Broken welds holding the tips of both sides of the swing arm of my 2002 suzuki dl1000 motorcycle. Had I not seen them in time, the entire rear wheel would have fallen off during riding. Dealer and suzuki of america said it was out of warranty and took no action. (If a wheel falls off because of bad welding... Isn't that a very serious event worth looking into?) There was no prior damage. *Tr
Suspension
Suzuki DL1000 Suspension problems by year
3 complaints filed with NHTSA about the Suzuki DL1000's suspension. Broken springs, struts, control arms, ball joints, noises and alignment that won't hold.
Suspension complaints by model year
Latest DL1000 suspension complaints
I own a motorcycle with a well-documented problem of shuddering badly between 3,000 and 3,800 rpm. Last month I was horrified to discover that 4 of the 5 welds holding my swing-arm axle-mounting bracket were completely cracked. The crack is on the chain-drive side, next to the sprocket. Had I not discovered this it would have broke, causing complete loss of control and serious injury or death. The swing-arm is aluminum, and I believe this failed as a result of the long-term shuddering problem. The bike was...
Read the full complaint
ridden only on the street, stored indoors, looks like new. This problem is well documented in magazine articles and blogs. Suzuki replaced the broken swing-arm but refused to fix the shuddering problem. After discovering the crack welds the dealer recommended replacing the drive chain. New tires and a new drive chain were installed, neither eliminated or helped reduce the shuddering problem. This bike was redesigned in 2003 to eliminate this problem, so suzuki has a fix. I am convinced this motorcycle is unsafe and will seriously injure or kill me or the next owner. I have many pictures of the cracked swing-arm and copies of the magazine article and blogs. Suzuki claims the shuttering can not cause this problem, however, they have failed to produce any explanation for this failure. I have owned over 100 motorcycles in my life, and this is the only motorcycle that experienced cracked swing-arm welds. *Tr
Re: 2007 suzuki dl1000 v-strom 1000 motorcycle fall-over incident while stopped for a red light, I attempted to put my left foot on the pavement. The boot lace on my left boot snagged on the exposed air bleeder valve on the clutch release cylinder next to my boot and just above the gear shift lever, causing the motorcycle to fall to the pavement on its left side. I suffered injuries to my left wrist and upper left back. The motorcycle suffered a broken gear shift lever, a broken left front turn signal, and other...
Read the full complaint
minor scrapes and scratches. I notified american suzuki corp. In writing of what I believe to be a serious design defect, with the uncovered and unprotected air bleeder valve next to the rider's boot, and sent photos of the incident; however, bryan malyszek from american suzuki called me on 4/30/07 and disavowed any american suzuki responsibility for the incident. *Tr
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data