Common problems
Brake problems: warning signs and what to do
Any change in how your brakes feel or sound is worth checking, and some changes mean you should stop driving now. A pedal that sinks toward the floor, a red brake warning light or a car that pulls hard to one side are urgent. Squeals and grinding usually mean worn pads, which are cheaper to fix the sooner you deal with them.
Signs you should stop driving
Warning signs and what they can mean
Soft, spongy or sinking pedal
A pedal that feels soft, goes down further than usual or slowly sinks while you hold it can mean air or moisture in the brake fluid, a fluid leak or a failing master cylinder. This is one of the most serious brake symptoms because it can get worse quickly.
Hard pedal
A pedal that suddenly needs much more force can mean a problem with the brake assist. Most cars use engine vacuum to help you press the pedal. Some engines, including many diesels and some turbocharged gas engines, use a separate vacuum pump, and others use an electric brake booster. If the assist fails, the brakes still work, but you have to press much harder and stopping distances get longer.
Squealing
Many brake pads have a small metal tab that squeals when the pads are getting thin. It is a reminder to book a brake service soon. Some squealing in damp weather or after the car sits can be normal.
Grinding
Grinding usually means the pads are worn through and metal is rubbing on the rotor. This reduces braking and damages the rotors quickly. Get it checked right away.
Pulling to one side
If the car pulls left or right when you brake, one side may be braking harder than the other, often due to a sticking caliper, a collapsed hose or contaminated pads. It can also be a tire or alignment issue.
Vibration or pulsing
A pulsing pedal or a shaking steering wheel during normal braking often means uneven rotors. Note that the pedal also pulses when the anti-lock braking system (ABS) is working hard on a slippery road, which is normal.
Leaks
Brake fluid is usually clear to light yellow and turns brown with age. It has a slippery feel. A wet patch near a wheel or under the engine bay should be checked straight away.
Brake warning lights
| Light | What it can mean | What to do |
|---|---|---|
| Red BRAKE or (!) light | Parking brake on, low brake fluid or a hydraulic fault | Check the parking brake is fully off. If the light stays on, stop safely and get help. |
| Amber ABS light | A fault in the anti-lock system, often a wheel speed sensor or module | Normal braking usually still works, but without anti-lock. Get it checked soon and drive carefully. |
| Red and ABS lights together | A more serious brake system fault | Stop driving and get it checked. |
| Brake pad wear light | Pads are nearing their limit (on cars with wear sensors) | Book a brake service soon. |
Symbols differ between manufacturers. Your owner's manual explains the lights in your vehicle.
Brake fluid
Brake fluid absorbs moisture from the air over time. Moisture lowers its boiling point, which can cause a soft pedal after hard braking, such as on long downhill grades, and can corrode parts inside the system.
- Check the brake fluid reservoir level when you check your oil. It should be between the marks.
- A level that keeps dropping means a leak or very worn pads. Do not just keep topping it up.
- Change the fluid as often as your owner's manual says. Many manufacturers recommend every few years.
- Use only the fluid type printed on the reservoir cap or in the manual.
What to do
- Decide whether it is safe to drive. Use the danger list above. If in doubt, get the car towed.
- Write down the symptoms. When it happens, at what speed, hot or cold, and any lights or sounds.
- Check for recalls. Use our VIN check. Brake components, ABS modules and vacuum pumps have all been the subject of recalls on various models.
- Look at what other owners report. See brake problems across all vehicles, or your own model's brake page, such as 2018 Toyota Camry brakes.
- Get an inspection and a written quote. A good shop will measure pad and rotor thickness and show you the worn parts.
Typical repair costs
These are typical rough ranges that vary widely by vehicle and location. Always get a written quote.
- Brake pads on one axle: often about $150 to $400.
- Pads and rotors on one axle: often about $300 to $800.
- Caliper replacement: often a few hundred dollars per wheel.
- Brake fluid flush: often about $100 to $200.
- ABS module or master cylinder: can run from several hundred to well over $1,000.
If it is a defect, report it
Normal wear is not a defect. But brakes that lose pressure, an ABS module that fails or a vacuum pump that stops working on a low-mileage car may be. If you had a brake failure or near miss, file a complaint with NHTSA. Brake complaints that show a pattern can lead to investigations and recalls.
Then share your experience on this site so other owners of your model know what to watch for.
Questions and answers
Is it safe to drive with the ABS light on?
Your normal brakes usually still work, but without anti-lock, so wheels can lock in a hard stop. Drive carefully and get it checked soon. If the red brake light is on too, stop driving.
Why does my brake pedal feel spongy?
Common causes are air or moisture in the brake fluid, a leak or a failing master cylinder. A spongy pedal is a serious warning sign, so get it checked before driving further.
What does grinding when braking mean?
Usually that the brake pads are worn through and metal is rubbing on the rotor. Get the brakes checked straight away, because braking is reduced and damage spreads quickly.
How often should brake fluid be changed?
Follow your owner's manual. Many manufacturers recommend changing it every few years, because it absorbs moisture over time.