Check a vehicle VIN check Latest recalls Latest complaints Common problems Rankings Compare vehicles Recall roundups All makes Guides Share your experience
Theme

Body, doors & structure

Piaggio FLY 150 Body problems by year

1 complaints filed with NHTSA about the Piaggio FLY 150's body, doors & structure. Doors, hoods and latches, frame rust, sunroofs, leaks, trim and structural failures.

Body complaints by model year

YearBody complaintsCrashesInjuriesRecalls
20141000

Latest FLY 150 body complaints

2014 Piaggio FLY 150Body, doors & structure

The piaggio fly 150 scooter has a design flaw. The rubber buffer that separates the center stand from the engine case in the up position is too big. This cause the center stand to scrape/hit the ground when cornering or travelling over curbs. When the center stand strikes the ground, the pivoting effect could be enough to cause the rear wheel to lose firm contact with the pavement. There are multiple internet forum entries by owners of this scooter that refer to this problem. Most of the forum entries discuss the...

Read the full complaint

owners of the scooters removing the rubber and cutting down to a small size with hacksaws or rasps. The solution is for piaggio to refit the scooters with a smaller piece of rubber. I have tried to contact piaggio customer service many times with emails, however they have not even acknowledged receiving my emails. *Tr

Filed Incident StructureNHTSA 10596396

Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data

Owners helping owners

Know before you drive.

Every experience you share - good or bad - shows on that vehicle's page and helps the next owner and buyer. Two minutes, anonymous.

Share your experience