Check a vehicle VIN check Latest recalls Latest complaints Common problems Rankings Compare vehicles Recall roundups All makes Guides Share your experience
Theme

2010-2012 · 2 model years

Polaris Ranger 800 Problems by year

Owners have filed 5 complaints about the Polaris Ranger 800 across 2 model years, and it has 0 recalls. The 2010 has the most complaints once its age is allowed for (2). The most reported problem area is the seats & seat belts, followed by the fuel system.

Most complaints for its age20102 complaints · 0 recallsSee the 2010
Complaints
5
Recalls
0
Crashes
1
Fires
1
Injuries
1
Deaths
0

Ranger 800 complaints by model year

Highlighted: the year with the most complaints for its age. Older vehicles have had more time to collect complaints - the Safety Index grade allows for that.

YearComplaintsRecallsCrashesFiresTop problemGrade
20123001Seats & seat belts-
20102010Seats & seat belts-

Most common Ranger 800 problems

Latest Ranger 800 complaints

2012 Polaris Ranger 800Seats & seat beltsFuel systemFire

Tl* the contact owns a 2013 (na) polaris ranger 800. While driving 3 mph, the passenger observed that his seat was very hot. The contact was aware of a failure with the seat support because it was hooked to the heat shield that was located above the exhaust. The contact previously notified the manufacturer and was referred to the local dealer (weekender sports, 141 w bridge s, hotchkiss, co 81419) where they suggested another seat; however, that seat was in worse condition, so the contact declined. In order to...

Read the full complaint

prevent the seat from melting and obtaining heat, the contact placed a piece of aluminum underneath the seat and in between a piece of wood; however, the attempt failed. Due to the weight of the passenger, the plastic melted more and burned a hole in the seat. The pressure from the body weight also placed a hole in the fuel line. The vehicle was taken to the dealer where they confirmed the hole in the fuel line and stated that it needed to be replaced along with the seats. The manufacturer was made aware of the failures and provided case number: c4162165. The contact was informed to consider the repair cost and that it would take 4-6 weeks. Two weeks later, the engineer from the manufacturer stated that, after review, their engineering was not the reason for the failure and they would replace the parts as a good will gesture; however, the contact would be responsible for the labor cost. The vehicle was not repaired. The failure mileage was 8,000.

Filed Incident Seats · Fuel / propulsion systemNHTSA 11012553
2012 Polaris Ranger 800Body, doors & structureSeats & seat belts

Rear seat on passenger side melted onto a frame cross member near the engine exhaust system. Incident was reported to polaris corporate via email. Response has not been provided. This could have caused a fire had the plastic seat bottom ignited resulting in personal injury or total loss of the vehicle. *Tr

Filed Incident Structure · SeatsNHTSA 10639472
2012 Polaris Ranger 800Seats & seat beltsEngine & coolingFuel system

Ten months after purchase of the vehicle the engine began using excessive amounts of oil; running bad after warm-up with misfiring, would not idle correctly; engine 'stalling-out' during operation and dying; engine hard to start which resulted in 'slack' in components; middle of back-seat got too hot for anyone to sit on the seat for very long resulting in slight burn to back of leg and/or discomfort caused from excessive heat rising-up from motor underneath seat which could have resulted in a fire/serious...

Read the full complaint

safety hazard; big gush of air out of system when hook up fuel pressure gauge/fuel-line vapor lock caused by excessive heat in engine, recommended fuel for this vehicle by dealership was mid-grade gasoline (u.S. 87-93 Aki octane rating). Polaris technicians asked if operator using non-ethanol gasoline (if available, which it is not in our remote area of the country), they went on to say "...With poor grade or old fuel the fuel could boil or vaporize once there is a good heat soak in the engine and engine compartment resulting in a vapor lock issue, the vapors will replace fuel in the rail and will work its way back towards the fuel tank'. Tech swapped out iac (idle air control) valve & tps (throttle position sensor) sensor; reflashed vehicle, performed 'leak-down test' losing 18% on mag (magneto/right piston) side/14% on pto (power take off) side; vehicle installed with new fuel pump. Tech tried new coil & replaced complete set of fuel injectors and wires; vehicle installed with another new fuel pump, reflashed ecu (electronic control unit)to 58 p.S.I., Top-end rebuilt, vehicle still idling erratic from 1250 to 1850 rpm; replaced bad tps with new one, still idles erratic. Set tps to .40, Then .43 Idle erratic, then .46, Then .40 . Replaced throttle body vehicle doesn't run with tps set at .46 Like it is suppose to according to the service manual. *Tr

