On certain passenger vehicles, during the strut mount manufacturing process, the thrust bearing was not properly positions and secured. If the suspension is fully unloaded, the front strut could separate from the upper mount.
Suspension
BMW 325I Suspension problems by year
8 complaints filed with NHTSA about the BMW 325I's suspension. Broken springs, struts, control arms, ball joints, noises and alignment that won't hold.
Suspension complaints by model year
Suspension recalls
Latest 325I suspension complaints
1- Steering shakes a lot at speed 45 and over and uneven wear on both front tire. 2- The shop lifted up the car and said that both sides of the frame that holding the sway bar are rusted through and nothing can be done but to go to the dealer. 3- Well the dealer was not co-operative on the issue and want me to pay for the fix. *Tr
Tl*the contact owns a 2001 bmw 325i. During scheduled maintenance, the mechanic noticed that the rear coil springs had failed. The contact stated that he previously heard a popping noise. The vehicle has not been repaired. The current and failure mileages were 73,784.
Dt*: the contact stated while backing up out of a driveway at 5 mph, a noise was heard. The contact inspected the vehicle and noticed the rear passenger side wheel separated from the control arm support. The bolts that attached the wheel were fractured. Prior to the incident, there were no warning lights to alert the contact. The dealership was contacted who informed the contact the repair must be covered at the contact's expense. The manufacturer was also contacted who coincided with the dealership. The...
Read the full complaint
contact expressed concern because this type of failure at higher speeds could result in fatal consequences and the manufacturer should be responsible for such defect. The vehicle remained inoperable since the incident occurred. The consumer discovered the control arm that secured the passenger side wheel to the sub frame had separated from the sub frame. There were 3 bolts that secured the control arm to the sub frame and one of the bolts had sheared, while the other two had ripped completely from the sub frame; not only had the bolts ripped from the frame, but they pulled through the female section to which they were bolted. Updated 07/16/07. *Jb
Sudden wheel bearing failure - little or no symptoms before failure. Severe or total loss of control. Seems to be a common problem with sealed unit angular contact units on all bmw's this has happened 3 times on our vehicles - resulting in one crash. We know of other similar incidents. *Jb
While traveling on the highway there is vibration coming through the rear wheel. Please provide additional information. Dealer is aware of the problem. Ts
NO SUMMMARY LISTED FOR ABOVE VEHICLE. *AK
When shifting gears front will make a crackling noise. *Ak consumer states entire back end suspension (struts left and right) holding the rear wheels, transmission differentials to the frame of the vehicle is separating from the frame, dealer has been informed, however refuses to acknowledge liability or investigate possible product design defect. *Slc
Strut that holds the rear wheel is pulling from frame, consumer is not able to drive vehicle. *Ak
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data