- The problem
- Certain school buses fail to comply with the requirements of federal motor vehicle safety standard no. 221, "School bus body joint strength." One or more of the bolts attaching the driver's platform to the floor structure was omitted.
- The risk
- The rear of the driver's platform may not be properly retained in the event of a crash which could increase the risk of injury or death to passengers.
- The fix
- Blue bird will notify its customers and inspect and repair the affected units. Owner notification began on november 20, 2003. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact blue bird at 478-822-2242.
Body, doors & structure
1995 Blue Bird TC2000 Body problems
No owner has filed a complaint about the 1995 Blue Bird TC2000's body, doors & structure with NHTSA. Doors, hoods and latches, frame rust, sunroofs, leaks, trim and structural failures.
- Complaints
- 0
- Recalls
- 8
- Crashes
- 0
- Fires
- 0
- Injuries
- 0
- Deaths
- 0
Body recalls for the 1995 Blue Bird TC2000
- The problem
- Vehicle description: school buses. These buses fail to meet the 60 percent joint strength requirements of fmvss no. 221, "School bus body joint strength."
- The risk
- In the event of a vehicle crash, the roof may not be supported sufficiently, causing personal injury to bus occupants.
- The fix
- Owners will be contacted and advised to inspect each roof joint. Owners will install repair rivets in each joint found to have insufficient quantity of rivets in each examined 8 inch section.
- The problem
- Passenger's clothing can unknowingly become caught in the forward handrails at bus doors when exiting the bus.
- The risk
- When a passenger's clothing becomes caught in the handrail, and the bus driver closes the door and puts the vehicle in motion, the individual is subject to being dragged by the bus. This can result in serious injury or death.
- The fix
- Owners will be directed to remove all forward handrails. Provisions will be made for those owners operating in states which mandate a forward handrail that a replacement handrail will be provided.
- The problem
- These buses are equipped with an entrance door handrail off set brace attached to the interior wall and the handrail. The attachment point at the wall is incorrectly positioned permitting the entrapment of the "connecticut nut/string test device" between the upper edge of the brace and the lower edge of the seat ledge. Passenger's clothing could unknowingly become caught in the handrails at the bus doors when exiting the bus.
- The risk
- When a passenger's clothing becomes caught in the handrail, and the bus driver closes the door and puts the vehicle in motion, the individual is subject to being dragged by the bus. This can result in serious injury or death.
- The fix
- Dealers will inspect and relocate the bracket as necessary. Owners can inspect and relocate the bracket is so desired.
- The problem
- An improper mix of adhesive was applied to the interior side panel joints resulting in the buses failing to conform to the joint strength requirements of federal motor vehicle safety standard no. 221, "School bus body joint strength.":
- The risk
- Consequence of non-compliance: in the event of a collision, the side panel of the bus may not protect the occupants at the level required fmvss no. 221
- The fix
- Dealers will inspect and repair with correct adhesive if the sealer was not cured properly.
- The problem
- The floor line handrail bracket can expand during use and create an opening which could entrap coat strings, etc. And other articles of clothing.
- The risk
- When a passenger's clothing becomes caught in the handrail, and the bus driver closes the door and puts the vehicle in motion,the individual could be dragged by the bus. This can result in serious injury or death.
- The fix
- Dealers will replace the flat split floor line bracket with a round tubular bracket.
- The problem
- These units are equipped with a counter weight assembly made up of 300 pounds of 1/4" plate steel welded together and bolted between the frame rails in the rear overhang just forward of the rear bumper. Some of the welds have broken due to insufficient welds, corrosion, or ice expansion.
- The risk
- These plates can drop to the roadway becoming a hazard to following vehicles increasing the potential for an accident.
- The fix
- Dealers will install a mechanical retaining device which clamps the plates together and fastened with threaded fasteners. Bus owners will have the option of repairing their own vehicles.
- The problem
- Passengers clothing can unknowingly become caught in the handrails at bus doors when exiting the bus.
- The risk
- When a passenger's clothing becomes caught in the handrail, and the bus driver closes the door and puts the vehicle in motion,the individual is subject to being dragged by the bus. This can result inserious injury or death.
- The fix
- Dealers will install a set screw to the metal clamp which retains the intermediate handrail. A high impact molded plastic "clam shell" will be placed over each end of the intermediate handrail completely covering the clamp and eliminating all catch-points. The flange of the existing floor line bracket will be crimped securing the vertical section of the primary tublar handrail at the floor line.
Body complaints
No complaints about this area yet.
Blue Bird TC2000 body complaints by year
TC2000 body problems, every yearSource: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data