Rivian Automotive, LLC (Rivian) is recalling certain 2022-2025 R1S and R1T vehicles that previously had service performed. The toe link may have been reassembled incorrectly during service procedures performed before March 10, 2025.
Suspension
Rivian R1S Suspension problems by year
15 complaints filed with NHTSA about the Rivian R1S's suspension. Broken springs, struts, control arms, ball joints, noises and alignment that won't hold.
Suspension complaints by model year
Suspension recalls
Rivian Automotive, LLC (Rivian) is recalling certain 2022 R1T, R1S, and EDV vehicles. The fastener connecting the front upper control arm and steering knuckle may have been improperly tightened.
Latest R1S suspension complaints
At 56,083 miles, my 2024 Rivian R1S experienced a suspension warning while driving on the US-101 Freeway and entered reduced-performance/turtle mode, limiting the vehicle to approximately 50 MPH while surrounding traffic was traveling substantially faster. The sudden speed differential created a serious highway collision risk. Rivian inspected the vehicle and diagnosed fault P12DF7A, "Roll Control Cross Circuit Static Leakage Check Failure." The technician repeated the hydraulic leakage test to rule out a false...
Read the full complaint
positive. After draining the hydraulic fluid, Rivian found metal debris throughout the system and documented that it was causing system contamination. Rivian separately confirmed in writing that the source was an "internal mechanical failure in the system." Rivian Repair Invoice INV_20260811-204135.pdf Rivian determined that the contaminated system required replacement of the hydraulic suspension manifold, hydraulic pump and all four dampers. Its repair procedure requires all four dampers to be replaced when metal debris contaminates the system. Rivian - Metal Debris Email.pdf Critically, Rivian advised me that even if turtle mode did not immediately recur, recurrence was "inevitable in the future" because of the metal debris and stated: "For your safety, we strongly advise against driving the vehicle in this condition prior to completing the full repair." Rivian - Metal Debris Email.pdf I previously reported excessive suspension clicking to Rivian at approximately 44,000 miles while under warranty. I am aware of at least two potentially similar R1 failures, including another involving reported metal fragments and turtle mode. I request NHTSA investigate whether an internal mechanical failure can introduce metal debris into the interconnected R1 hydraulic suspension system, contaminate multiple components and cause reduced-performance mode at highway speed, and whether similar R1S/R1T incidents indicate a broader safety defect.
I own a 2023 Rivian R1S, early production vehicle #531, with approximately 93,000 miles. While driving, I noticed the vehicle's suspension was not functioning normally. After parking, the front passenger side of the vehicle dropped significantly lower than the other side, leaving the vehicle visibly uneven. I also received suspension warnings indicating that the suspension system was too hot and needed to cool. I brought the vehicle to a Rivian Service Center. Rivian diagnosed a failed/leaking damper and a failed...
Read the full complaint
air compressor. I was informed that only one damper had failed, but that all four dampers must be replaced because Rivian changed the manufacturer of the dampers and the replacement components are not compatible with the original dampers installed on my vehicle. The estimated repair cost is approximately $8,000. I am concerned that this may represent a safety-related failure of the early-generation R1S suspension system rather than normal wear. The suspension failure resulted in a substantial and visible change in the vehicle's ride height and occurred after I had experienced suspension behavior changing while driving. I have also found reports from other Gen 1 Rivian owners describing leaking hydraulic dampers, damper failures, suspension sag or collapse, multiple damper replacements, and air-compressor failures. Some owners report Rivian replacing their original dampers with subsequently revised components. I am particularly concerned that Rivian has informed me that the original dampers on my vehicle can no longer be replaced individually because the damper manufacturer/component has changed. Although only one damper on my vehicle failed, Rivian states that all four must now be replaced. I am submitting this complaint because a suspension failure that causes a significant unexpected change in vehicle ride height may affect vehicle handling and safety, and I believe NHTSA should determine whether similar failures are occurring in other early-product
Tension noise and creaking coming from suspensions. Special washers were needed in order to fill gaps in build tolerances.
Right rear toe link to knuckle bolt snapped off while driving causing a deadly situation.
Recurring front suspension fastener and component failures causing severe asymmetric inner-shoulder tire wear and steering vibration. Vibration was reported to the manufacturer's service center from delivery (Feb 2024) and repeatedly called "normal." Jan 2025: front left hub bearing and halfshaft replaced under warranty after metal-on-metal grinding. Oct 2025: torn right front lower control arm bushing replaced under warranty; rack measurements before that repair showed front total toe 2.04 deg (spec 0.00-0.40) and...
