The contact owns a 2017 Lotus Evora. The contact stated that there was a clunking sound coming from the rear suspension. The vehicle was taken to a certified mechanic who was certified to work on Lotus vehicles, but not associated with the dealer, and the rear suspension arm was inspected and diagnosed with a fracture in the casting of the suspension. The suspension arm and bushing were replaced. The manufacturer was informed of the failure. The failure mileage was approximately 69,000.
Suspension
Lotus Evora Suspension problems by year
6 complaints filed with NHTSA about the Lotus Evora's suspension. Broken springs, struts, control arms, ball joints, noises and alignment that won't hold.
Suspension complaints by model year
Latest Evora suspension complaints
UNKOWN , DRIVER REAR UPPER CONTROL ARM BROKEN
Rear upper control arm failure. A crack develops along a casting line, which then allows the upper bushing to move within the control arm. This bushing is pressed into the control arm, and is not supposed to move. Because the hub was allowed to tilt forward due to the bushing not being held firmly by the control arm, the outer CV boot was allowed to contact the lower spring perch, which then burned a hole in the CV boot, allowing all its grease to escape. This scenario can generate an excessive amount of heat and/or wear in that joint, leading to axle failure.
Component that failed: rear upper suspension control arm developed a crack where it connects with the rear wheel knuckle. Other Lotus Evoras have reported this failure, across several model years. Component has not been inspected by others. No warning lamps. Suspension started making a clunking noise.
The rear upper control arm or wishbone developed a crack. The spherical joint in the wishbone started to slide forward and back under braking and acceleration. In my case, it was caught quickly and before there was an accident. However, this wishbone is one leg of a tripod that attaches the wheel to the car. If the crack were to develop into a break, it could cause a catastrophic failure leading to injury or death. Essentially, a rear wheel could fall off. The problem is clearly a pattern failure in these forged...
Read the full complaint
aluminum parts. Some have failed with relatively few miles on them. The failures have been confirmed through discussion on on-line forums Lotus Talk and The Lotus Forum. Evidently, the failed parts have been inspected by Lotus. There is a TSB out on the problem: From S.O.P, NA auto from MY12, see TSB 2011/19 - S/Charged (man & auto). No warning lamps related to this failure. Many owners have heard a clunk. I did not hear anything. I disco verde the failure during a routine inspection.
Rear upper control arm cracked. Very critical safety part. I have had a discussion with other owners and have discovered that several others have had the same issue. Very low milage. 10k miles. Could result in a fatal collision! Found issue during safety inspection. Bushing is now misaligned and control arm is not in the proper location due to the crack. Another crack could result in complete failure and result in a fatal crash.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data