Knock sensor code P1326 has set my car into limp mode twice from getting wet after a car wash once and the other driving on a rainy day. Both times the dealership has replaced the knock sensor. The car suddenly loosing power on the highway going 65pmh and stock at only able 2k rpm is not safe. It's a known issues that yet to receive a recall or at least permanent fix.
Engine & cooling
Hyundai Kona N Engine problems by year
6 complaints filed with NHTSA about the Hyundai Kona N's engine & cooling. Stalling, loss of power, oil consumption, overheating, head gaskets, timing chains and engine failure.
Engine complaints by model year
Latest Kona N engine complaints
While driving after a recent car wash, my car entered limp mode, limiting the engine to 2000 RPM. Multiple warning lights for electrical, safety, and engine issues appeared on the dashboard, and the error code P211800 was displayed. Despite being inspected at the dealership, the issue couldn't be reproduced, and the error code disappeared. This problem has occurred twice, but each time the dealership was unable to identify the cause since the error code was no longer present.
While driving on the interstate, the car went into limp mode (does not rev above 2000 rpm). I was unable to maintain speed or merge back into interstate. The dealership has inspected the vehicle, however, they confirm everything is normal. The car did give an engine error code of P132600 for Powertrain. This is the second time this issue has occurred, the dealership replaced the knock sensor the first time.
The knock sensor on the engine fails when exposed to any amount of water. The car is designed in a way that lets on too much. It's something that is VERY common amongst owners of these vehicles. It's a safety flaw that needs to be fixed because it puts the car in "limp" mode. That makes the car instantly halt acceleration. Please hold Hyundai accountable
After washing my '23 Kona N in a hand car wash, I experienced a sudden, complete loss of power as I was pulling into traffic immediately afterwards, nearly resulting in a rear-end collision. There was a flashing check engine light (CEL or MIL) on the dash, and I had to have the vehicle towed to a dealership. The stored OBD-II code is P132600 (knock sensor). The car has only 16k miles on it. This is a KNOWN ISSUE, and there are complaints about it all over Reddit, Facebook, and other Internet sites, and it also...
Read the full complaint
affects the same generation Elantra N. This issue can occur ANY TIME THE VEHICLE GETS WET. It is unacceptable that simply washing my car or driving my vehicle in the rain can cause me to lose all power and create an unsafe driving condition. PLEASE compel Hyundai to address this safety issue with a recall.
I took my vehicle through a touch free car wash. After the wash the vehicle sat for about 10 to 20 minutes while I dried off the exterior and cleaned out my interior. After leaving the car wash the car made it less than a mile down the road and illuminated a flashing check engine light with a P132600 code implying a connection rod failure detected by the knock sensor. As of time of reporting the vehicle is still waiting to be serviced by the dealership as it is still under warranty. Safety can be impacted as the vehicle will immediately go into limp mode, throttling performance.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data