Read the full complaint
rear camber -2.2 deg (spec -0.6 to -1.4); two tires worn to the wear bars on inner ribs were replaced. Mar 2026: vehicle towed in (parking brake would not release, 12v battery failed); technician found front suspension fasteners not torqued to specification, including previously replaced components, and replaced the front left hub a second time. No alignment was performed after the re-torque. Jun 2026: the Oct 2025 tires are again worn to near the wear bars on inner shoulders after ~12,000 miles - the third consecutive set destroyed by the same geometry-driven pattern. The manufacturer has confirmed in writing that only one alignment has ever been performed on this vehicle (Oct 2025) in 26 months and ~41,000 miles - none after the March 2026 suspension re-torque. The manufacturer has two federal recalls acknowledging suspension fasteners loosening after assembly or service: 22V-748 (under-torqued front fasteners that "could cause excessive wheel camber") and 26V003 (rear toe links that may separate), the latter reopened by NHTSA in May 2026 under PE26-004 with review expanded to ~114,922 vehicles. This vehicle exhibits the same failure mode - fasteners confirmed loose by the manufacturer's own technician - but is not in either recall population. Tires worn to the belts and loose suspension hardware at highway speed create a risk of loss of control. Work orders, the alignment report, and photos are available upon request.
While driving at city speeds, I heard a rubbing/grinding noise from the right rear of the vehicle and noticed that the suspension no longer felt normal. After stopping to inspect the vehicle, I found that the right rear wheel had shifted rearward within the wheel opening and was contacting the wheel liner. The condition appeared suddenly without prior warning messages or warning lights. I do not recall any curb strike, pothole impact, collision, off-road event, or other significant impact prior to the failure. ...
Read the full complaint
The vehicle was towed to a manufacturer service center and inspected. The manufacturer determined the damage was impact-related and not covered under warranty. Recommended repairs include replacement of the right rear knuckle, upper longitudinal link, toe link, hub bearing, and halfshaft. The failure resulted in a significant change in rear suspension geometry and raised concerns about vehicle safety. The damaged components are currently in the possession of the manufacturer service center and may be available for inspection.
I am submitting this complaint after learning through a recent TechCrunch article regarding the NHTSA investigation PE26004 into Rivian rear suspension / rear toe link failures that my incident appears substantially similar to the failures currently under investigation. On March 2, 2024, at approximately 1:29 AM, my son [[redacted]] was driving my 2023 Rivian R1S (VIN [[redacted]] ) in [[redacted]] . While making a normal right turn from [[redacted]] onto [[redacted]] and accelerating normally afterward at...
Read the full complaint
approximately 30 mph, the vehicle suddenly suffered what appeared to be a catastrophic rear suspension failure. According to the driver, the left rear portion of the vehicle suddenly jolted downward, a loud mechanical breaking sound was heard, and the vehicle immediately became uncontrollable. The rear suspension appeared to collapse instantly. The vehicle then began sliding uncontrollably across the roadway and crossed into the opposite traffic lane. The driver attempted to release the accelerator and correct steering input, but the vehicle did not respond normally. Steering control was effectively lost and the vehicle could not be controlled. The vehicle ultimately impacted a tree on the left rear/driver-side rear area before coming to rest perpendicular to the roadway. Importantly, the loss of control occurred BEFORE impact with the tree. The impact was a consequence of the apparent suspension failure and resulting loss of vehicle control, not the initiating cause of the event. There was no rain and road conditions were normal and dry. Driver-side airbags deployed and Rivian's emergency response system automatically contacted the occupants after the crash. Police responded to the scene within minutes and a traffic crash report was generated. The vehicle had approximately 7,862 miles at the time of the incident and remained under factory warranty. The vehicle had never undergone any prior suspension repair, suspension service, or suspension INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
Toe link failed on the driver rear side. My vehicle went out of control, veered over adjacent lanes, over the bike path, onto the side walk and back onto the road and side walk. I was left with a sore neck for several days, my apple watch kept trying to call 911 thinking I was in an accident. Anyone one the sidewalk or bike lane or adjacent vehicle lane would have been impacted. The problem has an outstanding recall with Rivian but my vehicle isn't part of the recall. Rivian is repairing the broken components. ...
Read the full complaint
No warning lamps, messages, or other symptoms before the failure. I was traveling at ~50MPH through and intersection when as soon as I exited the intersection the vehicle turned to the right / banked to the right in an aggressive manner which I could not control. I went across and adjacent lane that was unoccupied sideways and onto the sidewalk then back onto the road.
On [[redacted]], I was driving my Rivian R1S on [[redacted]] in the far left lane at highway speed on a smooth, straight road when I suddenly and completely lost control of the vehicle without warning. The vehicle swerved right, struck a vehicle in the middle lane, then veered left, spun, and collided head-on with the guardrail on the right side of the road. I was evaluated at the scene by EMT. There were no warning lamps, messages, or any symptoms of any kind prior to the failure. The loss of control was...
