Holiday Rambler Monitor Problems by year

The suspension coil spring box mounting brackets, which are fastened to the main chassis frame, may fail.

Incorrect size ear type clamps were used to secure nylon gasoline lines to barbed connector fittings.

Rubber gasoline hose used to accommodate relocation of the fuel tank is subject to deterioration over time.

Leak in lp gas service line caused by line contacting rear suspension system which results in line rupture.

Under heavy demand on the engine and transmission, the transmission cooler line temperature can exceed the temperature rating of both the plastic conduit and insulation for the battery cable.

Routing of the headlight and clearance light circuits through a single 20 amp fuse and/or breaker which is not adquate for the load created by both circuits.

Routing of air supply lines close to the exhaust manifold pipe subject the lines to deformation and possible rupture from the radiant heat of the pipe.

Wiring harnesses located to the rear of the engine compartment could chafe and short circuit.

Inadequate fastening of the brackets to the frame rail for holding the hydraulic brake and gas return lines may allow flexing and possible chafing of the line...

Motor homes were built with clear plastic lenses and bulbs in the front turn signals instead of amber colored, which is in noncompliance with fmvss 108-lamps, reflective devices and associated equipment...

Seam leaks may develop in the 70 gallon aluminum fuel tank, allowing gasoline to spill on the ground. This is due to poor seam welding...

The fuel switch on the dual fuel control has been wired incorrectly. The switch was wired in such a way that the driver could be pumping propane to the carburetor.