This complaint is a follow-up and expansion to existing NHTSA Complaint [redacted] regarding premature, cascading headlamp assembly failures on a 2023 Land Rover Defender X (VIN: [[redacted]]). At approximately 45,300 miles, the driver-side Daytime Running Light (DRL) signature halo suffered an internal electrical failure. To maintain vehicle safety and forward conspicuity, I paid out of pocket to replace the complete driver-side headlamp assembly at Land Rover Austin. Within days of that repair, at 45,319 miles,...
Read the full complaint
the passenger-side original factory headlamp assembly suffered an identical failure. The passenger-side signature halo and position light turned completely dark. Diagnostic scans confirm active hard fault codes stored in the Headlamp Control Module: * HCMB: B10F4-11 (Right front position light, circuit short to ground) * HCMB: B124A-11 (Right Daytime Running Light, circuit short to ground) Photographic documentation of the assembly labels confirms that the failed original passenger unit (build date 04.04.22) and the replacement driver unit (build date 2026-02-13) share identical internal supplier ratings and platform designations (KZ3 04S, POS: 2.7W, DRL: 15.8W). There is no revised hardware countermeasure, and both factory-sealed assemblies suffered catastrophic internal circuit shorts to ground within days of each other at 45,000 miles. Additionally, the dealership released the vehicle following the driver-side replacement with an active fault code: * HCM: B1041-54 (Levelling Control, missing calibration) This uncalibrated state has disabled Auto High Beam Assist and creates a risk of improper beam elevation. Having both forward factory lighting assemblies fail concurrently creates a serious loss of vehicle conspicuity and potential road illumination hazard on a low-mileage vehicle. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)