During static testing of belt anchorage points, the outboard attachment plate being used in the testing deformed and detached from the seat anchorage. This does not comply with fmvss no. 209, "Seat belt assemblies" and no. 210, "Seat belt assembly anchorages."
Seats & seat belts
Saab 900 Seat Belt problems by year
32 complaints filed with NHTSA about the Saab 900's seats & seat belts. Seat belts that won't latch or retract, seat frames, seat heaters, recliners and child seat anchors.
Seat Belt complaints by model year
Seat Belt recalls
One or more of the arc welds can be missing on the seat back frame recliner.
Two trigger springs mounted to the fore/aft adjustment lever do not develop sufficient force to properly lock the seat rails. After the seat is adjusted, this does not allow the seat rail lock to properly engage, which can cause the seat to move in a sudden...
A weld in the seat rails was not made, increasing the risk of fatigue cracks forming around the attachment bushings on the height adjustment mechanism, causing the possibility of the height adjuster breaking in a rear end collision and allowing the seat to...
There may be an insufficient permanent lubrication in the buckle/release mechanism of the type 2 seat belt assemblies. This may cause front seat occupants to have difficulty in fully fastening seat belts, although they may seem to be fully fastened.
Latest 900 seat belt complaints
I went to put my seat belt on and it caught on something and wouldn't let me extract the belt from the retractor. This vehicle registration is not-operative. *Tr
Tl* the contact owns a 1994 saab 900. The contact stated that the front driver's seat was cracked and had a damaged frame that was deteriorating. The seat was not secured and would move independently. The front passenger seat also exhibited the failure. The srs sensor and the service engine sensor illuminated for an extended period of time. The vehicle was taken to an authorized dealer but the dealer was unable to reset the codes. The contact referenced nhtsa campaign id number: 94v226000 (seats) however, the...
Read the full complaint
vehicle was not included in the recall campaign. The vehicle was to be inspected and repaired by an authorized dealer. The manufacturer was notified of the failure. The approximate failure mileage was 22,601 and current mileage was 143,100.
Tl* the contact owns a 1995 saab 900s. The contact heard an abnormal noise from the seat belt and immediately, the seat belt failed to restrain the contact. The dealer advised that the seat belt retractor assembly had failed and would need to be replaced. The vehicle was not repaired. The manufacturer was not contacted. The failure mileage was 160,785 and the current mileage was 161,292. Updated 11/03/10 *bf updated 11/04/10*jb
Dt*: the contact stated while stopped at a traffic signal both the front air bags deployed without warning. The vehicle was towed to the dealer who determined the control module shorted causing the deployment. The dealer determined the control module, air bags, and seatbelts needed to be replaced.
During an extremely hard stop and swerve to avoid a vehicle pulling out of it's lane, the front passenger seatbelt popped out of its harness and the pasenger was propelled in to the dash.The seatbelt was properly secured, and afterwards we were unable ot duplicate the problem by pulling hard on the seatbelt.
The experience leaking head gasket repeated problem. The engine overheating and brake problems. *Bf the brakes squealed when stopping, the windshield wipers, the passenger door was hard to close, the battery light had run bad, the heat operation was inoperative, there was an oil leak, seat cover left lower cracked, fluid leaked under the vehicle/overnight coolant leak, over heating while the vehicle was in motion, the turn signal assembly, leaking distributor seal, broken turn signal, at a certain position the...
Read the full complaint
seat would not operate forward, the antenna would not properly retract, left fog light inoperable, driver side window front and rear for proper rubber alignment, leaking crank pulley seal, oil leak from the transmission, found a lack of fuel pressure, smoke was coming out of the tailpipe, the convertible top was wearing on the left and right side, there was a loose hose clamp in the power steering hose, the battery failed, one tail light was inoperative, the alternator belt was wrapped around the chassis, there was a squealing noise after start up, oil leaked through the valve cover, and the tank clutch leaked fluid. *Sc
While driving 10 mph the vehicles passengers air bag deployed inadvertently. The driver exited the vehicle to let the smoke clear. When the consumer got back into the vehicle and drove about 40 yards the drivers air bag deployed. The seat belts also locked . *Ak *nlm
Seat back on both front seats have failed. Reclining mechanisim does not return the seat backs to the correct position. The position of the seat back impairs the drivers ability to operate the vehicle correctly. I have located two cables on both seats that have snapped and are the cause. These are permante pieces that require seat replacement. I consider them a manufacturing defect.
Right side passive seatbelt system failed motor caused shoulder belt key to go back and forth . Driver side did the same. Repair tech said that it was a short in the system and that it was commom with saabs with this type of safety belts. Cost of repair would be $650 did not repair had tech lock key in a fixed position.*Ak
While trying to put seat belt on, seat belt would not extend. Belts needed to be replaced. *Ak dealer replaced belt and retractor. *Slc
This is important: the rt pass seat belt did not hold my wife in a head on crash, and somebody removed the car from salvage yard quickly, inc co and yard owner did not know who took it before investigation could be made on belt failure..Suspect saab had it picked up in 7 days after accident...Wonder if this is a pattern where thay tried to hide wreck from investigation?
Vehicle has been at dealer since october waiting for a part to come in to fix power adjusting seat. Dealer said there was a nationwide need for the part. Original manufacturer was retooling the part to supply saab manufacturer. Electric motor on both sides malfunctioned. Cables malfunctioned so they couldn't be moved. It was required and needed to be a convertible.*Ak *slc
Driver's seat anchoring bracket which attaches to seat base broke away from the attachment bolt. Odometer became inoperable and this seems to be the case on most pre-1990 models as stated by mechanic who specializes in saab repairs. Mechanic states that this issue involves the gearing mechanism within the odometer.
While driving about 55 mph, the electric seat on the driver's side started moving to the rear. This happened five times before driver arrived at home, and was causing the driver's feet to be pulled away from the pedals. *Ml
Motorized seat belts are defective. Sometimes they don't engage, sometimes they don't release. This is a serious safety issue, and I feel the manufacturer should be responsible for the repairs. *Ak.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data