- The problem
- Vehicle description: passenger vehicles. A malfunction or failure of a coolant system component, such as a thermostat, water pump, or fan belt, can result in significantly increased coolant temperature and system pressure. If the indications of a critical overheating condition is not noticed by the driver, it is possible that damage to, or failure of, a coolant system component could occur.
- The risk
- If a crack were to form or a seam were to separate in the heater core end piece, hot coolant could suddenly be expelled, increasing the risk of personal injury to a vehicle occupant.
- The fix
- Dealers will install a new design radiator cap to control pressure and provide greater coolant overflow in the event of overheating.
Engine & cooling
1993 BMW 318IS Engine problems
Owners have filed 9 complaints about the 1993 BMW 318IS's engine & cooling with NHTSA - 69% of all its complaints, most recently on August 16, 2002. Stalling, loss of power, oil consumption, overheating, head gaskets, timing chains and engine failure.
- Complaints
- 9
- Recalls
- 1
- Crashes
- 0
- Fires
- 0
- Injuries
- 0
- Deaths
- 0
Engine recalls for the 1993 BMW 318IS
Engine complaints
While driving at any speed and no warning cooling system cracked, causing fluid to leak out. Dealer notified.*Ak
There is a coolant leak in engine because an inferior form of rubber sealant is used on engine. Coolant goes back into engine. Contacted dealer, and dealer stated they knew about leak and its a frequent problem, but not under warranty.*Ak the head had to be replaced due to this problem, the problem is a rubberized gasket, known as the timing case profile gasket. *Jb
ENGINE GASKET FAILED. BMW DENIES DEFECT.*AK
While driving car overheated. Had vehicle towed to the dealer, and was told that there was an engine head gasket failure. *Ak
Profile gasket material weak causing it to leak antifreeze resulting in smoke coming from the car.
Timing case profile gasket failed causing loss of coolant on the roadway and vehicle overheating.
Engine gasket failed causing coolant to leak out andthe engine to overheat.
When the gasket goes all of the coolant in the radiator leaks out of the car, causing the engine to overheat. Because water in the coolant is out of the car, it is nothing that the consumer can do. The dealer cannot duplicate the problem. *Ak
Engine timing case profile gasket fails and causes complete loss of engine coolant.
BMW 318IS engine complaints by year
318IS engine problems, every yearSource: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data