Chrysler (FCA US LLC) is recalling certain 2020 Jeep Wrangler vehicles. The left side lower control arm bracket and weld may not be correctly positioned.
Suspension
Jeep Wrangler Suspension problems by year
1,638 complaints filed with NHTSA about the Jeep Wrangler's suspension. Broken springs, struts, control arms, ball joints, noises and alignment that won't hold.
Suspension complaints by model year
| Year | Suspension complaints | Crashes | Injuries | Recalls |
|---|---|---|---|---|
| 2023 | 40 | 0 | 0 | 0 |
| 2021 | 181 | 1 | 0 | 0 |
| 2020 | 52 | 2 | 0 | 1 |
| 2019 | 134 | 0 | 0 | 0 |
| 2018 | 343 | 1 | 3 | 0 |
| 2017 | 8 | 1 | 3 | 0 |
| 2016 | 8 | 0 | 0 | 0 |
| 2015 | 17 | 0 | 0 | 0 |
| 2014 | 15 | 1 | 0 | 0 |
| 2013 | 20 | 1 | 1 | 0 |
| 2012 | 20 | 0 | 0 | 0 |
| 2011 | 39 | 0 | 0 | 0 |
| 2010 | 42 | 2 | 0 | 0 |
| 2009 | 72 | 0 | 0 | 0 |
| 2008 | 139 | 1 | 0 | 0 |
| 2007 | 169 | 2 | 1 | 0 |
| 2006 | 72 | 1 | 4 | 0 |
| 2005 | 51 | 1 | 1 | 0 |
| 2004 | 59 | 1 | 1 | 0 |
| 2003 | 19 | 1 | 1 | 0 |
| 2002 | 19 | 2 | 0 | 0 |
| 2001 | 21 | 2 | 3 | 0 |
| 2000 | 25 | 1 | 0 | 0 |
| 1999 | 6 | 1 | 2 | 0 |
| 1998 | 26 | 3 | 0 | 0 |
| 1997 | 25 | 0 | 0 | 0 |
| 1995 | 7 | 0 | 0 | 0 |
| 1994 | 1 | 1 | 1 | 0 |
| 1993 | 4 | 2 | 1 | 0 |
| 1992 | 1 | 1 | 0 | 0 |
| 1990 | 3 | 0 | 0 | 0 |
Suspension recalls
Latest Wrangler suspension complaints
The contact owns a 2023 Jeep Wrangler. The contact stated that occasionally, while driving at approximately 50 MPH, the vehicle was wobbling abnormally. The vehicle was taken to a local independent mechanic, where the track bar and shocks were replaced. The local dealer was contacted. The manufacturer was made aware of the failure by telephone. The failure mileage was approximately 6,000.
The Jeep shakes uncontrollably when driving over 50 mph. A rapid braking and speed reduction to under 30 mph will stop the shaking but it will occur again and again. Stellantis has built a completely unsafe car. I can no longer drive the vehicle on the highway or with my kids in the car. I want this major safety issue repaired at the manufacturer's expense.
At highway speed when hitting even a small bump or road irregularity, the Jeep experienced the notorious "death wobble". Oscillating shimmy and momentary loss of control. I discovered the steering damper was blown out on the track bar. After looking into the technical service bulletins, I found that I have the aluminum steering gear box described in TSB-08-074-20. I took my vehicle to the dealership to have this investigated and they agreed that the aluminum steering box caused the excessive force on the damper...
Read the full complaint
and steering components and needs to be replaced. However, since this is not covered under warranty, they are charging me for the repair of a well known and documented FACTORY DEFECT. I applied for goodwill repair and was denied. It is terrible that this should have been a recall and I am stuck paying the bill. But even more so, this is a SEVERE SAFETY ISSUE and is not a matter of if it will happen, but when it will happen. No one should be subject to losing control of their vehicle at highway speed due to a KNOWN DEFECT.
Jeep dealership described the symptoms as the Jeep Death Wobble that has previous recall in prior years.
Steering damper and drag link and drag link ends.
Death wobble dealer states was repaired by a bushing, lakeland Chrysler dodge selling and servicing dealer. They can not duplicate but no one is ever available to road test. Spoke with General manager and was told to trade in not we want to fix
FCA US sent me a written warranty extension (15 years/150,000 miles) for the instrument panel cluster on my vehicle, covering a blank EVIC display with no digital speedometer, fuel level, temperature, odometer, or PRNDL. My vehicle has this condition intermittently. As I was traveling approximately 55 mph my power steering, antilock brakes, speedometer, fuel gauge, traction control, all-wheel drive, and emergency brake warning lights came on/off. I actually lost power steering and was unable to turn the vehicle...
Read the full complaint
off. I reached out to Jeep and advised them of this and that I received the letter for the instrument panel cluster XZ1 and I thought this was related. I read the letter to them word for word, and they had the dealership perform the recall on my clutch. I didn't know until all of the same things happened again and I checked the receipt to confirm the work performed. I reached out to Jeep the same day and that was more than a week ago. I now have a new service transmission light. My vehicle is not safe to drive and they still don't even know why I called. My case number with Jeep is 98166358.
