I own a 2020 Tesla Model X equipped with HW3 and Full Self-Driving (FSD). After a Tesla software/FSD update earlier in 2026, the vehicle began experiencing a recurring problem during FSD operation. The issue has now occurred more than 20 times. During certain FSD-controlled maneuvers, particularly when turning from a complete stop onto a higher-speed road, FSD commands unusually aggressive acceleration. During the acceleration, FSD abruptly aborts/disengages and the vehicle logs diagnostic fault code DI_w124....
Read the full complaint
Cruise control and FSD then become unavailable. There is one particular location where the condition is highly reproducible. FSD turns from a stop onto a road with a 50 mph speed limit, rapidly accelerates the vehicle, then triggers DI_w124 and aborts. Tesla previously inspected the vehicle for this issue and advised that the vehicle hardware checked out normally. The problem has nevertheless continued through subsequent Tesla software updates. After another recent software update, I tested the same maneuver again on [[redacted]], and the same DI_w124/FSD abort occurred. The problem did not occur prior to the earlier software/FSD update and appears to be associated with FSD-controlled acceleration rather than a general vehicle hardware failure. I am concerned that a driver-assistance system commanding aggressive acceleration and then unexpectedly disabling itself during the maneuver presents a potential safety risk, particularly when entering a 50 mph roadway or merging into traffic. Tesla has previously inspected the hardware but the condition remains unresolved. I am reporting this so NHTSA can determine whether other 2019-2020 Tesla Model S/X HW3 vehicles are experiencing the same DI_w124 fault during FSD-controlled acceleration. here is a link to the video that was taken a few months ago. [[redacted]] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)