Check a vehicle VIN check Latest recalls Latest complaints Common problems Rankings Compare vehicles Recall roundups All makes Guides Share your experience
Theme

Engine & cooling

Mercedes Benz 420 Engine problems by year

6 complaints filed with NHTSA about the Mercedes Benz 420's engine & cooling. Stalling, loss of power, oil consumption, overheating, head gaskets, timing chains and engine failure.

Engine complaints by model year

YearEngine complaintsCrashesInjuriesRecalls
19952000
19941000
19891000
19872000

Latest 420 engine complaints

1995 Mercedes Benz 420Engine & cooling

There seems to be a problem that mercedes is well aware of with the engine wiring harness. The insulation was poorly done, which causes the wiring to breakdown. This is a very expensive fix for the consumer. Safety is the issue here when this causes the car to fail to accelerate. *Tr

Filed Incident EngineNHTSA 10459977
1995 Mercedes Benz 420Engine & coolingElectrical system

The engine wiring harness on my 1995 mercedes benz s420 has disintegrated. The wiring insulation is cracked and broken in many places, which has resulted in a non-operating condition. The car has stalled 3 times so far, in traffic, and will now not run at all. Apparently the wires have broken down due to the heat of the engine compartment. I believe the wires were not suitable for the application they were used for. *Tr

Filed Incident Engine and engine cooling · Electrical systemNHTSA 10453897
1994 Mercedes Benz 420Engine & cooling

I got 94 e420 benz with defect engine wiring harness. They are cracking. The idle is rough and I got engine code errors. One time the engine failed on the surface street. It was lucky there was no car behind me at that time. My mechanic told me that all mercedes models from 91-96 have this problem. That was so sad that no one has taken action against the factory. *Tr

Filed Incident Engine and engine coolingNHTSA 10189151
1989 Mercedes Benz 420Engine & cooling

Plastic follower apparently ages independent of mileage. Piece on left head breaks off, follows timing chain over cam gear, left head then out of time fails catastophically bending or breaking all valves and sometimes pistons. Engine halts immediately. Process is documented with pictures at web site http://www.Import-car.Com/ic/ic40024.Htm.*Ak

Filed Incident Engine and engine coolingNHTSA 734026
1987 Mercedes Benz 420Engine & cooling

Driving through downtwn at 5 mph, car was filled with steam becausethe hose broke.Consumer notified dealer and manufactur. *Ak

Filed Incident Engine and engine coolingNHTSA 844407
1987 Mercedes Benz 420Engine & cooling

Due to defective design of the radiator, it cracked and caused water to leak. This may have caused the engine to lock up. Common problem. Mercedes benz came with a new design of radiator, and claims that there was not a defect in the old one. *Ak *ml

Filed Incident Engine and engine coolingNHTSA 842651

Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data

Owners helping owners

Know before you drive.

Every experience you share - good or bad - shows on that vehicle's page and helps the next owner and buyer. Two minutes, anonymous.

Share your experience