Rear wheel locked at 40 mph and power cutoff while on a highway on ramp (soft right turn) making the rear wheel slide to the right, causing my passenger and I to fall off the bike hurting our left extremities (legs, arms, wrists, elbows, shoulders) as it slid and ended on its left side on the right shoulder. Harley-Davidson RDRS and Rain Mode were turned on and the road was wet from a previous rain but visible debris on the road.
Acceleration & cruise control
Harley-Davidson Flhtk Acceleration problems by year
10 complaints filed with NHTSA about the Harley-Davidson Flhtk's acceleration & cruise control. Unintended acceleration, surging, throttle problems and cruise or adaptive cruise faults.
Acceleration complaints by model year
Latest Flhtk acceleration complaints
A redesign in the left and right handle controls of the Harley 2014 model's, the Press to Talk (PTT) button and Cruise Control buttons were switched from the left hand grip to the right throttle/brake hand grip. The PTT button is used for the Citizens Band (CB) radio. The PTT button had always been located on the left hand grip and the Cruise Control button had always been located on the right throttle/brake hand grip. In order for the operator to use the CB to talk, the PTT button is used. To activate the PTT...
Read the full complaint
button, the operator's right thumb is used. When performing this action the operator needs to remove the thumb from the right hand grip and press the PTT button, and maintain continuous pressure to the button in order to talk using a motorcycle helmet microphone. The PTT button is the farthest button from the right hand grip at 2 ½ inches. Because the right thumb is removed from the right hand grip, the operator no longer has a grip on the right hand grip for only 4 fingers are on the grip. This is not safe for the operator when controlling the vehicle. The right hand grip has the throttle control and has the brake lever. When using the throttle control, you grip the right hand grip, with all fingers and thumb, and twist the grip to accelerate, decelerate or maintain speed. This setup, when using the PTT button, the operator no longer can maintain speed, accelerate or decelerate the vehicle because the operator does not have a grip on the right hand grip, only 4 fingers. The operator also cannot use the brake lever because the operator does not have a grip on the right hand grip. This setup, when using the brake lever the operator only uses 4 fingers to apply pressure while maintaining their thumb on the PTT button. The operator cannot safely use the PTT button while operating the right throttle/brake grip on the right hand grip. Harley Davidson provided an update to the 2014 models but not for the 2021 models, the update switched the buttons back correctly.
Twist Grip Sensor ECM Code p2138 and P1510. twist grip sensor correlation error and Electronic throttle control limited performance mode.
My front brakes on my 2013 harley dose not work most of the time and it is hard to pull in the brake lever to where when I pull the brake lever in and can not move the lever with no brakes...And some times the front wheel locks up by just sitting or at a stop light and my speed control stops working on and off and have a engine light that goes on and off vin #[[redacted]] redacted to protect personally identifiable information pursuant to the freedom of information act (foia), 5 u.S.C. 552(B)(6) *cc
Tl* the contact owns a 2016 harley-davidson flhtk limited. While driving with the cruise control activated, it disengaged automatically when going over bumps in the road. Also, the throttle would decrease and the vehicle lost power. On july 30, 2019, while pulling out of a parking lot, the throttle completely failed in traffic. The contact had to roll the vehicle to the side of the road. The vehicle was towed to la crosse area harley-davidson (1116 oak forest dr, onalaska, wi 54650, (608) 783-6112) where it was...
Read the full complaint
diagnosed that the six terminal socket caused the throttle to malfunction. The dealer performed wiring repairs and replaced the terminal socket to the throttle. The dealer did not cover the repairs since the warranty had recently expired. The manufacturer was contacted and provided a case number. The failure mileage was 9,960.
With cruise control set at highway speeds, as I approached slower moving vehicles I tapped the front brake like I have done so many times before; but this time the cruise did not cancel. I tapped the front brake several more times and hard enough to make the front end dive. But the bike kept accelerating. I took quick action to shut the cruise off. After getting clear of other traffic I tried to duplicate the problem. I was able to cancel cruise with the rear brake but not the front. 24 Hrs later I went for a ride and this time everything worked normally. I was able to cancel cruise control but just tapping the front brake lever at least 6 times. *Tr
Yesterday (04/03/16), I was traveling through northern va (on route #66), on my way home. Trying to take an exit to gas up, I wasn't able to shift at all. So I'm trying to pull over (very worried I might be hit by an another commuter in a very busy highway / 1st safety issue), to check the bike, I couldn't use my left floor board (affecting my balance / 2nd safety issue), because the shifter and shifter shaft were out of their position and laying on my floor board (these parts could have just flew away and hit...
Read the full complaint
another vehicle on the road / 3rd safety issue). Finally, I stopped the motorcycle, checked the bike, put it on 3rd gear, using linkage and made it to local hd dealership. After this scary experience a gentlemen at the dealership (just a customer with a similar motorcycle rushmore touring), told me that he had the same exact issue as well; thanks!
I turned onto northbound us highway 281 from eastbound south dakota highway 26 and accelerated normally to 65 mph and activated the electronic cruise control in 6th gear. Within a few seconds I heard a number of squeals from the front end and the handlebars began shaking violently. I applied the brakes to rapidly slow the motorcycle down. At 50 mph the shaking stopped. I disengaged the clutch and didn't feel any noticeable resistance. I stopped and inspected the front wheel and saw the bearing shield had moved...
Read the full complaint
away from the bearing . I was about 2 miles from redfield south dakota so I rode to redfield at a very slow rate without the handlebars shaking. I went to the super 8 motel and called the harley owners group roadside assistance. *Tr
Make turns and general operation of motorcycle becomes a problem when trying to use cb control button and maneuver the motorcycle and us cb-squelch. Possibly dropping motorcycle and causing and accident. Should be on left handle bar control not right. Cruise should be on right side with throttle. Accidents are going to be caused because of this issue. *Tr
This 2014 hd flhtk had the hydraulic clutch serviced in october 2013 under the massive hd clutch recall program. However, I inspected the bike and informed the dealer that the clutch fluid low. It was below the sight glass on the master cylinder (acutely at the bottom of the sight glass). I was informed that the cylinder was full and cannot be filled to the sightline because of the design. On november 15, 2013 driving 40 miles from home at 45 mph when I approached a traffic light and started to down shift....
Read the full complaint
Shifting became harder and had trouble getting into lower gears. I turned around and headed for home cutting my trip short. Within a few more miles, I lost all ability to shift gears and almost hit the back of a truck stopped at a traffic light. Luckily I was able to turn into an abandoned parking lot and stall the engine to stop the motorcycle. A phone call to the dealer was made by cell phone and they could not get out to pick up the bike for several hours. The air temperature 41 degrees and out in the open. I took a chance and kept pulling/pumping the clutch handle to build enough fluid pressure to be able to shift gears and drive the bike along side the road to make it back to the dealer. Dealer/service stated they rode the bike five mile and had no shifting issues. I explained if you pump the lever you can feel the pressure build and the clutch works. Dealer agreed as they pumped the lever and felt the same thing and that was strange. I reiterated my concerns about the fluid level. If the bike parked on a slop and on it's jeffy stand, the low fluid level could lead to problems as the clutch wore and fluid level drops. Hd's clutch serious problem needs to be investigated. *Tr
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data