Check a vehicle VIN check Latest recalls Latest complaints Common problems Rankings Compare vehicles Recall roundups All makes Guides Share your experience
Theme

Suspension

Vanleigh Beacon Suspension problems by year

6 complaints filed with NHTSA about the Vanleigh Beacon's suspension. Broken springs, struts, control arms, ball joints, noises and alignment that won't hold.

Suspension complaints by model year

YearSuspension complaintsCrashesInjuriesRecalls
20223000
20211000
20201000
20191001
20180001
20170001
20160001
20150001

Suspension recalls

Latest Beacon suspension complaints

2021 Vanleigh BeaconSuspensionBody, doors & structure

The frame of my 2021 Vanleigh Beacon 39FFB fifth wheel trailer has experienced a catastrophic structural failure in the primary load-bearing area near the king pin. The frame has fractured on both sides between the king pin structure and upper deck riser in a non-welded section of the frame. This failure has allowed the king pin to displace upward more than 2 inches into the front structure of the RV. Additional structural damage includes: -Shearing of a structural fastener/bolt -Visible separation and movement...

Read the full complaint

of frame members under hitch load -Bent and misaligned I-beam near the suspension/equalizer area The failure directly affects the towing connection and structural integrity of the vehicle and creates a serious roadway safety hazard, including potential towing instability or possible hitch/detachment risk. The RV has not been involved in an accident and has not been knowingly overloaded. The failure appears related to a structural/load path defect involving the frame design, material integrity, and/or structural fatigue in a critical towing area. The unit is currently unsafe to tow. Manufacturers involved: -Vanleigh RV -Lippert Components Photos and supporting documentation are available showing frame fracture, structural displacement, sheared fasteners, and frame movement under load. The RV is currently located at The Resort At Canopy Oaks, [[redacted]] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Filed Incident Suspension · Structure · Unknown or otherNHTSA 11740808
2020 Vanleigh BeaconSuspensionWheels & tiresBrakes

While travelling on an interstate freeway, towing our 40 foot 5th wheel RV at 63 mph, our trailer lost its front drivers' side wheel & tire. Upon realizing something was wrong and stopping to investigate, I recognized the wheel spindle had separated from the axle at the welding point, which allowed the wheel, bearings, disc brake assembly and tire to separate from the axle. The wheel, tire & all other parts were not found. An incident report was filed with the state police, who responded and assisted in attempting...

Read the full complaint

to locate the lost wheel & tire with negative results. Pictures of the axle, which remained attached to the leaf springs, were taken. The pictures clearly show evidence of rust approximately half way around the axle where the welding of axle to the spindle failed, as evidenced by brighter, fused, metal that was holding the spindle until the break and separation. Our safety was put at risk due to the immediate loss of the trailer's brakes due to the fluid loss from the brake lines being torn apart as a result of the loss of the left, front brake assembly, wheel & tire. In addition, the loss of the weight-bearing tire placed the trailer in an unstable condition for maneuvering at freeway speeds. The other major safety concern was the other motorists traveling nearby could have hit or been hit by the wheel and tire while traveling at speed on a freeway. We were able to get our trailer to a nearby trailer repair facility that confirmed our damage and the potential safety risk to other motorists. While an incident report was filed with the state police, there was no inspection of our trailer by the police, trailer manufacturer or insurance other than by photos. Prior to our traveling on this trip, I did have our trailer's suspension inspected by an RV repair & service provider, however, they had no reason to inspect the spindle/axle welds. There were no symptoms or warnings of a problem with the spindle/axle welds.

Filed Incident Suspension · Wheels · Service brakesNHTSA 11604905
2022 Vanleigh BeaconSuspensionBody, doors & structure

This is my second report with two different incidents of failure. These failures are connected to the Lippert frame of my fifth wheel trailer. While, traveling in Indiana near Gary, Indiana my leafspring on the rear axle on the driver side gave away, causing the trailer to veer hard to the left. Fortunately, there was no one to my left and I was able to regain control and get to the shoulder. After inspecting, I determined that the pin holding the leaf springs together sheared off after going over a bridge...

Read the full complaint

expansion joint. The second issue I discovered this spring is that I have two significant cracks in the upper deck frame, causing extreme frame flax. Lippert is refusing to cover the fix under the warranty. Lippert has been very difficult to deal with during this process and I have been forced to use a third-party to fix their poor welds. I have pictures if need be. There are many other frame issues that other people are dealing with. All have the Lippert frames! Someone will be severely injured or killed if Lippert is not held accountable by the federal government.

Filed Incident Suspension · Unknown or other · StructureNHTSA 11590067
2022 Vanleigh BeaconSuspensionFire

The contact owns a 2022 Vanleigh Beacon RV. The contact stated while driving at 60 MPH and looking at the rearview mirror, he noticed smoke at the top of the rear end of the RV. The contact pulled to the local Pep Boys and parked the RV. Upon inspecting the vehicle, the contact noticed that the rear passenger suspension had dropped to the ground. Additionally, the contact noticed that the undercarriage, the rear-end wall, the passenger's side sidewall, and hoses were damaged. The RV was towed to the dealer where it...

Read the full complaint

was diagnosed that the suspension had failed. There was no further information provided. The RV was not repaired. The manufacturer was notified of the failure but did not provide any assistance. The failure mileage was approximately 1200.

Filed Incident SuspensionNHTSA 11455063
2019 Vanleigh BeaconSuspension

The spring hangers on vanleigh rvs whose frame is manufactured by lippert components break during normal use. Please find the enclosed pictures. This is a lippert issue in my opinion but the unit as mentioned is made by vanleigh rv. My rv suffered this issue and upon a query to several other vanleigh rv owners its a common theme. A quick review of other rv forums finds the same issue and the fix is to "beef up" the affected area. Infact I was told lippert techs know of this issue and have a picture of a...

Read the full complaint

"beefed up" hanger. I spoke with a customer service rep at vanleigh and was told this was a known issue. Im happy to provide more pictures if needed and provide weblinks to other customers with this same lippert frame issue.

Filed Incident SuspensionNHTSA 11342450

Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data

Owners helping owners

Know before you drive.

Every experience you share - good or bad - shows on that vehicle's page and helps the next owner and buyer. Two minutes, anonymous.

Share your experience