Certain honeywell fram racing brand hp4 and hp8 oil filters that were manufactured from may 25, 2006, through september 14, 2007, and sold for use as replacement equipment for vehicles list above. The affected filters are marked with a date code a61451...
1977-1994 · 14 model years
Oldsmobile Custom Cruiser Problems by year
Owners have filed 42 complaints about the Oldsmobile Custom Cruiser across 14 model years, and it has 7 recalls. The 1992 has the most complaints once its age is allowed for (17), while 1983, 1993 have far fewer than a typical year. The most reported problem area is the brakes, followed by the seats & seat belts.
- Complaints
- 42
- Recalls
- 7
- Crashes
- 3
- Fires
- 4
- Injuries
- 6
- Deaths
- 1
Custom Cruiser complaints by model year
Highlighted: the year with the most complaints for its age. Older vehicles have had more time to collect complaints - the Safety Index grade allows for that.
Most common Custom Cruiser problems
Oldsmobile Custom Cruiser recalls 7
Vehicle description: passenger vehicles. The antilock brake system (abs) modulator can corrode and leak fluid from the front brake circuit.
The shoulder belt guide loop plastic covering may crack and expose the steel sub-plate.
Secondary hood latch assemblies can corrode, causing a high latch release effort and possibly preventing the hood from latching properly when it is closed.
A small nylon bushing in the cruise control servo bail may slip out of place, causing intermittent and unexpected increases in engine speed or dieseling (engine run on with ignition off).
Manual valve link in the transmission may have been improperly formed.
A child could open the rear side compartment door and enter this compartment. The child could become entrapped if the door were to close, as it cannot be unlatched from the inside.
Latest Custom Cruiser complaints
I have a 1991 oldsmobile custom cruiser (station wagon). For the last two days, vehicle has been "swiggly" when coming to a stop. Not so bad yesterday, noticeably worse today. A stuck front caliper was suspected. However, on the way home from work today vehicle became very unstable while decelerating from approx. 50 Mph. Vehicle was immediately pulled to the side of the road and inspected for a flat tire, etc. No obvious problem was found. Upon attempting to re-enter traffic, the driver side rear lower...
Read the full complaint
control arm bracket was ripped from the rear axle housing causing the tire to hit the front of the wheel well causing body damage. When foot was removed from the accelerator, the tire then slammed into the back of the wheel well causing more body damage, and bringing the car to a screeching halt, luckily still on the side of the road. The drive shaft was also pulled from the transmission and is now wedged tight. Vehicle had to be towed home. Inspection revealed that the bracket that ripped loose had been attached to the axle tube with two short welds, as is done during fixturing, and never fully welded. The other side bracket is fully welded. If this would had happened at speed, the consequences probably would have been deadly as the car would have gone into an uncontrolled skid into opposing traffic. *Nm
1986 Oldsmobile power master ran continuously and leaked brake fluid.*Mr a private mechanic found a recall for the problem and repaired it at no cost to the consumer (1996). Now the vehicle is exhibiting symptoms of the last problem. The consumer contacted the manufacturer and on three occasions they denied him repair under the recall. *Nm the electric power brake booster leaked brake fluid. *Jb
Fuse panel indicates a 30amp fuse for the heater blower. # 7 Slot is indicated in the manual and fuse cover but there is nothing in the slot. Where is the fuse?. *Ak
Passenger's brake line bracket I broke. The dealer doesn't carry the parts anymore. The consumer posed a question: since it was a safety item, was the government responsible to force the manufacturer to supply consumer with parts?*Ak
Hinge failure - driver side and passenger side upper door hinges break away from the body due to poor and/or insufficient welding. Additionally, the hinge plate that mounts to the body has a crack across the center of both hinges. *Nlm
According to the dealer which diagnosed the problem, this type of failure is not commonly seen.
Questions about the Oldsmobile Custom Cruiser
Which Oldsmobile Custom Cruiser years have the most problems?
Which Oldsmobile Custom Cruiser years have the fewest complaints?
What are the most common Oldsmobile Custom Cruiser problems?
Across every model year, owners report problems with the brakes (14), seats & seat belts (9), electrical system (7) most often.
How many recalls does the Oldsmobile Custom Cruiser have?
NHTSA lists 7 recalls across all Oldsmobile Custom Cruiser model years. Each year's page lists the recalls for that year; check your own vehicle by VIN at nhtsa.gov/recalls to see whether the repair has been done.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data