The involved vehicles were produced with hydraulic brake booster supply hoses that are located too close to the engine exhaust manifold and may chafe and develop heat damage during vehicle operation. Chafing and heat induced deterioration of a hose due to...
Brakes
Ford B700 Brake problems by year
3 complaints filed with NHTSA about the Ford B700's brakes. Spongy or hard pedal, ABS faults, brake failure, noises, parking brake and brake fluid leaks.
Brake complaints by model year
Brake recalls
The air brake lines may be routed too close to the exhaust muffler. Because the air brake lines are made of nylon material, heat from the exhaust muffler can weaken the brake line tubes, possibly causing them to rupture. Tube rupture could result in loss of...
Latest B700 brake complaints
The brake line to the right front wheel and the line to the rear brakes went through a common bracket along the frame. Inside this bracket, completely undetectable, the 2 lines had rusted... Both failed at the same time. I saw the fluid leak, but knew I had lost both braking systems, front and rear, so I continued looking for another leak. To my surprise, both lines made contact inside this bolt-on strap connector and had rusted simultaneously. All warning lights and buzzers worked properly. When the brake pedal...
Read the full complaint
hit the floor, the power steering system did not have enough reserve pressure to allow me to continue turning. Heading downhill and making a hard left turn with very little clearance from my house, I nearly hit my house before coming to a stop. Many years of double-bottom 160k lb. Gasoline tanker driving and a sound mechanical knowledge hastened my reaction time and I flipped the emergency brake lever and releaved the pressure from the rear spring brakes, which brought me to a stop. With both front and rear brakes gone at the same time, and with all buzzers and lights sending me warnings, still the emergency braking system failed to apply the rear brakes without manually moving the parking brake lever. This is the most serious problem I have ever incurred! A bus load of children would be in desparate danger if this happened to one of the many simular buses still transporting children today. Visual inspection of the lines would not show this problem. The bracket would need to be physically removed in order to inspect for rust. That does not happen! I am replacing all lines on my bus... I no longer trust any connector underneath this otherwise very solid vehicle.
School bus fires due to rupture of a brake hose which is located near the exhaust manifold. See odi#533336 and 533337
Three school bus fires due to rupture of a brake hose which is located near the exhaust manifold. See odi#533337 and 533338
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data