- The problem
- Certain chassis equipped with actia corporate instrument clusters fail to comply with the requirements of federal motor vehicle safety standard nos. 101 "Controls and displays" and 105 "hydraulic and electric brake systems." If the brake fail input falls below a voltage of 1.5V, the brake failure lamp and alarm will be activated. Also activation of the abs tell tale when the abs is not properly functioning does not always occur.
- The risk
- This does not meet the requirements of the standard.
- The fix
- Workhorse will notify its customers and reprogram the instrument panel cluster free of charge. The recall began january 2005. Owners should contact workhorse at 1-877-246-7731.
Vehicle safety record
2004 Workhorse Chassis Problems, complaints & recalls
Owners have filed 34 complaints about the 2004 Workhorse Chassis with NHTSA, most often about the brakes (27) and the electrical system (5). Those complaints describe 2 fires. It is covered by 1 recall, the latest in April 2004 for the electrical system. For comparison, the 2003 has 22.
NHTSA data checked
- Complaints
- 34
- Recalls
- 1
- Crashes
- 0
- Fires
- 2
- Injuries
- 0
- Deaths
- 0
Most common 2004 Workhorse Chassis problems
Share of all 34 complaints. One complaint can name more than one area. Tap an area for its complaints and recalls.
2004 Workhorse Chassis recalls 1
Recall repairs are free. Your dealer fixes them whether or not you bought the car there - check your VIN at nhtsa.gov/recalls to see if yours is done. What to do
What owners say
Problems or none - your experience is exactly what the next buyer is looking for. Write it now
34 complaints about the 2004 Workhorse Chassis
Newest first, as filed with NHTSA by owners. Page 2 of 2.
Tl*the contact owns a 2004 workhorse chassis. While driving approximately 60 mph, the vehicle had a premature tire blow out. The contact pulled over to the side of the road and the vehicle was towed to a local tire shop. The tire was replaced and the contact drove to his residence. Approximately one week later, he drove to a local tire shop to have the five remaining tires replaced and was informed that the brake rotors were cracked on the front driver's side. The mechanic did not explain how the failure occurred. The vehicle has not been repaired. The dealer and manufacturer have not been notified. The current mileage was 24,939 and failure mileage was 22,300.
Tl*the contact owns a 2004 workhorse chassis. While driving approximately 20 mph, the contact noticed a smell coming from the vehicle. In addition, the brakes began locking. The vehicle was pulled over to the side of the road and he noticed that the rear passenger side brakes were hot. The failure has recurred repeatedly ever since. The manufacturer stated that the vehicle was not being repaired and they were not liable for the repairs. There has been no definitive diagnosis. The dealer has not been notified. The current mileage was 9,980 and failure mileage was 8,500.
Tl*the contact owns a 2004 workhorse chassis. While driving 55 mph, the contact smelled an odor. He stopped and inspected the vehicle, but found no failure. As he continued driving, the odor intensified. The chassis was towed to the dealer and they stated that the driver's side brake locked and caused it to stick to the rotor. The failure then caused the rotor to overheat. The dealer replaced the rotor, brakes, caliper, and disc pad seal hose. The manufacturer stated that no recalls were available. The...
Read the full complaint
current mileage is 13,880 and failure mileage was 13,761 updated 04-08-08 *bf the front caliper seized which created excessive friction on the rotor which resulted in the rotor becoming warped. Updated
Tl*the contact owns a 2004 workhorse chassis. While driving 25 mph, the contact discovered that the brakes were burning. The calipers became so hot, that the abs sensor failed. The caliper, abs sensor, and brake pads were all replaced at the cost of $1,539.04. The current mileage was 20,000 and failure mileage was 17,000. Updated 12-12-07. *Kb updated
Consumer was not informed of recall on workhorse custom chassis. *Ts the consumer request a copy of the original recall which was sent on december 2004. The recall was to reprogram the electronic instrument panel (i/p) cluster software (recall number 50402-c). *Nm
Consumers brakes were not releasing all the way causing motorhome to drag. *Ts the consumer was unable to get the motorhome to reach 55 mph so he could use the over drive. While driving , the consumer noticed the bas light had illuminated. The consumer realized there was a serious brake problem when he had trouble stopping and then had trouble pulling away from it. When the consumer pulled over, he noticed oil running out of the right front hub and all 4 brakes were smoking, the brakes had locked up and the...
