Check a vehicle VIN check Latest recalls Latest complaints Common problems Rankings Compare vehicles Recall roundups All makes Guides Share your experience
Theme

Body, doors & structure

Hyundai Excel Body problems by year

17 complaints filed with NHTSA about the Hyundai Excel's body, doors & structure. Doors, hoods and latches, frame rust, sunroofs, leaks, trim and structural failures.

Body complaints by model year

YearBody complaintsCrashesInjuriesRecalls
19961000
19942000
19922000
19915010
19901000
19884000
19871000
19861000

Latest Excel body complaints

1987 Hyundai ExcelSteeringBody, doors & structure

1987 Hyundai excel has a broken motor mount and both crossmembers are bent.*Mr the consumer believes the vehicle was poorly welded on the right side of the subframe. The cover support bent. The rack and pinion leaked. The upper tie bar bent. *Nm

Filed Incident Steering · StructureNHTSA 10132401
1988 Hyundai ExcelSteeringEngine & coolingBody, doors & structure

Problems with broken motor mount, rack and pinion leakage, bent crossmember in the subframe, etc. (Nar) *ph *cb the consumer sent another complaint referencing 10040082,10022196,10011711, & 10003824 all of which went un-answered. *Tc

Filed Incident Steering · Engine and engine cooling · StructureNHTSA 10064949
1988 Hyundai ExcelSteeringBody, doors & structure

Rack and pinion is leaking, broken motor mount and upper tie bar is bent.*Mr the vehicle was poorly welded on one side of the subframe *ts the cross memeber was bent. *Jb

Filed Steering · StructureNHTSA 10040620
1992 Hyundai ExcelBody, doors & structure

While driving about 55 mph front hood flipped up, blocking vision. Kept control of vehicle, driving off road. Pushed down hood and tied it with a rope then, latch had to be fixed. *Ak

Filed Incident Latches / locks / linkagesNHTSA 881014
1992 Hyundai ExcelBody, doors & structure

Hood latch failed causing hood to smash windshield while driving. (New jersey state police report)

Filed Incident Latches / locks / linkagesNHTSA 523801
1991 Hyundai ExcelBody, doors & structure

Driving down the highway approximately 60mph and the hood released. Pulled over to close hood, and then noticed the u-shaped metal clip detached from the hood. *Ak

Filed Incident Latches / locks / linkagesNHTSA 810304
1991 Hyundai ExcelBody, doors & structure

Loose molding around rear wheel well broke off, causing lost of control by striking the center wall of the vehicle. (New jersey police report)

Filed StructureNHTSA 603367

Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data

Owners helping owners

Know before you drive.

Every experience you share - good or bad - shows on that vehicle's page and helps the next owner and buyer. Two minutes, anonymous.

Share your experience