There is a recall for the rear master cylinder on some of the 2015 tri-glide trikes part # 41700251 which is the same rear master cylinder in the 2015 harley davidson freewheeler trikes, which my rear brake pedal goes down with no stopping, when the rear braked pedal is depressed. Front brakes work fine. Harley davidson is using the same defective rear master cylinder on the freewheeler.
Brakes
Harley-Davidson FLD Brake problems by year
6 complaints filed with NHTSA about the Harley-Davidson FLD's brakes. Spongy or hard pedal, ABS faults, brake failure, noises, parking brake and brake fluid leaks.
Brake complaints by model year
Latest FLD brake complaints
I own a 2012 harley davidson road glide ultra with abs. In 2018 I began experiencing a stiff front brake while riding. After taking the bike into the local dealer for its regular service I was informed that the abs pump needed to be replaced. I was unable to afford the repair at the time. Now, after doing a lot of research, I have found that this is a common problem with the abs pump. My front brake is completely locked up and cannot be activated. Luckily I was not riding when this was found. All of the maintenance...
Read the full complaint
on this bike was done by the dealer including the break services. Harley does appear to be aware of the problem and has issued a recall for bikes with abs from 2008-2011 but only for a fluid replacement and not for the pump failure. There are no changes to the system between 2011 and 2012. The reported fix is regular fluid changes. My bike has been in for service at every recommended mileage because I have a service contract with the dealer. According to harley, if I had regular fluid changes I should not have had this issue, but I still do. If this failure had happened while riding I could have been killed. Up to the point of the total lock up I had experienced a hard break that had to be freed during riding.
The front brake lever on my 2012 harley-davidson electra glide failed. I was leaving a business, the exit was on an incline to merge into traffic. As I was going up the incline I grabbed the front brake to stop for oncoming traffic. The brake lever would not move, I was able to stop the bike with the rear brake at the top of incline ramp. After the incident, I found that the abs brake module on 2008-2011 harley-davidson were failing and about 175,000 bikes were affected. Harley-davidson said the brake fluid should...
Read the full complaint
be changed every two years. The problem is that moisture gets into the brake system and clogs the abs module ports. My bike had extended warranty and maintenance plan, however harley-davidson doesn't change your brake fluid in the scheduled maintenance milestones. They do open your master cylinder and check for moisture, they don't document moisture level. If the moisture level is above a certain level they will tell you, but if it's been two years and your current with your scheduled maintenance they should change the fluid. They don't, they just open your system up to be exposed possible contamination and if the fluid checks good for 3,4 or 5 years they won't say anything. The mere fact they take the top off the master cylinder in a sealed system could be when introduction of moisture begins. Harley-davidson is well aware of this issue and makes no proactive steps to help consumers with cost of correcting this costly or possible fatal discrepancy. Brakes are a necessity for safe motorcycling. If harley-davidson recommends changing brake fluid every two years they should have that on record when the bike comes in for service, just like oil changes.
Tl* the contact owns a 2012 harley-davidson fld. While driving 25 mph, the contact applied the brake, but the motorcycle would not stop. As a result, the contact was involved in a crash. The contact was injured and transported via ambulance to the hospital. A police report was filed. The motorcycle was towed to an insurance auto auction in clearwater. Fl. Lakeland harley-davidson (4202 lakeland hills blvd, lakeland, fl 33805) was contacted, but the technician was not able to provide any information. The manufacturer was not notified. The failure mileage was 7,000.
While riding the bike I heard an unusual metal noise looked down to discover rear brake rod disconnected from rear brake peddle. Clevis pin and cotter apparently dropped off the bike. When I went to tap the brake peddle it was swinging freely. There was absolutely no way to safely bring the bike to a halt. Dealer replaced missing pin.
While riding the bike I heard an unusual metal noise (ever so slight next to the sound of the bike) looked down to discover rear brake rod disconnected from rear brake peddle. Clevis pin and cotter apparently dropped off the bike. When I went to tap the brake peddle, to stop the bike, it was horizontal to the pavement and completely inoperable. Black widow h-d put a 1/4 x 1" bolt - washer - washer - nut [with loctite] on it and ordered a replacement pin. Secondary problem is an overwhelming odor of un-burned...
Read the full complaint
gasoline that fills the garage within minutes of parking the bike, I have smelt the gasoline while sitting at a light as well. I have now made the issue know twice first time to naples hd (at the 1,000 mile service) and secondarily to black widow hd (on 10/19/15). I am going to purchase a meter that I can collect information regarding the raw gasoline in the air inside the space where the bike is parked. As gasoline is a well known carcinogen.....Updated 12/02/15 *bf; updated 4/24/18*jb updated 05/17/18*jb
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data