Read the full complaint
consumer had difficulty getting the motorhome off the road. The lack of power the consumer experienced was due to the brakes not releasing. The consumer called a tow truck, when the tow truck driver disconnected the driveshaft he discovered why the abs light had come, the sensor and wire were completely melted. The mechanic fixed the result of the malfunction, but not the malfunction. After getting the rv back,the consumer felt a loss of power and could see a drop in gas mileage. The consumer heard a noise, but when he tapped the brakes the noise went away. The consumer believed the problem was either the booster pump or booster pump switch sticking which was preventing the brakes from releasing all the way. *Jb
Dt: the contact owns a 2004 rexhall motor home with a work horse chassis engine. The contact stated that three of the steel wheels on the motor home cracked, causing loss of tire pressure. The consumer has had three wheels replaced. The inspection of the wheels determined that the crack was due to a defect. The contact has not contacted the dealership due to it being out of state and no longer dealt with this type of vehicle, but referred the contact to the manufacturer of the chassis. The consumer contacted work horse, and they replaced two wheels after they cracked. The contact was writing a letter to work horse to inform them of the most recent failure. *Ak
Recall campaign 04v195000 concerning workhorse fmvss 101 and 105 instrument cluster. The consumer was unable to get the dealer to honor this recall since mid february 2005. *Ak the consumer was informed that the dealer did not have the tool to insert the correct data into the ip cluster. The consumer found a dealer who was able to perform the recall repairs. *Sc *jb
Intermittently while driving at any speed the engine would go into reduced power mode with out warning. When this happened the vehicle was only in idle power. This problem has occurred twice since february of 2004. The dealer is examining the vehicle at this time. *Nm *nm
Workhorse Chassis: every year compared
All Chassis years2004 Workhorse Chassis vs rivals
| Vehicle | Complaints | Recalls | Grade | |
|---|---|---|---|---|
| 2004 Workhorse Chassis | 34 | 1 | - | |
| 2004 Workhorse W22 | 92 | 2 | F | Compare |
| 2004 Workhorse W20 | 7 | 2 | C | Compare |
| 2004 Workhorse P32 | 2 | 1 | C | Compare |
More sales usually means more complaints, so compare similar vehicles of the same year. The grade compares each vehicle with its own model's other years.
Questions about the 2004 Workhorse Chassis
Does the 2004 Workhorse Chassis have any recalls?
Yes - NHTSA lists 1 recall for the 2004 Workhorse Chassis: electrical system (April 2004). Recall repairs are free at any authorized dealer. Enter your VIN at nhtsa.gov/recalls to see whether yours has been fixed.
What are the most common problems with the 2004 Workhorse Chassis?
By the complaints owners filed with NHTSA, the most common problem areas are the brakes (27), electrical system (5), engine & cooling (3).
How many complaints has the 2004 Workhorse Chassis had?
34 complaints have been filed with NHTSA, the first on August 16, 2004 and the latest on March 30, 2019. Of these, 0 describe a crash and 2 a fire, and together they report 0 injuries and 0 deaths.
Which Workhorse Chassis years have the most complaints?
2004 (34), 2003 (22). See every Workhorse Chassis year compared.
What should I do if my 2004 Workhorse Chassis has a problem?
If it is a safety problem, stop driving it if it is unsafe and contact your dealer. Report it to NHTSA at nhtsa.gov/report-a-safety-problem - enough reports start investigations and recalls - and share your experience here so other owners know what to look for.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data