I bought this car used august of 2002. I am now replacing the master cylinder for time #3. I know from the last 2 times the slave cylinder and clutch will also need to be done. This is absolutley horrid. My first replacements were 1/03 cylinders #1 and clutch #1, second time the repairs needed to be done in september, however due to an out of state move they were not done until 12/03 cylinders #2 and 1/04 clutch #2. I am at my wits end about this. I see other people have complained about multiple power train/clutch problems and replacements. My question is this: is suzuki liable with so many complaints about the same problem?*Ak
Brakes
Suzuki Sidekick Brake problems by year
21 complaints filed with NHTSA about the Suzuki Sidekick's brakes. Spongy or hard pedal, ABS faults, brake failure, noises, parking brake and brake fluid leaks.
Brake complaints by model year
Latest Sidekick brake complaints
The master cylinder is defective. The brakes drag intermitently, and the mechanic has told me that the "check valve" inside the master cylinder is failing to release when I take my foot off of the brake pedal. When the check valve fails to release, the brakes drag, and if I need to stop, the brake pedal is very hard to push. This has happened to two rebuilt master cylinders, and also to a new replacement master cylinder from suzuki.*Ak
Brake master cylinder exploded. Vehicle has been repaired. Please provide further details. *Ak
Axle seal failed, caused brake shoes to rotate and lock rr wheel. *Ak
While drivin gon highway car lost control. Car would not steer or brake going across the road. Then it slowed down and stopped. Took to dealer and they said that brake housing differential cracked. *Ak
Braking performance is severly diminished, only partial braking power is being used. Dealer contacted, and stated a normal wear pattern and cannot duplicate the problem. *Ak
While driving the vehicle various miles occupant began to step on the brake the pedal went all the way to the floor, still going the same rate of speed. Occupant has to use the emergency brake to stop the car. Dealer and manufacturer have been notified and confirmed the problem. *Ak
Brake malfunction. Grinding noise and poor performance, usually in wet, cool weahter. Noise seems to come from rear of vehicle.
Pulley assembly plate design was not thick enough for amount of pressure received, resulting in pully to be broken away from engine block damaging components within engine compartment.
Consumer was driving at approximately 45 mph when vehicle began to deaccelerate at approximatley 25 mph. Defect within brakes caused smoke and brakes to lock up, resulting in possible loss of vehicle control. Dealer has replaced rotors/calpirs and brakes. *Ak
COMPLETE FAILURE OF INBOARD PADS EVERY 15,000 MILES.
The front brake pads have gone out completely at 30000 miles, causing rotors to be damaged, thereby requiring the replacement of front pads and rotors. *Ak
Intermittently, when slamming the door close or any type of vibration causes the emergency parking brake to release. The whole emergency parking brake assembly was replaced once under warranty. Owner still expereincing a problem with truck if not in gear. *Ak
Inside front brake pads completely worn out, causing vibration upon braking.
BRAKE PADS REPLACED SEVERAL TIMES.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data