Check a vehicle VIN check Latest recalls Latest complaints Common problems Rankings Compare vehicles Recall roundups All makes Guides Share your experience
Theme

Engine & cooling

Yamaha FZ-09 Engine problems by year

10 complaints filed with NHTSA about the Yamaha FZ-09's engine & cooling. Stalling, loss of power, oil consumption, overheating, head gaskets, timing chains and engine failure.

Engine complaints by model year

YearEngine complaintsCrashesInjuriesRecalls
20152000
20148000

Latest FZ-09 engine complaints

2015 Yamaha FZ-09Transmission & drivetrainEngine & cooling

Driving down the road at 50mph when a animal came out of the ditch. I then pulled clutch in so I could brake. Once I did this the bike stalled. To get the bike going again I released the clutch, but once I did this the bike just locked the back tire. I then pulled clutch in again and then it started. I attempted to pull to the side of the road, when I noticed that the clutch was not disengaging I knew there was something wrong. Got the bike back home, and pulled the clutch case off to find two clutch disks had shattered. This also caused the clutch basket to break. Now there is metal floating all around my motor.

Filed Incident Power train · EngineNHTSA 11020180
2014 Yamaha FZ-09Transmission & drivetrainEngine & cooling

After only 7000 miles the clutch basket cracked, broke, and defected in spectacular fashion. This caused the gears to slip, more damage to be done internal to the clutch system and great cost. The problem was noted while driving. During acceleration, the motorcycle's engine would rev through the gear but no acceleration was experienced. This caused an alarming caution as attempting to pass vehicles, accelerate through intersections, and otherwise maintain speeds very difficult and difficult to determine proper...

Read the full complaint

avoidance of situations. Typically, a rider like myself can determine proper acceleration and timing to avoid things like other vehicles, road conditions, or dangerous situations but accelerating through, around, or away from them. This was nearly impossible due to this breakage of a non-normal wearing part.

Filed Incident Power train · EngineNHTSA 11020052
2015 Yamaha FZ-09Transmission & drivetrainEngine & cooling

Clutch basket cush bumpers prematurely wearing out, causing freeplay between ring gear and basket. Any play whatsoever is abnormal and will cause excessive vibrations. Vibrations within the clutch assembly will cause plates to break potentially causing a crash.

Filed Incident Power train · EngineNHTSA 10979181
2014 Yamaha FZ-09Engine & cooling

This is the second stock cam chain tensioner replacement that I have had done on this bike. The repair was done by malcolm smith motorsports in riverside ca. The cct fails. Resulting in a lose cam chain, causing a lot of noise. If the cam chain skips a tooth, it can cause catastrophic engine failure resulting in an accident, injury or death. The noise comes from the right side of the engine. It is really loud at start up and at idle speed.

Filed Incident EngineNHTSA 10936254
2014 Yamaha FZ-09Transmission & drivetrainElectrical systemEngine & cooling

I wanna say I love this bike and will continue driving and trying to fix it.My 2014 fz09 has 5000 miles on it and when I down shift in traffic or anywhere the bike dies the tire will sometimes lock up if I don't catch the problem in time.. I'm trying to get others that are on the fz forums to share there same complaints.. This is a serious safety issue as it will literally just cut off no power poof.. And a really bad noise and vibration around 3100 to 4000 rpms makes you feel like the transmission is falling apart.. Other than that I love the bike and hope the issues get fixed as this will be 2017 the next gen

Filed Incident Power train · Electrical system · EngineNHTSA 10904863
2014 Yamaha FZ-09Engine & cooling

While riding approximately 60mph in traffic, just pulled ahead of some vehicles, and the engine started to lose power, shudder, and then it made a loud screetching sound, and locked up the rear tire when the engine died. I pulled in the clutch, releasing the rear tire, and the engine was still dead. Tried the starter, nothing. Downshifted as the bike coasted slower into 3rd gear, and slowly let out the clutch, and it "bump started" the engine, but now it was making a massive tick tick tick tick tick noise. (Much...

Read the full complaint

louder than the other minor tick noises I'd heard, mainly when it was cold, right after start up before.) I verly slowly and at low rpm made it to work, and then slowly at low rpm made it home on the bike, but the entire time, it is making a loud tick tick tick tick noise. I tried a common fix, of using a longer set screw, adjusted finger tight, to keep the "automatic" cam chain tensioner from backing off, and making the loud tick tick tick tick noise. This seemed to fix the bike. I rode to work again the next morning, and bam, just about the same place, about 65mph this time, after passing slower traffic, and getting into the clear, the bike shuddered and then even louder than before, the engine locked up, sliding the rear tire. I pulled in the clutch, and it released, and I was nearly run over by the traffic behind me that I'd just passed. This is no longer just an issue of noise< now it"s putting my life in danger. Let me repeat: this timing chain noise has gone from annoying, to life threatening due to engine sieze up at speed now multiple times. Please force yamaha to step up, replace this faulty and life threatening design flaw immediately.

Filed Incident EngineNHTSA 10748012
2014 Yamaha FZ-09Engine & cooling

Tl* the contact owns a 2014 yamaha fz09. The contact stated that the timing tensioner on the vehicle had to be repaired twice. Each time the motorcycle was taken to the dealer, the tensioner was tightened; however, the remedy failed to repair the failure. The manufacturer stated that the failure was related to an unknown manufacturer recall. The vin was not available. The failure mileage was unknown.

Filed Incident EngineNHTSA 10694575
2014 Yamaha FZ-09Engine & cooling

Ever since day 1 it never likes to cold start on the first try. Starts to catch but never does until you try a second time. After starting, you hear a loud tick/flutter , I'm guessing the whole cam chain tensioner issue that seems to be plaguing everyone. I just received the recall for the headlight harness too short. *Tr

Filed Incident EngineNHTSA 10641267
2014 Yamaha FZ-09Transmission & drivetrainEngine & cooling

At initial cold start and under load between 3000-4000 rpm there is a noticeable rattle/tick from the right side of engine at the cam chain tensioner. Upon further inspection it seems the tensioner does not hold tension which can lead to premature wear, breakage, or engine failure. Following yamaha procedure for cam chain tension adjustment proves that the tensioner is malfunctioning by watching the hex key tool back off (loosen) after making adjustment and eventually causing rattle/tick again. Contacting yamaha dealership also confirmed issue, being informed that there have been multiple revisions made (updated parts) but still no confirmation on permanent fix. *Tr

Filed Incident Power train · EngineNHTSA 10609463
2014 Yamaha FZ-09Transmission & drivetrainEngine & cooling

Camshaft chain tensioner becomes loose, exceptionally loose increasing the chance for engine timing to jump, slip, or for the camshaft chain to break while in motion leading to or accelerating engine damage and wear. *Tr

Filed Incident Power train · EngineNHTSA 10594156

Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data

Owners helping owners

Know before you drive.

Every experience you share - good or bad - shows on that vehicle's page and helps the next owner and buyer. Two minutes, anonymous.

Share your experience