Hyundai Motor America (Hyundai) is recalling certain 2026 Kona vehicles. Due to a manufacturing error, the front steering knuckles may crack and break, which can result in a loss of vehicle steering control.
Steering
Hyundai Kona Steering problems by year
20 complaints filed with NHTSA about the Hyundai Kona's steering. Loss of power steering, stiff or loose steering, wandering, column and rack problems.
Steering complaints by model year
Steering recalls
Latest Kona steering complaints
See attached document for complaint.
The contact leased a 2024 Hyundai Kona. The contact stated that while driving 30 MPH, the steering wheel independently turned from the left to the right, and the contact lost control of the vehicle. There was no warning light illuminated. The contact experienced temporary left wrist pain but had not sought medical attention. The contact regained control of the vehicle and stopped the vehicle; however, the failure reoccurred a week later while reversing out of a parking space. During the failures, there were no...
Read the full complaint
other vehicles or objects nearby. The vehicle was driven to the dealer, but the service department was unable to duplicate the failure. The dealer claimed that the vehicle was safe to drive but refused to provide it in writing. The vehicle was not repaired. The manufacturer was not notified of the failure. The failure mileage was approximately 35,000.
The car shuts off at random times during me driving . Its like the car locks up steering and shuts completely down . Have to pull over and give the car time . And it shuts back on in and drives with poor accelerate after each issuse. The car is now shaking and making popping sounds while driving .
I purchased a used Hyndai Kona with 26,000 miles April 30 2026. I was told I have the balance of the manufacturer warranty of 5 years or 60,000 miles. I have not driven my car for 73 days because of extreme safety problems the Hyundai Kona. The car is very difficult to steer. The car pulls significantly to the right. One day after I purchased this vehicle the car jumped the curb and my face hit the steering wheel cutting my nose and creating a black eye. There is a lot of play in the steering wheel. When...
Read the full complaint
accelerating from a stop the car hesitates to move creating a safety concern. My rear view mirror does not stay in place. The mirror drops down and I cannot see behind me causing a safety concern. Both side view mirrors have to be adjusted each time I drive the car.
The contact owned a 2024 Hyundai Kona. The contact stated that while driving and pulling out of a parking space, the steering wheel turned to the right and then left, after which the vehicle lost power and steering capability. As a result, the contact was unable to maintain control of the vehicle and collided with a pole. The contact could not recall any warning indicators that illuminated after the incident. The driver side bumper and hood sustained damage from the collision and a nearby concrete barrier was...
Read the full complaint
also scratched. The vehicle came to a stop in the parking lot in front of the pole. No air bags deployed. The vehicle was subsequently towed to a collision repair facility. No police report was filed. The insurance company determined the vehicle to be a total loss. The contact stated that the seatbelt locked during the crash, causing strain to the left shoulder and a laceration to the left thigh. The contact also reported striking the steering wheel. No medical treatment was sought. The dealer and manufacturer were notified of the failure. The vehicle was not diagnosed or repaired. The approximate failure mileage was 28,791.
My 2020 Hyundai Kona (VIN: [[redacted]] ) has a persistent engine stalling safety defect that matches Recall 203 (22-01-042H, NHTSA Campaign 21V301000 - Nu 2.0L Atkinson Engine Inspection and Replacement). The recall addresses improperly heat-treated piston oil rings causing cylinder bore scuffing, accelerated oil consumption, abnormal knocking, and potential engine stall while driving (increasing crash/fire risk).I first brought the vehicle to Corona Hyundai for repeated stalling while driving. They performed the...