Read the full complaint
instantaneous and without any prior indication of a problem. Review of video footage captured by the vehicle's own cameras clearly shows the rear driver-side toe link failing and the rear wheel moving in a manner inconsistent with normal operation immediately prior to loss of control. At the scene, the rear driver-side wheel was visibly sitting at an abnormal angle, inconsistent with normal alignment, and the toe link bolt was visibly absent from its mounting location. The vehicle is currently being preserved as evidence and is available for inspection. The mounting location where the toe link bolt should be seated is visible and available for examination. The vehicle has not yet been inspected by Rivian, a dealer, or any independent service center. I am aware that Rivian issued NHTSA recall 26V003 on January 8, 2026, covering 2022-2025 R1T and R1S vehicles for this exact defect - rear toe link joint separation while driving, which increases the risk of a crash without prior warning. Rivian acknowledged awareness of at least one prior crash related to this defect prior to the recall filing. My vehicle has no open recalls on record and I was never notified of recall 26V003 or any related service campaign. This incident resulted in a multi-vehicle accident on a public highway. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
When vehicle returned from service for outstanding recalls, the control arm bolt was not properly tightened and caused additional movement on rear of vehicle
clunking/thumping noise coming from front end over speed bumps like something is loose or going to fall apart. have taken car into service few times and was told its normal, its getting worse. Online forum threads have mentioned same issue , I am afraid one of these days something going to snap and cause a breakdown or even worse terrible accident.
Front driver wheel had a hub bolt back out rendering the vehicle unable to drive. The car made a loud grinding noise and was unsteady. I had to pull over and was unable to drive any further. It required replacement of the hub bolt and axel. This is a known problem for rivian's and has not been addressed or checked. I reported a grinding sound when I turn 2 months ago and was told that the soonest Rivian could service my car was 2 months away. This known problem and complaint should have flaggged an immediate intervention and this needs a recall.
I own a R1S and the vehicle is less than 900miles old (21st day of ownership). When driving today on the highway at 75miles - the vehicle suddenly decelerated to 51 miles. I almost got rear ended by a truck and was very difficult to manoeuvre to safe place from the left lane to the right most lane. I parked in a safe spot and saw through several customer Complaint forums that we need to do a hard reset. But the messages were from customers that are 3 years old. I am surprised this still exists as a complaint. I almost died today
Rivian has a 'kneel' option that uses the powered air suspension to lower the vehicle to make entry and exiting the vehicle easier for users. Yes, this can be turned off or on. When on, the function stops if a main door (driver/passenger) is open and left open the car will not continue to kneel for safety purposes. However, it does NOT stop if you are using the rear hatch to access anything. The car continues to kneel. I have hit my head multiple times on the rear hatch because I am behind the vehicle and...
Read the full complaint
assume a certain amount of head room and the car is still kneeling and I do not realize it and stand up like I was and hit my head. I have notified Rivian and asked for updates. I consider this a critical issue and has caused minor injury or confusion momentarily. I live on a busy street and the last thing I need is to hit my head and be knocked out. I have not heard anything from Rivian on my request and an update came out to 'fix' items but this was not included. I advised if it was not I would file an official complaint to make them take security and safety issues seriously.
Immediately after purchasing the vehicle, I got error codes thrown to service the suspension while driving to my house, specifically at 15-20mph over traffic calming bumps. This fault cleared immediately the first few times. On July 25 I submitted a service request as my family headed out on a two week, 900 mile trip. The service suspension fault had returned and disabled my ability to change modes/ride heights, blind spot sensors and cruise control, all of which I was counting on using during trip. I shut off...
Read the full complaint
and restarted the vehicle several times trying to clear the fault and regain functionality, but the fault inevitably returned. On July 25, Rivian added a response in the service portal that they would address the problem by July 28th. I heard nothing more. On August 1, I was driving south on HWY 57 in North Idaho. I hoped that code would have cleared, but it came back on almost immediately. After driving for about 5 miles, I decided to pull over at a visitor center parking lot to try and reset again to change modes, regain safety sensors, and cruise control. While turning left into the parking lot, another driver tried to pass on my left on a double yellow line driving above the 55mph speed limit. He collided with the front left part of my vehicle, damaging the body and breaking the front tie rod ends, leaving me unable to steer or drive forward, disabled, in the oncoming traffic lane. I asked Rivian to share data about the turn signal use, brake light, and speed data at the time of the accident with me. They did not respond in writing, but called and refused, getting quite angry during the call. After researching and observing other Rivians, I don't believe that my brake lights were on during regenerative braking. The rear, side, and blind spot sensors were disabled. Turning 1/4 second sooner or 5º sharper would have killed me.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data