Check a vehicle VIN check Latest recalls Latest complaints Common problems Rankings Compare vehicles Recall roundups All makes Guides Share your experience
Theme

Suspension

Harley-Davidson Flhtc Suspension problems by year

6 complaints filed with NHTSA about the Harley-Davidson Flhtc's suspension. Broken springs, struts, control arms, ball joints, noises and alignment that won't hold.

Suspension complaints by model year

YearSuspension complaintsCrashesInjuriesRecalls
20131110
20111000
20081000
20001000
19992000

Latest Flhtc suspension complaints

2013 Harley-Davidson FlhtcSteeringSuspensionWheels & tiresCrash1 injury

On 7/16/2018, I was driving the subject vehicle in the mountains of central colorado on hwy 50 just east of gunnison, colorado going through monarch pass. The weather was clear that the rod was dry. I was fully awake and sober (do not drink). At approximately 6:00 pm, as I slowed my approached to the turn at monarch pass, my vehicle steering began to gyrate from side to side at approximately 25 -30 mph as I slowed to take a curve. The gyration caused me to lose control of the motorcycle. I was thrown from the...

Read the full complaint

motorcycle into the siding area of the 2 lane road. There were no reported witnesses. I was knocked unconscious and reportedly went in and out of consciousness at the scene and throughout my emergency treatment and transportation to the local hospital and then by emergency aircraft to grand junction trauma center. For 3 weeks I suffered multiple fractured ribs, a collapsed lung, a concussion (was wearing my helmet), and a variety of bruises and abrasions from the crash. I experienced retrograde amnesia, which blocked my memory of the accident until this week (8/16/18). I now remember the violent gyration of the handlebars just before the crash. I have over 12 years of experience riding motorcycles and was on the third day of riding in the rocky mountains without incident. This is the first accident I have had since I began motorcycle riding the motorcycle was virtually new (<5200 miles) and in good condition from the dealership I bought it from on may 19, 2018. I am sure that the steering of the motorcycle caused me to lose control and crash. The motorcycle did not sustain serious damage and was ride-able when brought home then following weekend. Up to that time I had no problems with the vehicle. I want to report this because I am convinced something was mechanically wrong on the motorcycle that day. I may be able to save the next rider from the same problem.

Filed Incident Steering · Suspension · WheelsNHTSA 11120559
2011 Harley-Davidson FlhtcSuspension

Tl* the contact owns a 2011 harley davidson flhtc motorcycle. The contact stated that while driving 50 mph the wheel bearings failed. The contact took the vehicle to the dealer for inspection where the wheel bearings were repaired. The manufacturer was notified. The failure mileage was 18,000. The vin was unavailable.

Filed Incident SuspensionNHTSA 10471614
2008 Harley-Davidson FlhtcSuspension

2008 Harley davidson flhtc wheel bearing failure. Problem was found during routine maint. Had to replace front and rear wheel bearings. Motorcycle only as 35,000 miles these bearings are supposed to be good for 100,000 plus. Wheel bearing failures on a motorcycle can be very dangerous. *Tr

Filed Incident SuspensionNHTSA 10353987
2000 Harley-Davidson FlhtcSuspension

The rear swing arm on my flhtc electra-glide cracked through the center of the left axle bolt hole. The broken part was held on by the rear left shock. The rear wheel stayed on only because the drive belt was holding it in place. This was discovered during a routine tire change while traveling. The mileage on my bike was over 30,000 miles. Due to circumstances, I had to have the part welded, in order to continue my trip. While shopping for replacement parts, I learned this type of failure is becoming common for...

Read the full complaint

'99 and 2000 year cycles with over 30,000 miles. I found numerous references to this failure on the internet. I've also learned that harley davidson has since modified the location of the axle to include solid steel at the failure site, which was previously a hollow piece of tubular steel. This modification occurred in 2002 and newer cycles. I believe this is a silent admission and acknowledgement of a design flaw. I have contacted the company to in order to have the swing arm replaced with a more stable part, but was told the failure could be operator error, or driving the bike improperly, not a design flaw. They will not address the issue. I have since spoken to an area harley dealers mechanic who acknowledged the problem but stated that harley won't address the problem until more bikes start reaching the 30,000 mile mark when this failure typically occurs due to metal fatigue. I fear that this situation could cause the rear wheel to fall off while the bike in operation, if the drive belt fails simultaneously. I have had a broken belt occur while riding, so this scenario is not impossible. *Tr

Filed Incident SuspensionNHTSA 10222327
1999 Harley-Davidson FlhtcSuspension

Hd is aware of the 99 & 2000 tc88 cam bearing failure which could cause the engine to seize up. Hd has service bulletins on this failure but only the dealer receives them. The consumer has no idea that they are riding a motorcycle that could seize up at any time, causing a crash. Do you think this should be a recall item?

Filed SuspensionNHTSA 730065
1999 Harley-Davidson FlhtcSuspension

Reporting a design flaw with the ball bearing used in the cam bushing should be replace with the rolling bearing. Feel free to provide to provide further details. *Ak

Filed Incident SuspensionNHTSA 865226

Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data

Owners helping owners

Know before you drive.

Every experience you share - good or bad - shows on that vehicle's page and helps the next owner and buyer. Two minutes, anonymous.

Share your experience