Winnebago industries (winnebago) is recalling certain model year 2009 through 2012 winnebago commercial vehicle model j38s, model year 2009 and 2010 adventurer motorhomes manufactured from october 30, 2008, through september 9, 2011, and one 2009 itasca...
Brakes
Itasca Suncruiser Brake problems by year
15 complaints filed with NHTSA about the Itasca Suncruiser's brakes. Spongy or hard pedal, ABS faults, brake failure, noises, parking brake and brake fluid leaks.
Brake complaints by model year
Brake recalls
Certain motor home chassis fail to comply with the requirements of federal motor vehicle safety standard no. 105,"Hydraulic and electric brake systems." The brake system warning indicator may not function as required by the standard.
Latest Suncruiser brake complaints
Tl* the contact owns a 2009 ford f-550 equipped with an 1994 winnebago itasca sun cruiser. The contact stated that while driving at 50 mph, the brake pedal was depressed, however, traveled to the floor while the brake fluid low warning light illuminated. The rv was taken to an independent mechanic where it was inspected and noticed that the brake lines were leaking and had extreme corrosion. The rv repair was pending. No dealer was contacted. The manufacturer was made aware and informed of the failure. The contact was also informed that the rv was not subjected to a recall. The failure mileage approximately 48,923.
While driving my itasca suncruiser motorhome to cobb & son rv repair I noticed I was unable to maintain normal speed. Arrived at cobb and explained to ritchie cobb the problem I was having. Ritchie had a tech measure the heat at the brakes and they were at 900 degrees. Informed recall from workhorse regarding a brake issue and that the vehicle would have to be driven to an authorized workhorse dealer for repair (100 miles away). Ritchie explained this could not be done as the vehicle was unsafe to drive and there...
Read the full complaint
would be serious risk of injury and even further damage as the pads were worn and crystallized, calipers bad, and the brake failure have created serious grooves in the rotors. Additionally the brakes had already gone into locking up mode. Ritchie said the remedy was replacement of all this parts on all 4 brakes because of damage caused by the recall issue. Astounded that workhorse said I would have to drive the vehicle to their dealer facility(100 miles away), I personally called workhorse. I got the same answer from customer service, then the head of customer service, then thirdly from carl dahl their regional manager. I refused to risk driving the vehicle and had to have it towed at my expense as workhorse refused to do so. My next surprise was that workhorse would not replace rotors, pad, etc., Even though their recall issue caused all the damage. A policy to tell someone to drive an unsafe vehicle and then they would tow it when I break down on the side of the road is insane and irresponsible. Further they are ignoring their responsibility to repair all the damage that was caused by their recall. I have now had to pay over $1,100 to restore my brakes, pay for towing, and drive 200 miles to pick up my motorhome. I need your assistance to persuade workhorse to do the ethical and honorable thing and reimburse all the money I have spent. *Js
On november 10, 2011 I was having recall #51101-c completed on my motor home. The mechanic had the brakes apart to replace the bosch brake calipers and he discovered all four rotors had 2 -3 cracks on the outside plate. The cracks started on the outside edge and radiated in about 2 inches. The cracks were completely through the plate. Workhorse refused to admit the cracked rotors might have something to do with the bad calipers or a manufacturing defect. They suggested the cracks were caused by driver error. For example, riding the brakes down a mountain or towing a car without auxiliary brakes. *Tr
Brake failure, happened two times so far. It is connected to the safety recall 50901-c. Workhorse brake caliber hang up. Company failing to act to repair w-20, w-22 chassis. Workhorse claims the have noted the problem, and have started to produce calibers, this was started back in 2009. If this company is still building these chassis's how can the say that there are no parts available? *Tr
I have a 2003 itasca suncruiser with the workhorse chassis that is under recall for the brake caliper problems. I encountered the problem last summer and took it to parkview rv in smyrna, de. They rebuilt the front and back brakes, seals, calipers, pads and sensors which had melted. At the time they told me workhorse would not pay for any of the work. Last week I took the repaired unit to florida and in tampa had a problem with the brakes smoking and the abs light came on. I am taking it back to parkview so...
Read the full complaint
they can document the new problems. I have spent over $1,000. For repairs and now it appears it will all have to be done again. I only drove for 2,000 miles and the braking system is bad again. I need to be reimbursed for the initial repair and a more permanent fix needs to be done on the unit. I have a $85,000 rv I am afraid to drive. Please help me if you can. The workhorse help line directs you to a mailbox that is full. I can not get anyone on the line. If necessary I will spend repair money on an attorney to get this resolved. Anything you can do will be appreciated.
Tl*the contact owns a 2004 itasca suncruiser rv. The contact noticed that the brakes were sticking. He took the vehicle to a mechanic and was informed that the brakes needed to be replaced. All of the calipers were replaced by the mechanic. The rear driver's side rotor and front passenger side rotor were replaced, in addition to all of the brake pads. The entire repair cost $3,000. The failure mileage was 18,000 and current mileage was 52,555.
While traveling in florida during february of 2008, in my 2004 itasca suncruiser my right front wheel caliper locked up and caused my motor home to pull to right. The wheel began to smoke and became extremely hot. I was able to get the vehicle off the road and contact the winnebago motor home company. They informed me the issue was a workhorse chassis issue and that I should contact them. They then gave me the location of the nearest workhorse chassis repair center to my location. I contacted the facility and made...