Death wobble
When I was coming to a stop at a stoplight, my vehicle started to violently wobble almost having me to loose control. I was unable to slow down when pressing the brakes and almost hit vehicles in front of me.this has happened numerous times and I have had my tires rotated and alignment done just recently.
When driving down the road, 55mph, I drove across some bumps in the road, and my steering, tires and the front of my Jeep started shaking violently. Couldn't hardly control it. Please help.
At approximately 58,000 miles I discovered that the rear upper coil spring mounts on my 2020 Jeep Wrangler JL Unlimited Rubicon are separating from the frame. The factory welds attaching the upper coil perches to the frame rails have cracked and torn, and the mounts are no longer securely attached. I found this condition only incidentally, while inspecting the vehicle for a separate ongoing steering issue. The coil mount separation was not what I was looking for, and I would not have found it otherwise. These...
Read the full complaint
mounts carry the rear vehicle load. If one separates completely, the coil spring can unseat and the rear of the vehicle can drop on that corner, causing loss of ride height, brake line displacement, and loss of vehicle control. I consider this an imminent safety hazard and I have stopped driving the vehicle. The fracture surfaces are heavily rusted, indicating the welds failed a considerable time before I discovered the condition, most likely years earlier and within the warranty period. The vehicle was taken to Jeep dealers for service and inspection multiple times during that period, and no Jeep inspection ever identified or reported this failure.
On the highway, at Highway speeds of 70 mph, going over small bump my jeep goes into a death wobble. Both tires bouncing erratically steering wheel racing back-and-forth. To stop the death wobble I Have to let off the gas and slowly break to a complete stop before the death wobble stops. The frustrating part is, the Jeep Wrangler, is only five years old, and it has never been off-road, and has less than 28,000 miles on it, not to mention how dangerous the situation is. I have had this happen 6 times.
2021 jeep wrangler 4xe unlimited rubicon. Death wobble steering stabilizer has been replaced. 4 Alignments in a week . Was told that it was my tires nope not the case . I can't not drive my jeep at all . Now the transfer case is leaking the track bar that I told the mechanics it needed to be replaced . The mechanic at John jones told me not to bring it back because I was not a mechanic to find someone else .ive had it sense oct2025 and put not even a thousand miles on it . Lemon laws do exist jeep needs to make it write. I've almost went into on coming traffic 3 times in the last week . The 4xe needs recalled before someone gets killed or kills someone ..
I am reporting a safety concern involving my vehicle's steering system, front-end condition, and a recall I was not informed about. I brought the vehicle in for a routine tire rotation, at which time I was informed that the front camber was out of specification and that there was uneven wear on the front tires. An alignment was recommended. In addition, the vehicle is experiencing abnormal steering behavior. The steering wheel has a noticeable shake and does not feel normal during operation. This suggests a...
Read the full complaint
possible issue with the power steering system or related suspension components. The combination of uneven tire wear, improper camber, and a shaking steering system presents a significant safety risk. These issues may affect vehicle stability, steering control, and tire integrity, increasing the risk of loss of control while driving. I have also recently learned that there is an active recall affecting this vehicle, of which I was not previously notified. The fact that this recall was not communicated raises additional safety concerns, especially given the steering-related symptoms currently present. These conditions were identified during a recent service visit, and the underlying cause has not yet been resolved. I am concerned that this may represent a broader defect involving the steering or suspension system that could impact vehicle safety and that proper recall notification procedures may not have been followed.
Summary of Issue: The vehicle exhibited a repeatable dangerous steering oscillation after encountering road irregularities at speed. This occurred multiple times and is consistent with the known Wrangler "death wobble" condition for which a class action settlement exists on prior MY vehicles. Context: The wobble occurred several times during 2025, always on the highway. The violent oscillation (which seemed harmonic in nature) occurred when driving 65-70mph after running on a bumpy stretch of road (which basically...
Read the full complaint
describes most of Michigan right now). The only remedy was for the driver to immediately hit the warning lights, brake and slow down to around 20-25mph to reduce the oscillation, thereby regaining control. The Jeep service shop replaced all four shocks and the steering stabilizer, in addition to checking wheel alignment/balance etc. Additional Technical Context: I believe the Wrangler 4xe's unique mass distribution may be contributing to the oscillation behavior, likely resulting in it acting differently to gas-powered Wranglers, The 4xe uses the same solid axle front suspension architecture as the gas powered Wrangler, but the hybrid model carries approximately 500-800 lbs of additional mass, much of it located low in the chassis and near the axle line. This added mass increases the effective unsprung and "near unsprung" inertia the suspension must control when the axle encounters a road disturbance. This higher inertia increases the energy transmitted into the track bar, tie rod ends, ball joints, and steering damper, reducing the system's tolerance for even minor compliance, wear, or alignment deviation. It is my belief that the 4xe's additional mass can amplify oscillation behavior after a bump, making the vehicle more susceptible to steering shimmy or 'death wobble' if any component is marginal.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data