Check a vehicle VIN check Latest recalls Latest complaints Common problems Rankings Compare vehicles Recall roundups All makes Guides Share your experience
Theme

2009-2011 · 2 model years

Victory Kingpin Eight Ball Problems by year

Owners have filed 3 complaints about the Victory Kingpin Eight Ball across 2 model years, and it has 0 recalls. The 2009 has the most complaints once its age is allowed for (2). The most reported problem area is the transmission & drivetrain, followed by the wheels & tires.

Most complaints for its age20092 complaints · 0 recallsSee the 2009
Complaints
3
Recalls
0
Crashes
0
Fires
0
Injuries
0
Deaths
0

Kingpin Eight Ball complaints by model year

Highlighted: the year with the most complaints for its age. Older vehicles have had more time to collect complaints - the Safety Index grade allows for that.

YearComplaintsRecallsCrashesFiresTop problemGrade
20111000Wheels & tires-
20092000Transmission & drivetrain-

Most common Kingpin Eight Ball problems

Latest Kingpin Eight Ball complaints

2011 Victory Kingpin Eight BallWheels & tires

Moving at aprox. 70Mph on a state hwy. When the rear drive pulley came loose from the rear wheel causing all of the bolts to shear off rendering the vehicle inoperative. Fortunatley the bike was able to be stopped without the rear wheel locking up. Apparently this has been a know issue with other victory motorcycles. According to the research I have done since the incident. The pulley was installed with powder coating on the mating surface. Over time the powder coat breaks down and causes the bolts to become...

Read the full complaint

loose. Mating surface between the pulley and the wheel should have been bare metal to metal. Damage was done to the wheel, pulley and swing arm. All of these parts will have to be replaced.

Filed Incident WheelsNHTSA 11113216
2009 Victory Kingpin Eight BallTransmission & drivetrainWheels & tires

3 Of 5 rear pulley bolts sheared off while riding. Pulley is powder coated. The surface between the pulley and hub of rim was not "cleaned" of the powder coating which eventually rubbed off creating friction between the bolt heads. The loose powder coating then shears the bolt heads off (they do not back out, they shear off!). This happened to me while riding! I heard a noise and could not figure out where it was coming from. Rode bike carefully to friend's house where it was found that three bolt heads were gone!!...

Read the full complaint

My pulley was moving using your hand alone. I'm so lucky to be alive. I have recently read of this happening to six people in less than a month to bikes that have powder coating. One person said that they went to victory/polaris and got no resolution. I can come up with a handful of people right now that could file the same claim as I am. I want to be compensated for the cost of repairs - at minimum! (In pictures, note the presence of powder coating on back side of pulley)

Filed Incident Power train · WheelsNHTSA 10897296
2009 Victory Kingpin Eight BallTransmission & drivetrain

The clutch cable snapped when shifting gears between 1st and 2nd gear initially at 18090 miles. I inspected the cable periodically and lubricated the cable with every oil change (2500) miles. The cable broke down by the engine not at the lever. After the breakage I replaced the cable in november 2012. The cable broke again at 27070 miles in august 2014 when I was in dense traffic. Since I was unable to shift this presented an very unsafe driving situation, I was forced to force shift the bike (no clutch...

Read the full complaint

engaged) into 2nd gear until I could get out of dense traffic. In both cases I had to kill the engine to stop the bike. I have read online where several other victory owners have experienced the same problem. The problem is so bad and recurring on victory motorcycles that a company sells a temporary replacement cable (http://www.Savurride.Com/) . I have since replaced the clutch cable with a hydraulic clutch kit that victory sells for $350 to $400. *Tr

Filed Incident Power trainNHTSA 10637027

Questions about the Victory Kingpin Eight Ball

Which Victory Kingpin Eight Ball years have the most problems?

By the number of complaints owners filed with NHTSA: 2009 (2), 2011 (1). Allowing for how long each has been on the road, the 2009 stands out most. Complaint counts also rise with sales, so compare years of the same model rather than different models.

What are the most common Victory Kingpin Eight Ball problems?

Across every model year, owners report problems with the transmission & drivetrain (2), wheels & tires (2) most often.

How many recalls does the Victory Kingpin Eight Ball have?

NHTSA lists no recalls for any Victory Kingpin Eight Ball model year on file.

Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data

Owners helping owners

Know before you drive.

Every experience you share - good or bad - shows on that vehicle's page and helps the next owner and buyer. Two minutes, anonymous.

Share your experience