Read the full complaint
an appointment to repair the brake. Mr. David nichols of nichols diesel engine services in eustis, florida informed me that the right front caliper had failed and had destroyed the wheel rotor. He called mr o'neil, the florida representative for workhorse because the motor home had only 11,200 miles and was a little over a month out of the three year warranty. Mr o'neil stated that workhorse would accept no responsibility for the problem. Nichols diesel replaced both the front calipers and rotors at a cost of $800.00, And informed me that workhorse stated that the slide pins on the calipers needed to be lubricated once a year. While traveling in alabama during december of 2008 my left rear caliper locked up causing the brake to over heat. The motor home is scheduled to have the brakes serviced again at ward truck in pensacola, florida. A friend recently informed me that workhorse w20 and w22 chassis from 2000 to 2005 with bosh calipers were under investigation for a high number of brake failures and that I should file a complaint with the reviewing agency, nhtsa. If there is a safety issue with this brake system I hope it is identified and rectified before someone is hurt . I have spoken to many rvers who have this chassis and model years in question, and many have stated that they have had brake failures in the w-22 chasis which is the same as mine. *Tr
Brake problem on workhouse chassis motorhome. Calipers lockup, apparently do to pins. This is a continuous problem. Replaced all 4 rotor. 4Calipers.2 Sets brake pads, 4 oil seals, 4 brake hose,2 axle gaskets. All at a cost of $3502.97 I have rotors, calipers. *Tr
Tl*the contact owns a 2004 winnebago itasca suncruiser . While driving 35 mph, the brake pedal extended to the floor when it was depressed. The contact had to downshift in order to stop the vehicle. The abs brake indicator illuminated and he drove into a parking lot in order to stop the vehicle. The contact called a towing company to take him to a repair shop because he was too scared to drive the vehicle without it being inspected by a mechanic. The repair shop had to replace the entire rear braking system. ...
Read the full complaint
They also serviced the front brakes. The contact retrieved the vehicle the next day and the front brakes failed while driving approximately 30 mph. The repair shop was called to the scene and they completely rebuilt the front brakes again, except for the rotors. The total cost to repair the front and rear brakes was $2,500. The manufacturer advised him to file a claim with workhorse because they made the chassis, which was the cause of the failure. The contact has not yet heard back from workhorse. The failure mileage was 27,000. Updated 11/07/08 *bf updated 11/07/08. 8Jb
Tl*the contact owns a 2003 itasca suncruiser rv. While driving 60 mph, the contact noticed a vibration in the steering wheel. He turned off the vehicle. When he restarted it, he noticed that the brake pedal was higher than usual and he had to apply extreme pressure to stop the vehicle. The vehicle was taken to the dealer and they stated that all four calibers needed to be replaced. The contact did notice any differences beforehand. The current and failure mileages were 15,944.
I purchased my rv in 2004 and it was 2 years old at the time. Later that year I found out it was subject to a recall for a potential problem with the brakes. I took it to a recommended dealer in september of 2004 (25,760 miles) and they said it was ok. I do not recall if they did anything or not. I again took it for service in february 2006 (39,000 miles) and was told the discs were scored and cracked but that they should be ok. Last spring in march 2007 ((50,000 miles) I took it in for another checkup...
Read the full complaint
and was again told the discs were in bad shape so I authorized a full brake job. (About $2000 if I recall correctly but I have full docs and can find them if necessary) I have been reading that there is an apparent generic problem with these braking systems and they are failing at a very high rate. I now have 62,000 miles on it and am concerned I will have to spend another $2000 soon. *Tr
The vehicle in question is a 2004 itasca suncruiser 35 foot motorhome built on a workhorse w22 chassis. It was purchased on june 30, 2004. It was purchased new with 1911 miles on the odometer and had 11391 miles at the time of the incident. On sep 6, 2007 while traveling from the east coast of florida to kissimmee, fl, I noticed the rv pulling to the left when braking as we approached kissimmee. When we pulled into the campground, I smelled ?Hot? Fluid and noted liquid dripping from the right front wheel onto...
Read the full complaint
the tire. The wheel cover was very hot. While moving to our campsite, the brakes were very spongy, although they did stop the vehicle. I called the workhorse customer assistance center and was referred to an authorized dealer in the area. I called them and was able to make an appointment the next morning. They were able to exam the vehicle immediately and found both right side rotors scored, with evidence that the brake calipers had seized. The fluid on the right front wheel was discovered to be gear oil, most likely from the hub overheating. The authorized dealer proceeded to reface the right side rotors and replace the brake calipers with the only two new calipers he had available. Brake pads and other seals, gaskets, etc were replaced as required. The dealer suggested that I should have the two left side calipers replaced also, as they would probably fail shortly. Unfortunately, parts to accomplish this were on backorder. He also indicated there wasn't anything I could do to prevent failure, other than watching them to make sure that the rotors are not destroyed if and when the calipers do seize. Upon returning home and doing some research on the internet, I discovered that workhorse has a history of problems with brake calipers. This goes along with the mechanic at the dealer, who indicated that they have to change them all the time. He showed me a large pile of caliper castings waiting to be returned for core credit. *Tr
A jelly like substance in my brake system. Workhorse at first said to have the dealer flush the system and replace the brake fluid, then they back off and said there is nothing wrong?*Ak
AUTOMATIC BRAKES ENGAGED WHILE DRIVING. *AK
Intake manifold had overheated. Also, vehicle will seize up and not stay in park. Cause unknown. Dealer notified.*Ak there was an auto park brake failure due to the brake control cable mounted within one inch of the exhaust pipes. It burned through the cable causing it to seize up and the parking brake to be inoperable. *Jg
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data