Nissan is recalling certain model year 2003-2005 infiniti q45 vehicles. A wiring connector for the seat mounted airbag may experience increased electrical resistance, resulting in the non-deployment of the side air bags.
1990-2006 · 17 model years
Infiniti Q45 Problems by year
Owners have filed 234 complaints about the Infiniti Q45 across 17 model years, and it has 11 recalls. The 1994 has the most complaints once its age is allowed for (31), while 1993, 1996 have far fewer than a typical year. The most reported problem area is the electrical system, followed by the transmission & drivetrain.
- Complaints
- 234
- Recalls
- 11
- Crashes
- 28
- Fires
- 16
- Injuries
- 28
- Deaths
- 0
Q45 complaints by model year
Highlighted: the year with the most complaints for its age. Older vehicles have had more time to collect complaints - the Safety Index grade allows for that.
Most common Q45 problems
Infiniti Q45 recalls 11
Certain vehicles fail to comply with the stop lamp and reflex reflector requirements of federal motor vehicle safety standard no. 108, 'Lamps, reflective devices, and associated equipment."
Certain passenger vehicles equipped with power rear seats fail to conform to the requirements of federal motor vehicle safety standard no. 225, "Child restraint anchorage systems." The lower anchorage brackets in the rear seats do not meet the location...
On certain passenger vehicles, the brake lamp switch may malfunction.
On certain passenger vehicles, the circuit board for the crank position sensor or cam position sensor may have an improper solder joint due to solder deformation caused by heat stress accelerated by the existence of flux residue during the soldering process.
On certain passenger vehicles equipped with 17 inch alloy wheels, the wheels may have a casting defect from which cracks could propagate as the vehicle is being driven.
On certain passenger vehicles, one of the diodes used in the alternator may have been damaged when built. This can eventually result in failure of the diode and an electrical short which could melt the plastic housing.
Vehicle description: passenger vehicles. One of the diodes used in the alternator may have been damaged when built. This can eventually result in failure of the diode and an electrical short which could melt the plastic housing.
Vehicle desription: passenger vehicles. The ignition key can be removed when the engine is turned off without placing the transmission shift lever in the "park" position. This does not comply with the requirements of fmvss no. 102, "Transmission shift...
Vehicle description: passenger vehicles equipped with bose rear speakers that have an integral amplifier. A conductive bridge can form between two lines of the circuit board pattern when there is accumulated electrolyte leaked froma capacitor and high...
The front safety belt buckle release buttons can break. These red plastic release buttons are marked "press." If a button breaks, pieces can fall into the buckle assembly causing the buckle to operate improperly.
Latest Q45 complaints
The circuit board for crank position sensor and cam position sensor have improper solder joints. This has caused the service engine light to come on, the engine may not start, power reduces, engine stalls at a traffic light or while in motion, on a city street or highway or while making a turn. This is also a common problem with the 2002 infiniti m45, q45; 2003 infiniti i35, m45; 2003 nissan altima, maxima, murano, sentra. There are 11 consumer complaints, 3 investigations and 33 service bulletins regarding this issue with the 2003 q45. Infiniti/nissan recall # 03v455000
I had a problem with my car, with the tires constantly leaking. I had to fill them with air all the time, had them checked a number of times, and had to have the rims cleaned and reground, etc., Trying to determine and solve the problem. After incredible aggravation, we finally tracked the problem down to cracks in the valve stems. The valve stems contained the air pressure sensors and were expensive to replace, parts were as much as $135 or so each, plus labor, which could be $200 or more, and then all the tire...
Read the full complaint
pressure sensors had to be re-set - I think the term was recalibrated or something, which most places didn't have equipment to do or couldn't do correctly, and I always ended up having to go to a dealership. At least they sometimes didn't charge as much as they could, as I was a captive; if they didn't do it, none of the sensors would work. I discovered that these valve stem sensors were subject to cracking, and had just been put on the car for that model year. Midway through the model year, they were replaced with another type made out of better material. Before my model year, the type used was in service I think for several years. The mid-year replacements were used for the next several model years. This all suggests that they knew there was a problem, but avoided paying for it or issuing a recall. Could you please investigate? Thank you
Tl* the contact owns a 2004 infiniti q45. The contact stated that the vehicle's frame was corroded. The vehicle was included in nhtsa campaign number: 11v244000 (steering, suspension). The manufacturer stated that they would not pay for the repair. The dealer was not contacted. The contact kept the vehicle parked and had not driven it in over two years. The vehicle was not diagnosed or repaired. The failure mileage was unknown.
When cruise control is set, and the need to pass or speed up is required, if you press the gas pedal to the floor the car takes off and *then stops responding and drops back to set cruise control speed while you are still flooring it. It bucks back and forth. I spoke to several owners on a infiniti owners site and theres performs the same. Its dangerous if the need to speed up occurs. This is a problem in the coding of the parameters in the ecu and could be deadly with unexpected performance. This happened on i40 in knoxville tennessee in heavy traffic. This condition can be repeated back to back multiple times.
Tl* the contact owns a 2003 infiniti q45. While driving 35 mph, the vehicle stalled and the service engine warning indicator illuminated. The contact was able to restart the vehicle after several attempts. The vehicle was taken to an independent mechanic where it was diagnosed that the camshaft position sensor failed and needed replacement. The vehicle was not repaired. The dealer was not contacted. The manufacturer was made aware of the failure and informed the contact that the vin was not included in nhtsa campaign number: 03v455000 (engine and engine cooling). The failure mileage was approximately 150,000.
My car randomly shuts off in the middle of driving. First time I was on the highway and it started right back up. Then again when I got home. One time it had a p0340 code for the camshaft position sensor, and I changed it three times in the last week and it still shuts off in the middle of driving.
Questions about the Infiniti Q45
Which Infiniti Q45 years have the most problems?
Which Infiniti Q45 years have the fewest complaints?
What are the most common Infiniti Q45 problems?
Across every model year, owners report problems with the electrical system (35), transmission & drivetrain (34), engine & cooling (30) most often.
How many recalls does the Infiniti Q45 have?
NHTSA lists 11 recalls across all Infiniti Q45 model years. Each year's page lists the recalls for that year; check your own vehicle by VIN at nhtsa.gov/recalls to see whether the repair has been done.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data