See attached document for complaint.
Brakes
BMW 540I Brake problems by year
9 complaints filed with NHTSA about the BMW 540I's brakes. Spongy or hard pedal, ABS faults, brake failure, noises, parking brake and brake fluid leaks.
Brake complaints by model year
Latest 540I brake complaints
I reserved this vehicle with a deposit on Oct. 26. At the time I was told the vehicle was under recall/stop sale for a brake issue and I would not be able to take delivery until the recall work was performed. On 11/5, I was able to purchase the vehicle after the repair work was done. After leaving the dealership, about a half mile down the road I received a message on the vehicle display which said "Brake fluid level low. Have the problem checked by the nearest service center." The message also advised that I...
Read the full complaint
could continue driving the vehicle. I returned to the dealership and the car was inspected for roughly 30 mins. The vehicle was released to me and the message was gone. I was advised that the vehicle probably needed brake fluid from the recall repair. On 11/7, while driving I received the same Brake fluid level low message from the vehicle. I contacted the dealership and drove to the dealership to have the vehicle looked at again. About a mile from the dealership, as I applied the brakes, the vehicle suddenly generated a number of messages including "Brake system malfunction, stop carefully. Do not continue driving". At this point the brake pedal fell to the floor. I was able to stop the vehicle by applying a large amount of force to the brake pedal and was able to get to a nearby parking lot. I was very lucky and I would have been unable to prevent a crash under many circumstances. The braking power was almost completely gone from the vehicle. I returned the vehicle to the dealership and they reversed the transaction. From what I read online, the symptoms I experienced were exactly the same as those who experienced the brake failure which led to the recall. This car was either not fixed correctly or (even worse) the BMW remedy for the recall suffers the same potential problem as the original recall. In the second case, I believe this is a very dangerous situation.
The contact owns a 2024 BMW 540i. The contact received notification of NHTSA Campaign Number: 24V10400(Electronic Stability Control(ESC), Service Brakes, Hydraulic); however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced the failure. VIN tool confirms parts not available.
Power steering pump broke causing accessory belt to be thrown from engine at highway speeds, resulting in loss of steering and power. *Tr
The driver owns a 1999 bmw 540i with 72,579 miles. Over the past two months the disc bmw electronic stability control system icon and the amber abs and brake lights illuminated in one of two scenarios: (1) just after a new ignition cycle, (2) during normal driving. Once these warnings illuminated the dsc, abs, and traction control systems become non-functional. Until recently, the warnings would go out after 5-10 ignition cycles. Now they were on continuously.*Ak next to seatbelts, I strongly believe...
Read the full complaint
esc is the most significant development in automotive safety. As such, I find it very disconcerting the system on my vehicle has malfunctioned. Researching the topic on the various bmw forums has lead me to believe my situation is not an isolated one; that many model year 1999-2000 5-series bmws have also been affected. Esc malfunctions can have very negative impact on vehicle safety. In justifying the rationale for its recent mandate of esc, nhtsa estimates esc will reduce single vehicle crashes and rollovers by 34 and 71 percent, respectively. The agency estimates this technology will safe up to 9600 lives per year. Please feel free to contact me if you require additional information. Thank you.
I think this is ridiculous that the 60,000 dollar bmw 5 series with dsc and abs continually have abs control module failures. The part is obviously a design flaw and the company should be forced to repair or replace units free of charge. This is obviously a safety issue since the module failure causes the traction control and abs to fail. This is common in model years 98,99,and 2000. *Nm
Abs warning and dsc light is on indicating failure of abs electronic module. Abs and dsc is no longer operable. This is a safety issue since the car will no longer have abs and dynamic stability control system in operable condition. It is unknown if brake could be randomly activated by the failed abs module while driving. Common failure on 1999 or plus 5-series bmw based on user discussion on internet. The failure is temperture related. The higher the temperture, the quicker the warning light will come on. *Nm
Both sun visors cracked along weld seam. Replaced by dealer. Temperature control switche covers broken. Replaced by dealer. Noticed the design of new covers is different and eliminates risk of failure. Parking brake doesn't hold. Dealer admits bad desin and tried different shoes without success in past. Deler couldn't fix, resulting in safety hazard.
While driving at 55 mph engine compartment caught on fire. Insurance investigators claimed fire was due to brake fluid being expelled from abs system and iginiting exhaust manifold. *Ak
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data