto sales says they cannot find the problem and I need to wait until "something happens" this vehicle is a death trap and I implore someone to assist me in getting these defects corrected before someone is killed.*Ak

Filed Incident Service brakes, hydraulicNHTSA 743049
1997 Ford AspireBrakes

NO SUMMARY.

Filed Incident Service brakes, hydraulicNHTSA 9001402
1997 Ford AspireBrakesEngine & coolingElectrical systemLightsWheels & tiresCrash

Have had recent oil leak and as of 08/24/00 white smoke blowing out of exhaust engine light continues on.. I have had airconditioning leaking into passanger side so it cant be used, I have always maintained my car at every 3 months.. The brake problem was noticed first month I owed car and only when it rained which caused a wreck on 09/99 due to no brakes at that time. Have had front breaks replaced. Mechanic said he couldnt see any wear on them but need replaced.. My turn signals fuses replaced about 4 or 5 times , 3 wks ago had them replaced and now have no turn signals. ..( Dot number: tire size: 16570/13 )

Filed Incident Service brakes, air · Engine and engine cooling · Electrical system · Exterior lighting · TiresNHTSA 728967
1994 Ford AspireBrakes

I am sending this with great concern over a manufacturing defect that I feel is very dangerous.The spot welds on the harness that holds the brake and clutch pedals broke and caused the brake pedal to hang up on the steering column. I was unable to stop safely and nearly put the car into a ditch. I was appalled when I realized the cause of the failure. The whole harness has stress fractures and from what I can see has broken on at least two of the spot welds. How could a part that would obviously have so much...

Read the full complaint

wear and tear as the brake clutch pedal assembly only be spot welded together? Let alone be manufactured out of such thin metal? It was poorly manufactured and I believe these vehicles should be inspected before someone gets seriously hurt. Had this not been a five speed I would have had no way to slow the vehicle down and would have surely been in an accident. I am afraid of the car and I hope ford will accept the responsibility to fix it because this in no way is user error. It is definitely a manufacturer's defect/engineering design flaw that no consumer shoud be responsible for. It was a poor choice of cost cutting to only spot weld this part together . It plainly is a dangerous safely issue for anyone operating one of these cars. I hope no one gets seriously hurt because any more of these welds break and cause someone to be unable to stop safely. As of right now both the clutch cable and pedal do not function correctly and the brake pedal repeatedly hits the steering column preventing it from being able to depress far enough to fully stop the car. I pray I am the only one who has run into this problem, but I feel this needs prompt attention and should be investigated before someone is hurt or killed by one of these cars due to this mechanical error. This assembly never should have been "glued" together with an obviously weak spot weld.

Filed Incident Service brakes, hydraulicNHTSA 724499
1997 Ford AspireBrakesAirbags

When driving at any speed and applying brakes vehicle shakes, and there is a grinding noise coming from the vehicle. Also,air bag light/ engine check light are on. *Ak

Filed Incident Service brakes, hydraulic · Air bags · Unknown or otherNHTSA 849193
1996 Ford AspireBrakes

Front brake rotors have failed 4 times. Ford turned the rotors, and stated aspires have bad brakes. This is not acceptable as I have owned 4 of these cars.

Filed Incident Service brakes, hydraulicNHTSA 705433
1997 Ford AspireBrakes

FRONT BRAKES EXPERIENCING A "GROANING" NOISE. *YC

Filed Service brakes, hydraulicNHTSA 608077
1996 Ford AspireBrakes

Rotors and pads experienced excessive wear, rotors were warped.

Filed Incident Service brakes, hydraulicNHTSA 542635
1996 Ford AspireBrakes

At 800 miles, the front rotors warped. They had to be remachined. At 13,000 miles the front rotors warped again. The dealer and ford motor company refused to fix the problem. At 55 miles an hour the steering wheel shakes. When you make a turn the steering wheel shakes more. At highway driving, when you make a turn or change lanes, the steering is hard to control.

Filed Incident Service brakes, hydraulicNHTSA 700461
1996 Ford AspireBrakes

Was having problem with the brakes. Took vehicle to dealer & told that rotors & pads were worn excessively. They needed replacing. Passenger front was worse. The other 3 were warped. *Ak

Filed Incident Service brakes, hydraulicNHTSA 828989
1997 Ford AspireBrakesAirbagsCrash

While driving the driver attempted to apply the brakes and there were no brakes. Vehicle hit another car. Before the driver hit other vehicle, the air bag deployed, causing the driver to hit other vehicle. *Ak

Filed Incident Service brakes, hydraulic · Air bagsNHTSA 825450

Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data

Owners helping owners

Know before you drive.

Every experience you share - good or bad - shows on that vehicle's page and helps the next owner and buyer. Two minutes, anonymous.

Share your experience