Check a vehicle VIN check Latest recalls Latest complaints Common problems Rankings Compare vehicles Recall roundups All makes Guides Share your experience
Theme

Body, doors & structure

Harley-Davidson Flhr Body problems by year

3 complaints filed with NHTSA about the Harley-Davidson Flhr's body, doors & structure. Doors, hoods and latches, frame rust, sunroofs, leaks, trim and structural failures.

Body complaints by model year

YearBody complaintsCrashesInjuriesRecalls
20151000
19991000
19951000

Latest Flhr body complaints

2015 Harley-Davidson FlhrBody, doors & structure

While on a road trip through northern arizona and utah in early october 2015, the license plate mounting bracket broke off the bike and was lost. Attached to the broken mount was my license plate, the associated fasteners, reflector and possibly more unknown items. The mounting bracket fractured through both mounting bolt holes. I had achieved speeds up to 75 miles per hour with the motorcycle when the mounting bracket detached from the vehicle. I believe this license mounting bracket on my 2015 harley davidson...

Read the full complaint

road king motorcycle is defective in design or manufacture or both. I believe this defect is dangerous and could cause damage to other vehicles or injure pedestrians. Included is a image of what remains of the license mounting bracket.

Filed Incident StructureNHTSA 10783030
1995 Harley-Davidson FlhrBody, doors & structure

Dt*: the contact stated that the motorcycle chassis and frame rusted and fractured in several places without incident. The motorcycle was not exposed to any harsh weather elements or road salts. The motorcycle was inspected by a dealer who determined a new frame was needed. The manufacturer was alerted.

Filed Incident StructureNHTSA 10164515
1999 Harley-Davidson FlhrBody, doors & structure

I am the original owner of a 1999 harley road king/fl family cycle. I have had the rear fork swing arm break at the axle through hole slot almost putting me in the bushes. The swing arm is made of 1/8x1x2 inch rectangular structural tubing with the side wall(2") slotted so that little structural integrity remains. In addition:1. The vehicle power plant had increase horsepower that year and no modification to the structure. 2. The shock absorber bottom mount is to the rear of the slot so that it cantilevers each...

Read the full complaint

time the shock retracts/extends and in addition the belt adjuster is at the axle point and made of round tubing inside the swing arm acting as a fulcrum point. This leads to tortional and torque loads exceeding the structural integrity/strength odf that section. In previous years the swing arm was round with a casting end and the shock mount forward of the "fulcrum" axle point. In later years the swing arm was changed gain due to I believe excessive failures. I asked harley to assist repeatedly in the replacement of a cycle with only 30k miles. They refused and would not forward requests up the line or to the engineering dept. And refused to allow me to request any related recall or service bulletin regarding this. It is a poor design, due to the cutaway of the side wall and the location of the shock mount, which exponentially increases the load placed at the shock point according to passenger weight, acceleration and terrain. If they have changed it , why? *Nm

Filed Incident StructureNHTSA 10155908

Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data

Owners helping owners

Know before you drive.

Every experience you share - good or bad - shows on that vehicle's page and helps the next owner and buyer. Two minutes, anonymous.

Share your experience