Read the full complaint
recall vibration inspection and software update (Campaign 974), stated the test passed, and declared the vehicle "fixed", safe and "good-to-go" Immediately after pickup, the stalling returned worse: approximately 60-80 miles later on XX near the [redacted] exit (four-lane high-speed highway), the engine completely stalled at 65 mph while merging for an exit. This caused vehicles and semi-trucks behind me to swerve dangerously and very nearly collide with me. The vehicle stalled four more times on the way to my destination in [[redacted]] .I then took it to the nearest dealer, Carlsbad Hyundai for safety reasons. They performed the vibration inspection again, which also "passed," yet the real-world symptoms would continue unchanged: accelerated oil consumption (I monitor the dipstick and refill regularly), sputtering, knocking noises, and complete engine stalls (dozens of incidents, especially on local roads and turns). The vehicle remains undrivable due to imminent stall risk while moving and putting myself, my passengers and other commuters at high risk of severe injury or death.Both dealers and Hyundai Customer Care (Case #[redacted]) have refused further action, stating the vibration test passed, they cannot duplicate the concern, and no additional claim can be submitted for engine replacement. Hyundai's TSB [[redacted]] requires only the vibration inspection; engine replacement is authorized if "NO PASS" - no separate oil consumption test or monitored drive INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
While at a light, the auto stop/start kicked on but when it was time to start driving again and I pressed the gas pedal, the car would not move. There was a long beep and then the check battery icon and an alert came on my dash board stating "Auto Stop is Off. Shift to P or N and start engine manually." When I turned off the ignition and restarted the car, the alert went off but two additional icons showed up on my dash board- check engine and check oil. Then my steering wheel locked up and I could not press on the breaks or gas pedal. I could not operate my car for more than 30 minutes.
the car loss power and shut completely off and ran into the wall with my sister and my child in there on the interstate can I please get help about this matter it could've been worse where i could've lost them forever. I don't want this to happen to nobody else they cars know about these malfunctions and still but these cars on the market for accidents to happen. Please something needs to be done about this.
My family got in a accident on this recall of loss of power on the high way making the car crash into a wall... 8/16/25 3:06 pm in Duval county Jacksonville,FL Something needs to be done about this my kids have gotten hurt
Car pulls to the right since I had it..the dealer did a alignment twice already but it still pulls to the right..they did a alignment at around 5000 miles and again at 8000 miles but it still does it.
At a stop sign, or red light, car bucks, then accelerates. Steering column is making noise. Took car to dealership..stated they can't look at my car until October 31st, 2023! My car only has 16k miles. If this is a dangerous issue, especially the steering colum noise (possibly a bearing issue or rack and pinion problem)..why am I having to wait until October??
I was hearing a weird sound when turning the steering wheel and it reminded me of the same noise that happened before in March 2020 when the column and housing (part number 56390-39000)as well as bolt-safety lock (part number 81919-31000) were replaced at Boulder Hyundai (now called Foundation). This was covered under warranty then as the mileage was 24,928. The notes say: Customer states that there is a sound when turning the wheel. Technician confirmed customer complaint. Sound coming from steering wheel...
Read the full complaint
described as "growling". Found TSB that states if sound is heard to remove and replace steering housing and assembly. Technician removed and replaced steering wheel column and assembly. Test drove to ensure proper operation. All is okay. When this happened again I told Manly Hyundai, and the service advisor said it was the worm gear. However I still had to pay for a diagnosis and repair ($225.09). If this is common, and there is a TSB, I'm very disappointed with what has happened (again I believe). The notes say: Confirmed noise at steering column. Worm shaft bearing noise. Recommend replacing small bearing kit as per TSB 22-ST-005H-1. Replaced worm shaft bearing as per previous diagnosis. Removed old component. Installed new bearing. OK at this time. Noise gone. [Part number ?56359-L1AAAFFF Bearing Kit, also has 84586.] The Kona now has 84,580 + miles. I don't know how serious the problem is but I knew the sound wasn't right and I don't want the steering to fail. I really don't want this to happen again. Your attention to this is appreciated. Sincerely, [[redacted]] INFORMATION Redacted PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6).
Trying to pull off the free way to the right and it decided to go left in front of a truck. It likes to take control. Scary. I have not had the car even 2 months.
Accident due to recall
Car has been pulling to the right since a week old. Dealer adjusted alignment and still doing it. Wheel is off center and more resistance going left than right.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data