Filed Incident Seats · Engine · Fuel / propulsion systemNHTSA 10524789
2010 Polaris Ranger 800Acceleration & cruise controlCrash1 injury

The throttle cable stuck wide open on my 2010 polaris razer. My son was starting it and when he put it in gear , the throttle cable stuck wide open when he pushed on the gas pedal. He was unable to brake and get it to stop. The machine traveled about 30 feet before he crashed through the rear garage door. He continued through the garage and smashed into a car that was parked in the driveway. The machine was spun sideways . My son jumped out of it and the machine continued to spin tires at full throttle. I was...

Read the full complaint

finally able to reach in and turn key off. Had my son not hit the car in the driveway, I believe he would have continued across the street at about 45 mph and would have run through the neighbors house, possibly could have been a fatal incident. The dealer sent a mechanic to my residence. They started the machine two different times in neutral and the throttle revved up again. I believe this is a safety concern for whoever purchases a polaris rzr 800. I have read several articles online from consumers who have had the same problem. Thankfully my son only suffered a bump on his chin from the steering wheel as a result of smashing into the car. I believe there needs to be recall on this machine to ensure that this does not continue to happen. I can only imagine what could happen if someone was on a steep mountain trail and the throttle sent someone over the edge. Someone is going to get seriously injured or killed if this problem is not addressed. *Tr

Filed Incident Vehicle speed control · Unknown or otherNHTSA 10370285
2010 Polaris Ranger 800Seats & seat belts

This vehicle is a four wheel drive, mid-engine, off-highway vehicle. The seat base is connected to the frame by way of two plastic, mushroom shaped, prongs along the front edge of the seat and two tabs along the rear edge of the seat. There is one prong and one tab on both the left and right sides of the seat. The tabs fit into slots on the frame at the rear, and the prongs are pushed down into holes with retaining clamps, thereby securing the seat to the frame. In older models, the prongs were metal and...

Read the full complaint

affixed to the seat base. In this model, the prongs are part of the molded plastic seat base. The engine is located under the seat. The heat produced by the engine softened the plastic prongs, allowing them to flex, crack, and break off of the seat base. This allows the seat base to come loose from the frame and slide forward. The rear tabs pop out of the slots in the frame, rendering the seat base unsecured from the frame. The seat is unstable and interferes with the driver's ability to control the vehicle. When the seat slides forward, it opens a gap between the seat and the engine compartment, exposing the driver and/or passenger directly to the engine heat. This has happened on two separate occasions. The first time, I was negotiating a steep, downhill trail in very rough terrain. All of my weight, and the weight of my passenger were on the front edge of the seat. When the seat broke loose and became unstable, I had difficulty controlling the vehicle due to my having to use my legs to keep my body from sliding forward. The first defective seat was replaced under warranty. The replacement seat also failed in a similar manner, while again coming down a steep trail on february 12, 2010 at 1433 miles. The manufacturer subsequently denied the second warranty claim.

Filed Incident SeatsNHTSA 10368731

Questions about the Polaris Ranger 800

Which Polaris Ranger 800 years have the most problems?

By the number of complaints owners filed with NHTSA: 2012 (3), 2010 (2). Allowing for how long each has been on the road, the 2010 stands out most. Complaint counts also rise with sales, so compare years of the same model rather than different models.

What are the most common Polaris Ranger 800 problems?

Across every model year, owners report problems with the seats & seat belts (4), fuel system (2), acceleration & cruise control (1) most often.

How many recalls does the Polaris Ranger 800 have?

NHTSA lists no recalls for any Polaris Ranger 800 model year on file.

Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data

Owners helping owners

Know before you drive.

Every experience you share - good or bad - shows on that vehicle's page and helps the next owner and buyer. Two minutes, anonymous.

Share your experience