Certain sport utility vehicles fail to comply with the requirements of federal motor vehicle safety standard no. 210, "Seat belt assembly anchorages." The anchor bolt for the rear, left-hand side seat belt buckle directly behind the driver's seat does not...
Seats & seat belts
Lexus RX330 Seat Belt problems by year
12 complaints filed with NHTSA about the Lexus RX330's seats & seat belts. Seat belts that won't latch or retract, seat frames, seat heaters, recliners and child seat anchors.
Seat Belt complaints by model year
Seat Belt recalls
Latest RX330 seat belt complaints
I was driving with the driver's seat heater turned on. While I were traveling, I noticed that the seat heater was very hot, so I turned it off. I arrived at my destination and parked the vehicle for about two hours. I did not turn the seat heater back on when you returned to the vehicle. I was removing snow from the vehicle with the driver's door open and some of the snow landed on the driver's seat. When I brushed the snow off the seat, I noticed a burn mark in the seat cushion. I called Lexus USA to report this 2...
Read the full complaint
days later and showed my local dealer (Lexus of Portland) and they had never seen this before. Here is the response from Lexus today: "In response to your concerns, a vehicle inspection was conducted by a Lexus Field Technical Specialist (FTS) on January 19, 2022 at Bud Clary Toyota of Yakima. A visual inspection confirmed there was a small 6mm x 7mm burn hole in the driver's seat leather cover on the bottom cushion. The hole was in the outer bolster portion of the bottom cushion. Resistance was checked through the seat warmer grid. The seat back was recorded at .7 ohms and the seat bottom had an open circuit. The seat cover was removed to examine the seat heater grid. Two wires were found near each other at the burn area. One wire was broken at the location. Our FTS disconnected the seat heater switch after the inspection was completed." They left me with now 2 non functioning seat heaters by disconnecting it during a cold winter. They did not offer any sort of assistance or recommendations for next steps, I feel like they hung me out to dry.
The heat control on the driver's side abruptly began to stay on last week. I believe I now smell a chemical odor issuing from the front of the car.
Error message has appeared regarding passenger air bag. Airbag on/off indicator goes on and off when someone is sitting on front passenger seat. Seatbelt warning signal starting ringing when passenger removed seatbelt and exited the car. Stoped when I pressed down on passenger seat.
The key broke into the ignition, dealer refused to assist with repair ot new key even though I hadn't had it very long. The stering wheel locks., The tires shake, cords all falling from under the car, the electrical goes in and out including windows and heat. My seat belts lock on me . This car is a mess and I have two children 11,5 and a senior father that has alzeimers that have to be transported in this lemon faily. The dealers wonmt help they make payment and reapir promises and never keep them, I had been experiencing hardships and they used it against me to justify not repairing the car. Yet these issues have been exisitent since day 1. 11/15/2016
The dashboard is disintegrating. The car has been predominantly kept covered and well maintained. Initially a large piece (credit card size) broke off dash. We repaired with vinyl restoration company, and another area about a year later. Since then, numerous cracks are present - too many to repair. This is not normal wear! *Tr
I started to smell something burning, and my seat warmer light wouldn't turn off. The seat kept getting hotter to the point it was uncomfortably hot. Fortunately, I was only 5 mi away from the dealership when I started to smell the burning. During that time, the plastic under my seat bubbled and was within minutes of catching fire according to the mechanic. The previous morning I drove into boston and was stuck in traffic for and hour and 45 minutes. Had this problem occurred one day earlier, I have no doubt there would have been a fire under my seat. *Tr
Child was restrained in carseat using latches. She grabbed the nearby seatbelt while seated in the rear seat drivers's side. She was not using the seatbelt (it was not buckled) because she was in a latched carseat. She managed to wrap the seatbelt around her neck. When I (parent) attempted to free the seatbelt from around her neck it locked and tightened. I was not able to loosen it enough to remove it because it would not "unlock". The more I attempted to loosen it or "unlock" it the tighter it became and I had no choice but to cut the seatbelt from around my child's neck or she would have choked. The seatbelt will have to be replaced.
We own a 2004 lexus 330. On a trip july 1, 2010, our 6-year old daughter fell asleep in her booster seat and the seatbelt shoulder harness went behind her when she fell to the side. We pulled over on the side of the road to help her get readjusted. We unlatched the buckle; the seat belt was wrapped around her torso and the seatbelt locking system malfunctioned and would not release. My husband and I both worked to try to release her. We tried to extract her through the seatbelt, but it was wound too tightly around...
Read the full complaint
her torso. We tried to retract the seatbelt a bit so the locking system would release; however, the seatbelt kept tightening and locking with each movement until she could barely breathe and the seatbelt was digging into her midsection nearly 3 inches all around. She was literally being crushed to death. Panicked, we searched the car for my husband's swiss army knife, which luckily he had in his luggage. We were parked on the side of the road not near any facility or town - had we not had a knife in the car, the malfunction of the seatbelt locking system would have resulted in a tragedy. We can barely bring ourselves to imagine how a seemingly normal incident of a child getting entangled in their seatbelt could have turned into a fatality. Yet, this would have occurred had we not been able to cut the seatbelt. There is no other manual release available. Our daughter sustained considerable bruising around her sides and back and pain in her abdomen. 6-8 Inch long bruises. We have photos of this. This incident was also severely emotionally distressful for her and us. We found a recall for 2006 lexus vehicles for this failure of the seat belt locking system to disengage. Obviously, this is a problem with other models. We have contacted our lexus dealer and were told the repair is not covered because there is not a recall for this model. We are awaiting response from lexus headquarters on how to obtain the repair/replacement. *Tr
Lexus rear seat over shoulder belt would not release. Belt had somehow wrapped around 11 year old boy that was trying to lie down and we had to cut belt to release child. *Tr
Tl*- the contact owns a 2004 lexus rx330. He stated that the seat belt in the back seat won't release. There was recall #06v023000. The dealer stated that it would take a week to get the part for the recall, but the contact has been waiting four months. He felt the wait was too long. The vehicle currently has 40,000 miles. *Ak
The top latch strap provided on this seat cannot be tightened firmly against the vehicle seat. Rather than provide a (normal) tensioning device for the top strap, the manufacturer elected to provide a dual loop steel plate. The strap is threaded through this plate in a ridiculously complex manner, and no amount of pulling, tugging, or trying to finagle enough slack through the multiple layers the strap goes through (to allow the whole strap to be pulled tightly) allow proper tensioning to secure the child seat back...
Read the full complaint
to the vehicle seat. A few dollars saved in manufacturing cost by providing this plate rather than a tensioning device have resulted in a child seat that cannot be used properly. This is simply incompetent engineering. I returned the seat to wal-mart for a refund, but there may be people who do not have the same options for return, and end up installing the seat in an unsafe and insecure manner. Note that the correct model of seat was not shown in your drop-down menu, so I had to select another model in order to proceed. The seat I'm filing a complaint about is a safety 1st booster seat manufactured by dorel juvenile group. Model # 22-561-wal. Manufactured: p102 b 220565 09/22/06. Thank you. *Nm
1994 Lexus rx330 hesitates while depressing the accelerator. *Kb the vehicle has been taken to the dealer several times to alleviate the problem but they claimed that the vehicle was operating within normal specifications. The vehicle has also been plagued by other malfunctions to include squeaks, rattles, multiple malfunctions of the sunroof electronics, broken seats and liftgate alignment problems. *Nm updated 08/14/06. *Jb
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data