Tiffin motorhomes is recalling certain model year 2011 allegro bus and phaeton recreational vehicles built on the powerglide chassis equipped with a cummins isx or isl diesel engine. The v-band clamp assembly, part numbers q187684, q187685, and q187686, used...
Engine & cooling
Tiffin Allegro Bus Engine problems by year
6 complaints filed with NHTSA about the Tiffin Allegro Bus's engine & cooling. Stalling, loss of power, oil consumption, overheating, head gaskets, timing chains and engine failure.
Engine complaints by model year
Engine recalls
Latest Allegro Bus engine complaints
Extreme engine heat into vehicle
At highway speed, dash lit up with warning lights, dash sounded alarms, mobile eye flashed err..And dash display flashed abs comm error! 60 Seconds latter the engine stopped (everything dead)...But motor coach still moving with no power steering! Luckily I was able to stop the coach in a busy exit lane. After 4 hours (police stayed with us the entire time)...Was able to reset ecm error code and start the engine. After contacting tiffin, they advised to disconnect mobile eye under dash. Spent 1 hour under dash...
Read the full complaint
(while in traffic) trying to find connection. Never found, believe it is not under dash, but up and behind a kick panel? Limped coach home...With the problem recurring 2 additional times. This a s major safety problem...Imagine the panic of at 70 mph this problem happening...And you only have 60 seconds to find a safe place to bring 50,000 pounds of coach to a safe stop before loosing all power! This problem has been reported multiple times by others as recorded in the tiffin network forum. This should be a tiffin recall action!*Dt*jb
This is not a single isolated incident. There have been a large number of owners with this issue and the manufacturer has not provided an acceptable solution. *Dt on the 2015-2018 tiffin allegro bus on the power glide chassis, a critical design defect exists with the engine fan drive tensioner bracket and tensioner pulley assembly. The fan drive is designed to engage at a pre-determined engine coolant temperature and is utilized to lower engine temperature as the engine coolant temperature reaches a high level. ...
Read the full complaint
The tensioner bracket is constructed from heavy gauge steel plate that is welded together and the tensioner pulley assembly is a cast/machined aluminum assembly. The assembly weighs over 20 pounds. As designed, the fan drive tensioner assembly cannot sufficiently handle the torque and vibration generated when the fan drive engages. The tensioner bracket and pulley develops micro-cracks that quickly deteriorate into major cracks in the steel bracket and tensioner pulley causing a sudden total failure of the bracket, which in a worse case situation, results in the bracket breaking into several pieces and becoming discharged from the rear of the motorhome at highway speeds. When the bracket fails, the engine fan drive is inoperable, and the motorhome operator experiences a rapid increase in engine temperature and the engine shuts down, possibly causing a loss of vehicle control.. Should the fan drive tensioner and tensioner bracket become dislodged from the motorhome engine compartment, it could strike another vehicle or person causing severe damage, injury, or possible death. To date the manufacturer has been unable to design/provide a fan drive tensioner assembly that will withstand the torque and vibration being generated. The manufacturer should implement a recall of the fan drive tensioner bracket and tensioner pulley assembly,
Cooling system fan drive belt tensioner develops cracks that progress to the point of catastrophic failure where half the bracket end and two heavy pulleys are ejected from the vehicle by the fast moving fan belt.. This has been a known problem and tiffin has redesigned the bracket and is repairing them as they fail. There have been numerous failures and posts about them posted in the on-line recreational vehicle forums. As a result of these posts, I added a check of this bracket to my maintenance checklist. A...
Read the full complaint
major maintenance cycle was completed just before christmas and no problem was found. Another maintenance cycle was completed this may, approximately 6000 miles later, and the cracks were found. Tiffin was notified and a replacement bracket is being sent to me. *Dt
Isl cm850 engine stop engine now and other problems. Customer states that the #6 wrist pin was bad. The wrist pin was replaced. Then consumer was informed that the manifold gasket was out of line. That was realigned. *Kb once the gasket was re-adjust, the engine knock disappeared. *Jb
Dt*: the contact stated when the motor home was exposed to hot weather there were strong fumes present believed to be formaldehyde. The fumes were very irritating to the eyes of all occupants. The contact's spouse was hospitalized for five days due to respiratory problems, asthma, pneumonia and a collapsed lung. The contact expressed that there were other similar complaints about this were posted on the internet. The dealership and the manufacturer informed the contact that the smell would get better after the vehicle got older. *Ak
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data