Tl* the contact owns a 2007 saab 9-3. The contact received notification of nhtsa campaign number: 16v063000 (latches/locks/linkages). The part to do the repair was unavailable. The contact stated that the manufacturer exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. Vin tool confirms parts not available.
Body, doors & structure
Saab 9-3 Wagon Body problems by year
10 complaints filed with NHTSA about the Saab 9-3 Wagon's body, doors & structure. Doors, hoods and latches, frame rust, sunroofs, leaks, trim and structural failures.
Body complaints by model year
Latest 9-3 Wagon body complaints
The rear side door window has had all of the following issues, which led up to its current state - the window is inoperative. I have not had it repaired because it is likely to re-occur, due to poor fit, and faulty alignment. ' Window rattles or squeaks. ' Window binds. ' Window has slow operation. ' Window fits poorly or is misaligned. Currently, rear driver side window inoperable, and fits the following gm communication (nhtsa id number: 10054243 manufacturer communication number: pi-0018-b general...
Read the full complaint
motors: the windows, front and rear, would bind, poor fit, misalignment, makes rattle or squeaking noises, moves slowly and is inoperative. Model 2008-2014 vehicles and trucks. Is there a recall for this defect?
My hood release( what I pull to pop the hood inside of the car) broke 14 months ago and I had the old saab dealer fix it. You would pull it and nothing would happen. About a month ago the same thing happened. The hood would remain in the completely shut position. On 3-14-15 I was driving 40 miles per hour and the hood flew up and smashed into the windshield. Thank goodness I was not on the highway and there were no cars close by. If this happened on the highway I hate to think what could have happened. It is a very serious issue and clearly there is a manufacturing defect in the hood release mechanism. The hood is unsalvageble as it is so bent. *Tr
Tl* the contact owns a 2008 saab 9-3. While driving approximately 35 mph, the hood inadvertently unlatched and flew up. The contact merged the vehicle over and managed to tuck the strut in and force the primary latch to secure the hood. An independent mechanic stated that the secondary hood latch striker failed due to corrosion. The vehicle was not repaired. The manufacturer was notified of the failure. The approximate failure mileage was 55,000.
Tl* the contact owns a 2008 saab 9-3. The contact stated that he entered the vehicle and noticed that the floor mat holder was fractured. The vehicle was not taken to the dealer for inspection. The vehicle was not repaired. The manufacturer was not notified of the failure. The failure mileage was 33,786.
On august 27, 2012, while shopping in the mall, I came out side to the fire department putting a fire out that looks to have occurred while I was in the store. I don't understand how the care caught fire while it was parked. When I got out of the car it seemed to be fine. The fire marshall report side that it was an electrical fire that started because a defect from the manufacturer. *Tr
I have a 2007 saab 9-3. It has a plastic cover/protector under the dash over the pedals. The problem is that my feet constantly get caught by this protector which limits my ability to press on the pedal, especially the brake as my foot may get caught. Similarly I have encountered issues where I cannot release the brake or accelerator for the same reason. There is also a connector there which looks like the connector to connect to the car ecu. This connector sticks out below other points and causes the most...
Read the full complaint
interference. It is thin so it is only a problem at certain times, but when it gets in the way it can severely impede my foot. My shoes are not very large at all at a men's size 9, but I keep hitting the cover and connector on my saab. I am posting this after the toyota recalls, since I feel that this can have a similarly dangerous effect on my driving. *Tr
Tl*the contact owns a 2008 saab 9-3 convertible. While driving at an unknown speed, the contact noticed a gap between the roof and the vehicle. He drove the vehicle to the dealer and they stated that the roof of the 2008 saabs were redesigned. Two attempts were made to repair the vehicle. The manufacturer stated that the vehicle was still under warranty and nothing else could be done. The vehicle has not been repaired. The current mileage was 7,500 and failure mileage was 400.
2007 Saab 9-3 4 door does not allow an infant car seat to be installed. The backseat is too short to allow the infant car seat to be installed . I have contacted baby seat companies and the are all the similar length, my concern is how can a new family car known for safety be allowed on the road and a 4 door not allow me to bring my infant child back from the hospital? Why have latches and all the other safety features if one can not fit a infant car seat rear facing? If one spends over 30,000 for a new vehicle I expect to be able to bring a new born child home from the hospital. I called saab and they could not give me an answer. There should be a re-call. *Tr
Unsafe to know that my new car has door locks that do not unlock from within the car cabin when the door handle is pulled. Unlike my previous car (vw) whereby the door is unlocked when the driver door (for example) is pulled - door opens or my bmw whereby the door is unlocked by pulling the handle twice. In a saab, the doors can not be opened unless the "unlock" button is pressed. This is a safety issue since egress can not be done quickly in the event of an accident or other emergency need for immediate egress. *Tr
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data