Ford Bronco 2DR Engine problems by year

The contact's wife owns a 2025 Ford Bronco. Upon taking delivery of the vehicle, the door stops on both rear doors began detaching and the plastic fender components fell off while the vehicle was parked. Additionally, the rear passenger's side window intermittently failed to roll up. The contact then received notifications of NHTSA Campaign Numbers: 26V468000 (Engine, Electrical System) and 26V403000 (Structure). The vehicle was taken to the dealer for a wiring harness recall repair; however, the dealer stated that...

The contact owns a 2025 Ford Bronco. The contact received notification of NHTSA Campaign Number: 26V468000 (Engine, Electrical System); however, the part to do the recall repair was not available. The dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was notified of the issue. The contact had not experienced a failure.

Description On your vehicle, it may be possible that one or more engine camshaft roller finger followers were not properly installed at the time of engine assembly. Safety Risk An improperly installed engine camshaft roller finger follower may result in engine failure, resulting in a no-start condition or a loss of motive power. A loss of motive power increases the risk of a crash. Your vehicle may also experience engine ticking or tapping noise, and or a low-volume oil leak due to this condition. Remedy A...

Car would shut off shortly after using remote start on key fob then display a warning on digital instrument cluster for two days now. It would also show my speed going back and forth from 0 to 1mph while parked.

On [[redacted]] at [[redacted]] PM I was driving westbound on [[redacted]] at [[redacted]] while traveling through the intersection, my vehicle started shaking, lost acceleration, and nearly caused me to have a collision. My vehicles check engine light began flashing, and I was able to safely exit the highway. On May 20, 2026, Crouse Ford diagnosed a "cylinder #6", however attributed the event as "an anomaly", and no corrective action was taken despite the seriousness of the safety concerns. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

The contact owned a 2025 Ford Bronco. The contact stated while driving 30 MPH, another driver pulled closer to the vehicle and honked to get the contact's attention. The contact stated that upon rolling down the window, the contact noticed flames coming from the front driver's side wheel well. There was no warning light illuminated. The contact was able to pull over to the side and exited the vehicle. The contact stated that the vehicle completely burned from the front end to the front seats. The contact stated...

on Jan 15, 2025. A cold start for the Bronco, putting in reverse, the vehicle lurched back and to the hard right, uncommanded acceleration at a high rate of speed, steering locked up, brakes locked up, tires spinning, engine revving causing the bronco to smash into the exterior of my home garage area. Then, shifting to drive, the vehicle again lurched, uncommanded acceleration hard to the left now, steering locked up, brakes locked up, tires spinning engine revving traveling 20-30 feet crashing into the electrical box coming to rest on top of it. Numerous faults showing multiple systems malfunctioning causing this incident.

While slowly backing into our home garage, the vehicle accelerated brakes were not working and smashed into the side of the house, put the car in drive to move it. It accelerated forward over correcting and drove into our power box and came to a halt. No brakes were working and the wheels/steering locked up.

While driving, after a missed downshift that causes engine bogging, the vehicle experiences a loss of engine power. The engine remains running but will not produce usable torque and will not rev above approximately 800 RPM, despite clutch disengagement and selecting the correct gear. Holding the clutch fully depressed does not immediately restore power; instead, after approximately 4 seconds, the engine stalls or cycles/resets, after which normal operation resumes. The condition persists until the vehicle nearly stops, the engine stalls, or the ignition is cycled. This has occurred in traffic and adverse weather conditions and is repeatable."

I was driving the vehicle on high mountain pass roads in Colorado. Anytime I would approach approximately 11,400 feet of elevation. The vehicle would instantly lose all power with no warning lights of any kind. All gauges were in the normal operating range. Vehicle would barely move 2 mph. Created a very unsafe condition on narrow steep dirt roads in the mountains. As soon as I turned around and descended approximately 100 feet in elevation the power came back instantly and vehicle operated normally. This happened...

2025 Bronco Sport Safety Recalls* Replace instrument panel cluster Recall incomplete Block heater element replacement Recall incomplete Cylinder head replacement Recall incomplete Cylinder head inspectionreplacement Recall incomplete DO NOT DRIVE! RECOMMENDED TO REPORT NATIONAL ALERT FOR OWNERS OF THIS VEHICLE TYPE. INVESTOR REPORTING FOR BROADCAST RECALL ALERT!