On certain school and transit buses built with bosch zero offset pin slide (zops) hydraulic disc brakes, the zops hydraulic disc brakes may experience calipers sticking in the applied position, which can result in excessive or abnormal heat generation at one...
1979-2001 · 20 model years
International Harvester 3600 Problems by year
Owners have filed 0 complaints about the International Harvester 3600 across 20 model years, and it has 11 recalls.
- Complaints
- 0
- Recalls
- 11
- Crashes
- 0
- Fires
- 0
- Injuries
- 0
- Deaths
- 0
3600 complaints by model year
Highlighted: the year with the most complaints for its age. Older vehicles have had more time to collect complaints - the Safety Index grade allows for that.
International Harvester 3600 recalls 11
These buses have a turn signal lever that will not operate consistently in the lane change mode if the lever is not moved to the position where resistance to movement is felt.
The wiring from the electronic control unit was connected to the wrong wheel sensor or to the wrong brake modulator valve. It is possible that either or both wiring may have occurred at either the front or rear axle or both axles.
The fuel hose to the fuel filter is routed too close to the alternator belt causing the alternator belt to rub the fuel hose. This can cause a fuel leak.
The base of the electronic accelerator pedal is made of die cast aluminum. The base mounts directly to the cab firewall. The cab firewall is not rigid enough or flat enough at the mounting surface, causing stress on the accelerator base that will cause the...
Four compression backplate retaining fasteners on the turbo-charger were torqued only hand tight. This allows the fasteners to loosen, and causes oil to leak into the compressor air side of the turbo-charger which, when coupled with the heat precipitated by...
The hydraulic steel brake lines from the master cylinder to the frame fittings are experiencing vertical flexing which causes fatigue cracks at the frame end of the assembly, resulting in brake fluid leakage. This can occur in one or both of the steel brake...
The fuel tank cage assembly bolts mounting the vertical straps to the horizontal angle were assembled with the threaded end of the bolts facing the fuel tank.
The pressure relief valve was omitted in the air tank. The air tank is the reservoir for the air suspension and is not brake related. Without the pressure relief valve, there is no back-up system to limit air pressure in the air suspension system.
The bracket that supports and positions the hand throttle cable at the accelerator rod can be bent or misaligned during body assembly to the chassis.
THE FUEL SYSTEM FAILED THE CRASH BARRIER TEST.
Questions about the International Harvester 3600
Which International Harvester 3600 years have the fewest complaints?
How many recalls does the International Harvester 3600 have?
NHTSA lists 11 recalls across all International Harvester 3600 model years. Each year's page lists the recalls for that year; check your own vehicle by VIN at nhtsa.gov/recalls to see whether the repair has been done.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data