Check a vehicle VIN check Latest recalls Latest complaints Common problems Rankings Compare vehicles Recall roundups All makes Guides Share your experience
Theme

Engine & cooling

1992 BMW 318I Engine problems

Owners have filed 5 complaints about the 1992 BMW 318I's engine & cooling with NHTSA - 62% of all its complaints, most recently on July 10, 2004. Stalling, loss of power, oil consumption, overheating, head gaskets, timing chains and engine failure.

Complaints
5
Recalls
1
Crashes
0
Fires
0
Injuries
0
Deaths
0

Engine recalls for the 1992 BMW 318I

Engine and engine cooling: cooling system

98V178000340,000 vehicles affected

The problem
Vehicle description: passenger vehicles. A malfunction or failure of a coolant system component, such as a thermostat, water pump, or fan belt, can result in significantly increased coolant temperature and system pressure. If the indications of a critical overheating condition is not noticed by the driver, it is possible that damage to, or failure of, a coolant system component could occur.
The risk
If a crack were to form or a seam were to separate in the heater core end piece, hot coolant could suddenly be expelled, increasing the risk of personal injury to a vehicle occupant.
The fix
Dealers will install a new design radiator cap to control pressure and provide greater coolant overflow in the event of overheating.

Engine complaints

Engine & cooling

FAULTY PROFILE GASKET ON 1992 BMW 318I ENGINE. *AK

Filed Incident Engine and engine coolingNHTSA 10080772
Engine & cooling

The profile head gasket is a widely reported defect on bmw 318i engines. For me its a serious problme now that this is the second head gasket to blow. The first was replaced under warranty, the second may or may not be replaced under warranty. In anny event the repair work has not yet been done. Based on the web pages I have read this is a widespread problem and bmw is not reacting properly. I think you should consider a class-action law suit to make them act properly for such a major defect.

Filed Incident Engine and engine coolingNHTSA 700720
Engine & cooling

Profile gasket failure. The part fails on all m42 engines produced by bmw between 1991 and 1992. Was made aware via technical bullletin sent to dealers. A recall needs to be issued.

Filed Incident Engine and engine coolingNHTSA 540101
Engine & cooling

I have done some research over the internet for this problem and it appears to be a very common one. I am completely amazed that bmw is not covering this repair of this, even though they are aware of the defect.

Filed Incident Engine and engine coolingNHTSA 537617
Engine & cooling

Vehicle experienced coolant loss and low coolant levels but the temperature guage did not rise above normal. Loss was due to engine gasket failure.

Filed Incident Engine and engine coolingNHTSA 546736

BMW 318I engine complaints by year

318I engine problems, every year

Had a engine problem with your 1992 318I? Tell other owners.

Your experience goes live straight away and helps every owner and buyer who checks this vehicle. Anonymous, free, no account.

Overall, how would you rate it? *

0/4000 · Please leave out names, phone numbers and your full VIN.

By posting you confirm it's your own, honest experience and agree to the rules. Safety defect? Also report it to NHTSA - that's how recalls start.

Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data

Owners helping owners

Know before you drive.

Every experience you share - good or bad - shows on that vehicle's page and helps the next owner and buyer. Two minutes, anonymous.

Share your experience